BT Video Baby Monitor 6000 User Guide
- June 7, 2024
- BT
Table of Contents
BT Video Baby Monitor 6000 User Guide
Welcome
Thanks for buying a BT Baby Monitor. You’ll soon be able to relax knowing you can watch and listen for your baby’s every breath, gurgle and wriggle. But first things first. To get set up, just follow the steps opposite. If you need any help, go to bt.com/producthelp or give us a call on 0808 100 6554*
Important safety notices
-
Your baby monitor is designed as just an aid.
It isn’t a substitute for responsible and proper adult supervision. -
Make sure all cables and units are out of your baby’s reach – at least one metre away.
-
Never cover either unit, put them in moist places or inside the cot, bed or playpen.
-
If you travel abroad, check the voltage on your unit’s plugs match the local power output.
-
Do not take the product apart. You can’t change the battery installed in the Parent unit. If you need repairs, get in touch with our help desk
Getting set up
- Plug the cable into the Parent unit, then plug it into the mains power socket and switch the socket on.
- Leave to charge for 12 hours.
Tip
- The first time you use the Parent unit, or if you haven’t used it for a long time, it’ll take 12 hours to fully charge.
- The battery life on a single charge lasts for 4 hours. We recommend you keep the cable plugged into the mains power socket if you’re going to use for longer than this or throughout the night.
- When the battery gets very low, it’ll take about 30 minutes to charge enough for you to use it for a short time. To charge the Parent unit in the shortest amount of time, turn it off while it’s charging.
3. Place the Baby unit near a power socket in the room where you’re going to
be monitoring your baby most of the time. It should also be at least one metre
away from your baby.
4. Plug the cable into the Baby unit, then plug it into the mains power
socket and switch the socket on.
5. Slide the Off On button on the side of the Baby unit up to turn it on.
Tip
Keep the power cord out of baby’s reach by looping any extra length and
securing it.
6. After the Parent unit has charged for 12 hours you can switch it on.
Before you do, move the Parent unit at least one metre from the Baby unit. Any
closer and you might get audio feedback sounds.
Press the button and hold for 2 seconds to turn the Parent unit on.
The Parent and Baby unit are automatically linked so they are now ready to use.
What’s the range?
The maximum range between your Parent and Baby units is about 250 metres
outdoors and about 50 metres indoors. Thick walls and doors reduce the units’
range and affect how they link to each other.
Troubleshooting
My Parent/Baby unit isn’t working. What should I do?
Check that:
- power cables are plugged in and switched on at the wall socket
- the Baby unit is plugged in and the Parent unit battery is fully charged (for 12 hours)
- both units are turned on
- the Parent unit isn’t too far from the Baby unit (large obstructions or other electrical devices might affect the signal between the Parent and Baby unit).
- unplugging the power cables, waiting about 15 seconds, and then plugging them back in can help.
My Parent/Baby unit is making a high-pitched noise.
What should I do?
The units might be too close together. Make sure they’re at least one metre
apart, even when you’re using the button.
Why is my Parent unit beeping?
The Parent unit beeps when:
- the Baby unit is turned off
- the units are too far apart – try moving them closer together (but not closer than one metre)
- the battery in the Parent unit isn’t charged – try charging it for 12 hours
- Other electronic items, like TVs and mobile phones, are causing interference – try moving the Baby unit away from things like that.
Why is the Parent unit not making any sounds even though there’s noise coming from my baby’s room?
- the Parent unit might not be fully charged – make sure it’s charged (for 12 hours).
- the speaker volume might be switched off.
- the Parent unit might be out of range of the Baby unit – try moving it closer (but not closer than one metre).
- large obstructions or other electrical devices might be affecting the signal between the Parent and Baby units). Try moving the Baby unit away from obstructions, including electrical appliances like TVs or mobile phones.
Need some help?
Frequently asked questions are available online.
bt.com/producthelp
If you cannot find the answer to your question online, call our free Helpline.
Our dedicated advisors are more likely to be able to help you than the
retailer where you bought your baby monitor.
**0808 100 6554***
This user guide is also available in other formats: large print, Braille and
audio CD. Call the helpline for a copy.
- Calls made from within the UK mainland network are free.
Mobile and international call costs may vary.
General information
Guarantee
Your Video Baby Monitor 6000 is guaranteed for a period of 24 months from the
date of purchase.
Subject to the terms listed below, the guarantee will provide for the repair of, or at BT’s or its agent’s discretion the option to replace the Video Baby Monitor 6000, or any component thereof, which is identified as faulty or below standard, or as a result of inferior workmanship or materials. Products over 28 days old from the date of purchase may be replaced with a refurbished or repaired product.
The conditions of this guarantee are:
- The guarantee shall only apply to defects that occur within the 24 month guarantee period.
- Proof of purchase is required.
- The equipment is returned to BT or its agent as instructed.
This guarantee does not cover any faults or defects caused by accidents, misuse, fair wear and tear, neglect, tampering with the equipment, or any attempt at adjustment or repair other than through approved agents.
This guarantee does not affect your statutory rights.
To find out what to do, if your monitor is in or outside of the 24 month guarantee, go to bt.com/producthelp
How to recycle your equipment
The symbol shown here and on the product means that the product is classed as
electrical or electronic equipment, so DO NOT put it in your normal rubbish
bin.
It’s all part of the Waste Electrical and Electronic Equipment (WEEE) Directive to recycle products in the best way – to be kinder to the planet, get rid of dangerous things more safely and bury less rubbish in the ground.
You should contact your retailer or supplier for advice on how to dispose of this product in an environmentally friendly way.
Radio Equipment Directive Declaration of Conformity
Hereby, British Telecommunications plc declares that the radio equipment type
BT Video Baby Monitor 6000 (088306) is in compliance with Directive
2014/53/EU.
This device has been evaluated for and shown compliant with European Guidelines when installed and operated with a minimum distance of 16mm between the unit and your body.
The item code for both power supply units is 089010 (BLJ06W050100P1-B). The full text of the EU declaration of conformity is available at the following internet address: bt.com/producthelp
Radio transmission information
© British Telecommunications plc 2017.
Registered Office: 81 Newgate Street, London EC1A 7AJ. Registered in England
No. 1800000
Designed and produced by The Art & Design Partnership (ADP). Printed in China
/ Issue 4 / ADP12-17.
Using the Parent unit
Get to know your Baby unit
Get to know your Parent unit
Using the Baby unit
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>