Gude GFS 401 S Submersible Pump Instruction Manual

: June 5, 2024
: Gude

Gude GFS 401 S Submersible Pump

Gude-GFS-401-S-Submersible-Pump-
product

STARTING-UP THE MACHINE

Gude-GFS-401-S-Submersible-Pump-
fig-2

SERVICE CONNECTION

Gude-GFS-401-S-Submersible-Pump-
fig-3

SENSOR SWITCH

Gude-GFS-401-S-Submersible-Pump-
fig-4

Operation

Gude-GFS-401-S-Submersible-Pump-fig-5 Gude-
GFS-401-S-Submersible-Pump-fig-6

Transport / storage

Gude-GFS-401-S-Submersible-Pump-
fig-9

Technical Data

Read and understand the operating instructions before using the appliance. Abide by all the safety measures stated in the service manual. Act responsibly toward third parties. In case of any doubts about connection and operation refer please to our customer center

Specified Conditions Of Use

The pump is solely used for drainage and for pumping into and out of containers in the house, garden, farm and agriculture and only for water. Not observing general regulations in force and instructions from this manual does not make the manufacturer liable for damages.
Caution!
During flat sucking in the automatic mode, the pump can switch on and off every moment in case of small areas due to water flowing back from the pump body.
To drain flooded spaces and provide flat suction, the pump should therefore essentially work in the continuous mode and should not be left unattended.

WARNING

The pump is not suited for long-run operation (e.g. as a circulation pump in ponds or streams). When used in this manner, its service life is curtailed correspondingly. In these cases, then, use a time switch to secure sufficient idle periods between cycles of operation.
Do not leave the pump unattended while in operation in order to prevent subsequent damages caused by eventual malfunctions. Make sure to disconnect the device from the grid if you do not plan on using it.
Do not use the pump for drinking water!
The pump must not be connected to the existing water-supply network as a pressure-boosting device.

Power tool description

Gude-GFS-401-S-Submersible-Pump-
fig-1

Sensor switch
Suction foot
Pump connection
Pump connection angle
Connecting branch for the hose fitted with check valve
Handle
Power supply cable

Requirements for operating staff

The operating staff must carefully read the Operating Instructions before using the appliance.

Qualification:
Apart from the detailed instructions by a professional, no special qualification is necessary for appliance using.

Minimum age:
Persons over 16 years of age can only work on the appliance. An exception includes youngsters trained in order to reach knowledge under supervision of the trainer during occupational education.

Training:
Using the appliance only requires corresponding training by a professional or the Operating Instructions. No special training is necessary.

The operator is responsible for accidents or risks to third parties. Observe to keep out of dangerous zone

Emergency procedure

Conduct a first-aid procedure adequate to the injury and summon qualified medical attendance as quickly as possible. Protect the injured person from further harm and calm them down. For the sake of eventual accident, in accordance with DIN 13164, a workplace has to be fitted with a first-aid kit. It is essential to replace any used material in the first-aid kit immediately after it has been used. If you seek help, state the following pieces of information:

Accident site
Accident type
Number of injured persons
Injury type(s)

Safety Instructions

This device is not intended for use by persons (including children) with limited physical, sensory or mental capabilities or without the necessary lack experience or knowledge unless they are supervised by a person who is responsible for their safety or was instructed by that person in how to use the device.
Children should be supervised to ensure that they do not play with the device. Always keep children and unauthorized persons out of reach of the appliance.
Operation is only allowed with a safety switch against stray current (RCD max. stray current of 30mA). Please ask your electrician.
Before putting into operation, a qualified electrician must check whether electric safety measures required are in place. Any national regulations in this regard must be complied with.
Electric connection to a socket.
It is necessary to make sure the connecting socket was not near water and humidity and the plug was protected against humidity.
Check the voltage. Technical data given on the type label must correspond with electric network voltage.
Only use splash-proof extension cables approved for outdoor purposes.
Do not grab the feeder cable, plunge the pump, lift or carry it while it is connected to the grid!
Check the cable and/or socket for damages before the appliance putting into operation.
To avoid danger, a damaged mains supply pipe must be replaced by the manufacturer. Do not execute any repair yourself under any circumstances.
Protect the feeder cable from excessive temperatures, oil and sharp edges.
Unplug the device prior to submersion, upon termination of operation, in the course of defect removal and prior to performing maintenance procedures.
If the pump is in operation, neither people nor animals can be present or plunged in the pumped liquid (e.g. pools, cellars, etc.).
The pump must not in any case run without fillings.
Do not leave the pump unattended while in operation in order to prevent subsequent damages caused by eventual malfunctions. Make sure to disconnect the device from the grid if you do not plan on using it.
The temperature of the drained liquid must not exceed +35 °C.
If the lubricant escapes the fluid could become contaminated.
If the pump is used in ponds, wells, etc. and appropriate pumping stations, standards valid for pumps in the given country must unconditionally be observed.
The user is responsible to third parties if pump (dum-ping stations, etc.) is used.

operation

Automatic switch-off mechanism
Adjust the automatic pump switch-off mechanism with a flat suction box with a time delay of app. 3 minutes The automatic switch-off mechanism will prevent the pump from being switched off immediately after the water level has dropped under the contact surface of the electronic switch sensor; this also applies if the switch with the sensor is not in the continu. The pump must not in any case run dry until the automatic switch-off mechanism stops.

Guarantee

Warranty period of 12 months applies to commercial use and 24 months applies to private use and commences on the day of purchase of the device. The guarantee solely covers inadequacies caused by material defects or manufacturing defects. Original payment voucher with the sales date needs to be submitted for any claim in the guarantee period. The guarantee does not cover any unauthorized use such as appliance overloading, use of violence, damage as a result of any unauthorized interference or caused by foreign items. Failing to follow the operating and assembly instructions and common wear are also not included in the guarantee. GÜDE cannot be held responsible for damages incurred in consequence of unqualified installation or unskilled handling of the pump. The device has to be checked on a regular basis to ensure perfect functioning. Let us refer to the fact we do not assume any responsibility – according to standards in force – for damage eventually caused by our appliances in the below-mentioned cases:

Unprofessional repairs executed by unauthorized service centers;
Use in conflict with the designed purpose, or failure to observe the use as designed;
Pump overload with a continuous run;
Damage as a result of icing or any other fault caused by climatic influences;
Identical regulations apply for accessory parts.

To prevent damage (such as flooded rooms, etc.) as a result of faulty pump operation (failure or fault) the owner (user) is obliged to take reasonable safety measures (alarm assembly, spare pump, etc.).

Service

Do you have any technical questions? Any claim? Do you need any spare parts or operating instructions? We will quickly help you and without needles bureaucracy at our web pages at www.guede.com in the Servicing part. Please help us be able to help you. In order to identify your device in case of claim, we need the serial No., product No. and year of production. All this data can be found on the type label. Please enter it here for future reference.

Maintenance

Prior to every use, visually check the machine to rule out any defects, in particular on the power cable and the plug. The machine must not be used under any circumstances if the machine or the safety devices are damaged. In case of a failure of the pump, a repair can only be executed by the GÜDE service center. Original spare parts to be used only. To ensure long service life of the pump seal we recommend rinsing the pump with clean water in regular intervals. At winter storing, it is necessary to make sure there is no water in the appliance as the frost could damage the appliance. Prior to transportation, it is necessary to unplug the pump from the grid! The device has to be completely emptied and stored with frost-proof protection. Adhesion of mechanical seals can be prevented if you rinse the pump with appropriate oil (for example, with vegetable oil). Only a regularly maintained and treated appliance can serve as a satisfactory aid. Insufficient maintenance and care can lead to unforeseen accidents and injuries.

Disposal

Do not dispose electric appliances as household refuse. According to the European Directive No. 2002/96/EG on waste electrical and electronic equipment and based on including this Directive in the national law, separate collection of worn electrical equipment must be provided and such equipment must be recycled in an environment-friendly manner. Recycling alternative of recovery Alternatively to send-ing equipment back, the electrical equipment owner is obliged to cooperate in the professional evaluation. An old appliance may also be left to a collection center that will provide disposal in accordance with the national law regarding circulation management and waste. This does not apply to parts of accessories and aids connected to old appliances and not containing electrical components.