Johnson Controls QC008-840 IQ Card PG User Guide
- June 15, 2024
- Johnson Controls
Table of Contents
IQ CARD-PG QUICK GUIDE
QC008-840 IQ Card PG
The IQ Card-PG can be installed in to “Slot 1” of your IQ Panel 4, IQ4 Hub or
IQ4 NS to enable support of PowerG sensors.
Product Name: IQ Card-PG
Part Number: QC008-840
Document last updated on: 8/30/23
BEFORE YOU BEGIN
| Swipe down and touch “Settings” then “Advanced Settings”. Enter your code
and touch “POWER DOWN”.
---|---
| Once the IQ Panel has completely powered down, unplug or disconnect the
power by removing the barrel jack connector inside the panel or by unplugging
the power supply.
NOTE: it is NOT required to disconnect the battery.
INSTALLING THE CARD
| From the bottom of the panel, find the retaining screw, loosen completely.
---|---
| Once the screw has been loosened, pull the backplate away from the panel to
remove.
| Locate “SLOT 1” which is designated as the slot for PowerG daughter cards.
| Make sure the PowerG antenna jumper is connected to the main motherboard.
| Match the pins on the bottom of the IQ Card to the terminal on the IQ Panel.
| Push the IQ Card firmly into place.
Connect the PowerG antenna jumper to the daughter card.
| Install and tighten the provided locking screw to secure the IQ Card into
place.
| Replace the back cover, top tabs first.
Press down on the bottom and tighten the retaining screw.
| Plug the power supply back in and press and hold the power button for 3 sec
to power on.
TESTING THE CARD
| Swipe down and touch “Settings” then “Advanced Settings”. Enter your code
and touch “System Tests”.
---|---
| Touch “Daughter Cards Test”.
| Run the “PowerG” test. Allow up to 2 min for the panel to successfully test
the radio in the new IQ Card. If test fails, reboot the panel and try again.
The IQ Panel will automatically recognize the newly-installed IQ Card-PG and it is now ready to use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>