Shantou LHWJ1601 remote-controlled aircraft Helicopter Instructions

June 5, 2024
SHANTOU

Shantou LHWJ1601 remote-controlled aircraft Helicopter

INCLUDED PARTS NAME

Shantou-LHWJ1601-remote-controlled-aircraft-
Helicopter-fig-1

ASSEMBLY TRANSMITTER

  1.  Install antenna cord: remove antenna into adapter clockwise.
  2.  Install batteries: open the cover of battery case, insert 6 batteries (size 1.5V

properly followed by polar indicator. (Batteries to be purchased).

USING INSTRUCTIONs OF CHARGING POWER BATTERIES

First tum off the power switch of the helicopter, insert the USB plug of the charging cable into the USB socket of the computer, and connect the other end of the plug to the charging socket of the helicopter. When charging, the LED light will light up, when the charging is completed, the LED Ight will go out, and the charging time is about 120-180 minutes.

  • The helicopter is equipped with a Li-Poly battery, please also pay attention to the following cautions for safety use.
  • Do not use or leave the battery near a heat source such as fire or heater. Otherwise, it can cause damage or explode.
  • Do not immerse the battery in water, and keep the battery in a cool dry environment.
  • When recharging, only use the battery charger specifically for that purpose.
  • Do not disassemble the battery.
  • Never leave the battery unattended during charging.

ENVIRONMENT FOR FLIGHT:

  1.  Fly on a sunny day, without wind.
  2. Do not fly in extreme temperature.
  3. Do not fly in temperature above 113 degrees Fahrenheit /45 degrees centigrade, orbelow 50 degrees Fahrenheit /10 degrees cen ti grade. Flying in extreme heat and/of cold will affect performance and may damage the model.
  4.  Do not fly in strong wind. Windy conditions will limit, or disturb the flying control. In very windy conditions, your helicopter may become lost and/or damaged.
  5.  Select a large, wide-open area for flying, and make sure is no obstructions, Animals or people nearby.

READY TO FLY

  1. Lay your helicopter onto the ground, turn on the power switch, and the indicator lights.
  2. Leave the helicopter at least two meters away, while the tail aimed at you.
  3. Check that the helicopter be far away frow the crowd, animal s and other obstructions.
  4. Pull the antenna of the remote controller to the longest and make sure the accelerator is at the minimum position. Turn on the remote controller, turn to full throttle and reset, the indicator light will be always on. This time you can use the remote controller and prepare for taking off.

CONTROL METHOD

SPECIAL PROMPT

If helicopter flies, rotating in the air without pulling the control stick, then you can stop the fly, use screw driver to adjust the potentiometer on chopper circuit board lightly till it is steady. Then adjust the hard adjustment till it stop revolving.(If the helicopter is revolving in the air yet you do not make action tO the rudder, you can use tne ine-turn-out on it to make the helicopter stop revolving and back to the balance. If head of the helicopter rotates clockwise, slowly touch the fine-turn button left of the rudder to keep it balanced, and vice versa. But when this adjust action is useless, make helicopter landing, turn off the power on it. Then you turn on the power of helicopter and launch it, adjust the fine-turn button again .)Shantou-LHWJ1601-remote-controlled-aircraft-Helicopter-
fig-6

FLYING PRACTICE

After enough practice, you can attempt following flying practiceShantou-
LHWJ1601-remote-controlled-aircraft-Helicopter-fig-7

TROUBLESHOOT AND DEAL WITH

Shantou-LHWJ1601-remote-controlled-aircraft-
Helicopter-fig-8

CAUTION

  1.  The control distance will shorter when the quantity of electricity is not full.
  2.  When the quantity of the electricity of the helicopter is not full, the helicopter will difficulty or the height of fly is not enough.
  3.  If the helicopter becomes damaged, or has deformation, please repair in time. If the rotor becomes damaged or broken, do not fly, otherwise, it will lead to injury.
  4.  If you don’t use the transmitter for a long time. Remove all batteries out, in order to avoid the battery leakage to damage this product
  5.  Don’t drop the helicopter from high position or crash it seriously. because that will damage it seriously or shorten the using time.

SAFETY

Shantou-LHWJ1601-remote-controlled-aircraft-Helicopter-
fig-9

  • This product is not a toy. Be sure that you can control and operate it safely and it is not suitable for children under 14.
  • lf you don’t have rich experience of controlling and operating the product, you are suggested to learn it under the guidance of an experienced RC pilot. Manufacturer and dealer will not take any responsibility of the using of the product.
  • Debugging and flight should be carried out strictly in accordance with the Manual and make sure to keep your hands, face and body away form the revolving parts.
  • Be sure to fly the helicopter indoors or in a windless outdoor place. Keep the moving parts away from the other people and objects.
  • While stopping flying, off the switch of the transmitter power.
  • Lithium polymer battery is included with this helicopter. Users are required to obey the operating regulation of the lithium battery otherwise it may cause accidents like burning, exploding and so on.
  • Charge the product by using the charging system included with the controller or the product’s special charge and power adapter.
  • Take out the charge and the power adapter from the power outlet.
  • To avoid accidents happening, never charge the product for a long timee without anybody’s watching.
  • Never place the lithium battery in direct sunlight or near fire. Never throw the battery into fire.
  • Be sure to keep the battery in the dry environment.
  • Never transport the battery and metal objects together.
  • Never disassemble the battery.
  • Never touch the charger or the power adapter with wet hands as to avoid accidents.
  • While flying, do keep it away from the other electrical equipment, magnetic objects or radio devices so as to avoid accidents caused by interference and affection with each other.
  • When battery power indicator light is twinkle. it shows that power of the controller battery is insufficient, please stop filying and replace the controller batter. Guidelines for using lithium battery safely.
  • In the case of not operating, charging the lithium battery may cause fire, personal injury and property loss. Users should be aware of the existence of risk while using such products. it is impossible for the manufacturer, dealers
  • and retailers to take the responsibility for the existence of accidents. Please carefully read the instruction of the guidance, charging and using battery before usage of the product.
  • lf you are not sure how to charge the battery, please consult the local aeromodelling dealers. warning:
  • Keep the batter away from the children and pets. Users under the age of 18 should be used in adult’s guardianship and users under the age of 14 are not suitable to operate the product.

PARTS ARE ALTERNATIVE

Shantou-LHWJ1601-remote-controlled-aircraft-
Helicopter-fig-10

FCC statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SHANTOU User Manuals

Related Manuals