KENUO GenieCAM 360 Degree Object Tracking Holder User Manual

KENUO GenieCAM 360 Degree Object Tracking Holder

Detailed Introduction

Function:
360° Rotation Auto Face Tracking Shooting and Vlog Shooting Smartphone Holder.

Download App

Scan the QR code to download the app then follow the instruction to operate.

Operation

1. Cover the bottom position with the palm of your hand,turn the battery cover counterclockwise according to the arrow mark. Install 3’AA’batteries,then close the battery cover and lock it clockwise.
2.  Hold and press the ON/OFF button for 3 seconds to turn on the product, the red indicator light flashes.
3.  Click the ON/OFF button, the blue indicator light gets work and the red indicator light flashes, the product will automatically rotate and enter the self-check mode;
4.  Turn on the phone s Bluetooth, the red indicator light will light up, the blue indicator light will flash (when the device is tracked, the blue indicator light will keep on), and the device will connect with the phone automatically.
5. Fix the phone on the phone holder and adjust the angle you want.
6. Open the ‘Live360’ app, the page displays the desired live broadcast or camera app to make you select, select ‘More Apps, click ‘Open App Manually’, then click ‘Start live broadcast. The pop-up box shows the live 360 reminders, click ‘Realize’.
7. Keep active in your phone backstage, open any live broadcast software or ‘camera’ app, the device will automatically track and shoot following the movement of the face.
8.  If it is not used for more than 5 minutes, the device will automatically enter sleep mode, just click the ON/OFF button (red indicator light flashes) to restart work.

Warmly Tip:
When the device and mobile phone connect the Bluetooth,there is no need to connect Bluetooth manually.

Specification:

Mechanical Angle

|

30’infinitehorizontal rotatfon 30’upward flfp 30’downwardflip

Support System| 10S 12.4or above,Android 10.0

or above

Support size for

Mobile

|
Battery| 3x ‘AA’ batteries(Nolnduded )
Input voltage| 3-4.SV
Made in China|

FCC RULES

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.  This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>