Skullcandy S6HVW Hesh Evo Wireless Over-Ear Headphones User Guide
- June 5, 2024
- Skullcandy
Table of Contents
Skullcandy S6HVW Hesh Evo Wireless Over-Ear Headphones
Power – On/ Off
- ON – 00:01
- OFF – 00:02
Pairing Mode *On Mode
Pair New Device Pair New Device “Hesh Eva”
Pairing Mode Play/Pause Volume Up Volume Down
Track Forward
TrackBack Answer/ End Phone Calls
**Activate Voice Assistant
Charge**
Rapid Charge: 10 minutes = 3 hours
Tile™ Enabled: Download the App
Pair Tile™
Clear Paired Device Hold Together
Questions Visit: www.skullcandy.com.
Fcc Statement
ISED Statement
This device contains license-exempt transmitter(s) and receiver(s) that
comply with Innovation, Science, and Economic Development Canada’s license-
exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
ISED SAR Statemen
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. End-user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter. The portable device is designed to meet the requirements for
exposure to radio waves established by the lSED. These requirements set a SAR
limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value
reported under this standard during product certification for use when
properly worn on the head.
The FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Skullcandy,.and other marks are registered trademarks of Skullcandy, Inc , All rights reserved.
- Speaker Driver: 40mm,
- Impedance: 32 Ohms, THD <3%@100Hz 10KHz,
- Voltage Regulation: 3.7v, Bluetooth 5.0,
- Frequency Band: 2.402GHz – 2.480GHz,
- Maximum Power: 9.5 dBm,
- Weight: 213g.
Contains a Li-ion battery. The battery must be recycled or disposed of properly.
Americas
Skullcandy, Inc. 6301 N Landmark Dr. Park City, UT 84098 U.S.A.
Skullcandy.com
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Skullcandy Internation GmbH declares that the radio equipment type
[Model: S6HW] is in compliance with Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following internet address:
Skullcandy.eu/product-documents
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>