POWERSTICK COM PIN24555 PowerPad Wireless Charger User Guide
- June 5, 2024
- POWERSTICK COM
Table of Contents
PowerPad Wireless Charger
User Guide
How to Wirelessly Charge your smartphone
POWERPAD
PowerPod is a desktop wireless charger with the option of docking your Apple
Watch magnetic charger. Simultaneously charge your phone and watch without any
dangling cables.
Step 1: Plug the included micro-USB into PowerPad and a USB power source.
Step 2: Place your phone on the grey silicone pad to begin charging. The LED
will flash green when it is charging.
How to Install the Watch Dock
Step 1: Use the flap on the back to slide off the slot cover completely
Step 2: Slide on the – Watch dock from the back of PowerPad
Step 3: The Watch dock is installed when the squished part returns to its
initial shape around the corner.
How to Install your Apple Watch® Magnetic Charger
Step 1: Start by sticking the USB end through the Watch dock
Step 2: Push the Apple Watch® magnetic charger into place in the front
Step 3: Snap the cable into the silicone at the back until it is secure
Step 4: Plug the Apple Watch® magnetic charger into PowerPad or another USB
power source
? QUESTIONS
Email us at
support@powerstick.com
The device has been evaluated to meet general RF exposure requirements, The
device can be used in portable exposure conditions without restriction.
Federal Communication ommission (FCC) Radiation Exposure Statement Power is so
low that no RF exposure calculation is needed. This device complies with part
15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications or changes to this
equipment. Such modifications or changes could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates ses and can radiate radio
frequency energy and, if not installed nd used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
‐ Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AITNPOWERPAD