SKROSS 1302471 Pro Light USB Travel Adapter Instruction Manual
- June 5, 2024
- SKROSS
Table of Contents
SKROSS 1302471 Pro Light USB Travel Adapter
World adapter PRO Light USB, 3-pole
PRO Light USB (2xA):
- max. 7 A, 110V/770W-24a0V/1680W
- 2x USB-A port: SV/max. 2.4 A (shared), (max. 12W) 1.2
PRO Light USB (4xA):
- max. 7 A, 100V/700W-250V/1750W
- 4 x USB-A port: 5V/max. 4.8 A (shared), (max. 24W)
PRO Light USB (AO:
- max. 7 A, 100V/700W-250V/1750W
- 1 x USB-C port: 5 V/max. 3 A, (max. 15W)
- 1 x USB-A port: SV/max. 2.4 A, (max. 12W)
Country adapter World to Europe, 3 pole
- max. 16 A/100V-250V
only included with PRO Light USB -World v”ons:
- PRO Light USB (2xA) -World
- PRO Light USB (4xA) -World
- PRO Light USB (AC) -World
Fuse replacement
Slow blow microfuse (glass or ceramic): T 7 A, 250V AC, 6.3 x 25.4 mm;
replacement only possible with following world adapters:
- 1.1 PRO Light USB (2xA)
- 1.2 PRO Light USB (4xA)
- 1.3 PRO Light USB (AC)
Plug types:
A USA/Japan, B USA, C Euro, E French Schuko, F Schuko, G UK, I
Australia/China, J Switzerland, L lta, N Brazil
Safety instructions
- Keep the adapter oot of the reach of children.
- The adapter is only intended for short-term use. Disconnect from the mains/device after use.
- Never use the adapter if the casing is d.imaged.
- Never expose the adapter to liquids or moisture.
- The adapter is not suitable for use in enclosed spms (IP20).
- The adapter is not a voltage converter. The input voltage for the device to be connected must match the voltage of the local mains power .
- The fuse will blow if the adapter is used with higher-powered devices than specified
- When replacing the fuse always use an appropriate fuse.
- The adapter cannot be used to charge electric vehicles.
- The adapter must only be used to connect a single device (not including USB connections).
- The adapter must not be used with multlplug sockets or other adapter plugs.
- Improper use of the adapter will invalidate the manufacturer’s warranty.
- Retain a copy of thisdocument and the manual.
Wananty & limitation of liability
This product has been developed in line with international safety standards. The user must exercise due care and attention when using the product. The warranty expires 24 months after the date of purchase and is limited exdusively to the replacement of a defective product. Aside from its commitmfflt to replace a defective product within the warranty period, WorldConnectAG accepts no liability, under any circumstances, for direct, indirect or consequential damages resultirrg from (i) a defective product; (ii) force majeure events; (iii) any improper use of the product that deviates from its intended use (iv) any use of the product that contravenes the instructions contained in the manual. Liability is also excluded for aany lost profits, operational downtimes, data loss or any other losses and/or damages incurred during the proper or improper use olthe product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>