Linklike LNHS1 Noise Cancelling Headphones User Guide
- June 2, 2024
- Linklike
Table of Contents
QUICK GUIDE
Connection Tutorial
- Open the settings in your sevices.
- Open the bluetooth.
- Click the “LINKLIKE HS1” to connect.
- Enable the call and media permissions.
Check the Battery Level
- According to the system, you can check the battery level on the phone’s negative one screen or the top bar.
Two Device Connection Explanation
- Turn on the headphones – Turn on the Bluetooth function on device A and device B – Connect them in the device interface.
- Turn on the headphones – Turn on the Bluetooth function on device A – Connect them in the device interface – turn off the device A’s Bluetooth – Turn on the Bluetooth on device B -Connect them in the device interface – Then turn on both devices’s Bluetooth again.
Note: Different devices may have different Bluetooth settings. If they cannot reconnect immediately, you can manually click on the connection in the device’s Bluetooth interface or turn the Bluetooth on and off again.
Volume Synchronization (Important)
According to different systems, the sync function locations is different. You can find the sync function through the following steps:
- iOS system: Automatic sync, no need to set up.
- Android New system: Settings – Bluetooth – Headphone settings – Turn on volume sync function.
- Android Old system: Settings – About phone – Tap on the version number repeatedly (at least 8 times) to enter developer mode -Go back to the settings interface, system and updates – Developer options – Turn on Bluetooth absolute volume – Done (you can exit developer mode in the status bar).
Tip: To better control the volume and enjoy music, it is better to turn on the sync function as soon as you get the phone.
Multifunction Button
Multifunction Touch Button
FCC Warning
15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
- This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 5mm between the radiaand your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>