ACROX RX0T 2.4GHz Wireless Silent Optical Mouse with Nano Receiver User Guide

June 5, 2024
ACROX

2.4GHz Wireless
Silent Optical Mouse/Nano Receiver
USER’S GUIDE
Ver.:1.00

CAUTION: To use this product properly, please read the user’s guide before installing.

Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure Statement:
The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

Functional Introduction

Installing the batteries

Step 1: Take the battery cover off.
Step 2: Insert the battery as shown inside the battery compartment.
Step 3: Replace the cover.Mouse with Nano Receiver -Installing
Batteries Warning:
Please insert the battery in the correct position according to the instruction label on the mouse.

Step 5: If you need to travel with your wireless mouse, made sure you turn off the POWER SWITCH.
Setup the Connection between the Receiver and the Mouse

1. Insert the battery into the mouse, then follow the step below.
2. In the meantime, to open the battery cover, take the Nano receiver out.
3. Plug the Nano receiver into the USB port on your computer.Setup the
Connection between the Receiver and the Mouse

4. When low battery, the battery indicator on the mouse will start to blink.LED Indicator

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals