CALIBER RMD 034DAB-BT Car Radio with DAB + and Bluetooth User Guide

CALIBER RMD 034DAB-BT Car Radio with DAB + and Bluetooth User Guide

Product Overview

1. Power/Mute/Pause
2. Volume control (rotate)
3. Function selection (press)
4. Mode switching/clock button
5. Band switching/automatic memory storage
6. Next track / next station / search FM station forwards / answer button
7. Previous track / previous station / search FM station backwards / hang-up button
8. Display
9. MicroSD card slot
10. USB interface (No charge function)
11. AUX-IN jack
12. Built-in microphone
13. Reset button

Remote Overview

1. Power ON/OFF
2. End/ignore call
3. Mode switch (Tuner/AUX/Bluetooth)
4. Intro play / Preset 2 / No. 2
5. Play/Pause playback / Preset 1 / No. 1
6. Shuffl e playback / Preset 4 / No. 4
7. Preset 5 / No. 5 / -10 tracks
8. RDS AF mode / Preset 8 / No. 8
9. RDS TA mode / Preset 9 / No. 9
10. Audio (settings) menu / Numeric #
11. Call pickup
12. Increase volume / + in menu
13. Next track / tune seek
14. Decrease volume / – in menu
15. Repeat mode / Preset 3 / No. 3
16. PTY / Preset 7 / No. 7
17. Preset 6 / No. 6 / +10 tracks
18. Display / Numeric *
19. Band / Numeric 0

CONNECTOR

• B1. Rear right speaker(+) / Purple
• B2. Rear right speaker(-) / Purple-Black
• B3. Front right speaker(+) / Grey
• B4. Front right speaker(-) / Grey-Black
• B5. Front left speaker(+) / White
• B6. Front left speaker(-) / White-Black
• B7. Rear left speaker(+) / Green
• B8. Rear left speaker(-) / Green-Black

1. Al. Not connected
2. A2. Not connected
3. A3. Not connected
4. A4. Battery 12V (+) / Yellow
5. A5. Antenna power / Blue-Whit
6. A6. Not connected
7. A7. ACC+ / Red
8. A8. Ground / Black

Product Dimension

Warning: The negative speaker lead should NOT be grounded, otherwise it will damage the radio!

WARNING!

• To connect the unit, use ISO connectors only.
• If your vehicle isn’t equiped with an ISO connector, please use the provided ISO loom cable.This prevents an incorrect wired connection.

Damage caused by faulty wiring: warranty will be void.

ANTENNA INSTALLATION

• Place the antenna on the windshield near the ‘A post’ 12V remote
  

• Remove the cover of the A-post

• Stick the transparant part of the antenna on the windshield and put the black part (magnetic) on the metal frame.

• Power the DAB Antenna with the blue/white cable (12V Remote) Make sure to strip the wires before connecting them.
  

SETTINGS

1. Antenna connection
   Connect the DAB antenna correctly according to the wiring diagram as described on the page to the left.

2. Station search and automatic storage
   Press the [MOD] button (4) to switch to DAB mode. After the switch to DAB mode upon first energizing, the system will automatically search and store. If not or if you want to re-scan, long press the [BND/AMS] button (5) to start the search. When the search is completed, it will start playing the first active station.

3. Playback DAB+ stations
   After a full search the 18 strongest stations automatically will be stored in the three DAB bands. Six presets on each band. To recall the stations, switch between DAB1, DAB2, DAB3 using the [BND/AMS] button (5) and use buttons (6/7) to switch between 1~6.

SPECIFICATIONS

FM TUNER

• Frequency Range:   87.5 ~ 108MHZ
• Usable Sensitivity: 12 dBuV
• Stereo Separation:   >40 dB

DAB+ TUNER

• Frequency Range:   174 ~ 240MHz
• Antenna type: Screen mount / male SMA connector / active (with separate 12V power supply wire)

Note: connect the antenna power supply wire to the remote/antenna wire (blue/white) of the head unit

ELECTRIC

• Power Supply : DC 11 ~ 15 Volt
• Current Consumption: < 10 Ampere
• Load Impedance:   4 to 8 Ohm
• Dimensions:   187mm (W) x 38mm (D) x  58mm (H)
• Power   Output: 4x 55W (Max)
• Line Output:   1V

Transmission

• Bluetooth Freq range: 2402-2480 Mhz
• Max e.r.p: <100mW/20dBm

PLAYBACK

• MP3

Old appliances and/or batteries must not be disposed with garbage! If the device/battery can not be used anymore, every user is legally obliged to dispose of old appliances and/or batteries separated from the garbage, e.g. at a collection point of his municipality/district.

Caliber hereby declares that the item RMD034DAB-BT is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU (RED) and 2011/65/EU (RoHS).

Latest declaration form can be found at:
www.caliber.nl/media/forms/DeclarationRMD034DAB- BT.pdf

WWW.CALIBEREUROPE.COM
CALIBER EUROPE BV • Kortakker 10 • 4264 AE Veen • The Netherlands

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>