Silver Cross 31462418 Smart Stroll Air Quality Monitor and Route Tracker User Guide
- June 5, 2024
- Silver Cross
Table of Contents
Silver Cross 31462418 Smart Stroll Air Quality Monitor and Route Tracker
INSTRUCTION
Step 1 Plug in
Charge for a minimum of 20 minutes and 75 minutes to full charge.
Step 2 Turn on
Turn on by sliding the switch on the top.
Step 3 Download
Scan the cover QR code with your smartphone to link to the Silver Cross App,
then log in or register.
Step 4 Connect
Ensure your smartphone’s Bluetooth is turned on. Open the Smart StrollTM
dashboard within the App and follow the on-screen instructions.
Step 5 Off you go
Attach your Smart StrollTM to the inside of your pushchair hood using the
magnet, and start Smart Strolling.
Smart Stroll
Charging Indicator
- White: On
- Green flashing: Charging
- Green solid: Fully charged
- Red flashing: Low power
Disclaimer
Silver Cross Smart StrollTM is not a medical device. It is not a professional air quality monitoring device; it provides estimates intended for personal use and informational purposes only. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Chill Baby Technologies LLC is under license. Other trademarks and trade names are those of their respective owners.
Fitness, Wellness, Happiness
FOR OPTIMUM RESULTS, FOLLOW THE INSTRUCTIONS
Position Smart Stroll M inside the hood. Ensure the air inlet and outlets are
not blocked and air flow in and around the device is not restricted. Smart
StrollTM is splash proof only and not water-resistant. Dry immediately if it
comes into contact with water.
Storage:
Store in temperatures not exceeding 65°C and no lower than -20°. Store in a
dry place out of direct sunlight.
Usage:
Ensure Smart Stroll M is placed on the inside of the stroller hood when in
use. Avoid any contact with water. If Smart Stroll TM is in contact with water
dry off immediately. Smart Stroll TM is not waterproof. Smart StrolM can be
used at temperatures between -10°C and 45°C. Do not use in temperatures
exceeding 45°C Avoid any prolonged exposure to chemical products and dust.
Avoid exposure to:
- Silicone vapours from sources such as silicone adhesives, silica gel, silicone rubber, silicone sealant, silicone gel, HMDS, and oils including hair gels and oils.
- Corrosive gases and vapours such as chlorine, hydrochloric acid, sulphur oxides for example some flux vapours
- Acids, solvents and other liquids, including wat contain ionic contamination such as salts, especially where the water
- Avoid any kind of shocks, be they physical, thermal or otherwise. They may damage internal and external components.
Warranty
Smart Strol| TM Limited Warranty extends only to the first consumer purchase of the product and is not transferable.
The warranty covers:
Subject to the exclusions contained below, Silver Cross warrants the Smart
StrollT and in-box accessories, accompanying the Product against defects in
workmanship and material, under normal consumer use. The warranty does not
extend to:
- Natural wear/tear (scratches, alteration of the colour and/or the materials of the Smart StrollTM).
- Any damage to the Device/its parts resulting from accident, misuse, liquid contact, fire, earthquake or any other external causes, abnormal or abusive use, negligence or lack of care, or accidental damage (such as dents).
- Indirect damages of any kind.
Magnet Disclaimer:
Magnets are used within the design of this product. If in doubt, always seek
professional advice when using products containing magnets.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. silvercrossbaby.com.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>