Tyt TH-UVF9 Two-way radio Remote User Manual
- June 5, 2024
- Tyt
Table of Contents
TH-UVF9 Two-way radio Remote
Safety Training Information
our TYT Electronics Co., Ltd. radio generators RF electromagnetic during
transmit mode. This radio is designed for and classified as”Occupational Use
Only”,meaning it must be used only during the course of employment by
individuals aware of the hazards,and the ways To Minimize Such hazards. This
radio is NOT intended for use by the”General Population” in an uncontrolled
environment. This radio has been tested and complies with the FCC RF exposure
limits for “Occupational Use Only”.Inaddition, our TYT Electronics Co., Ltd
radio complies with the following Standards and Guidelines with regard to RF
energy and electromagnetic energy levels and evaluation of such levels for
exposure to humans:
–IEEE Std. 1528:2013 and KDB447498, Evaluating Compliance with FCC Guidelines
for Human Exposure to Radio Frequency Electromagnetic Fields.
–American National Standards Institute (C95.1-1992), IEEE Standard for Safety
Levels with Respect to Human Exposure to Radio Frequency Electromagnetic
Fields, 3 kHz to 300 GHz.
–American National Standards Institute (C95.3-1992), IEEE Recommended Practice
for the Measurement of Potentially Hazardous Electromagnetic Fields- RF and
Microwave.
The information listed above provides the user with the information needed to
make him or her aware of RF exposure, and what to do to asÿsure that this
radio operates with the FCC RF exposure limits of this radio.
Electromagnetic Interference/Compatibility
During transmissions, TYT Electronics Co., Ltd. radio generates RF energy that
can possibly cause interference with other devices or systems. To avoid such
interference, turn off the radio in areas where signs are posted to do so. DO
NOT operate the transmitter in areas that are sensitive to electromagnetic
radiation such as hospitals, aircraft, and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed as
consequence of their employment provided those persons are fully aware of the
potential for exposure and can exercise control over their exposure.
Attention:
This radio complieswith IEEE and ICNIRP exposure limits for
occupational/controlled RF exposure emvironment at operating duty factors of
up to 50% and is authorized by the FCC for occupational use only. An
appropriate warning lable is affixed to all units. In order to comply with RF
exposure requirements, a minimum distance of 2.5cm must be maintained when
held-to-face, and body-worn operations are restricted to the approved original
acessories (belt clip). Do not use this device when antenna shows obvious
damages
This product is compliance to FCC RF Exposure requirements and refers to FCC
website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for
FCC ID:PODTH-UVF9 to gain further information include SAR Values.
FCC Warning
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device. RF
Exposure complianceStatement and operating instructions The device has been
tested against the SAR limit (8.0W/kg). The highest SAR value reported under
this standard during product certification for use at the Face up is 2.415W/kg
and when properly worn on the body is 3.068W/kg. This device was tested for
typical operations. The device only supports simplex-mode and transmitting is
no more than the rated duty cycle factor of 50% of the time. For hand-held
operation, the radio should be held at least 25mm from the user’s face. The
use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not
satisfy these requirements may not comply with RF exposure requirements, and
should be avoided. Use only the supplied or an approved antenna.