SKROSS 231219 Power Stand Instruction Manual
- June 1, 2024
- SKROSS
Table of Contents
SKROSS 231219 Power Stand
Product Overview & Functions
Power Stand
5 000 mAh battery with built-in viewing stand and USB-C connector for
charging USB devices.
- A Power Button
- B LED Indicator
- C USB C Input/Output (PD/QC 3.0)
- D USB C Port Input (QC 3.0)
- E Stand
- F USB-A to USB-C Charging Cable
Specifications
- Battery Capacity: 5000mAh/18.5Wh
- Battery Type: High-Density Lithium Polymer
Input
- USB-C: 5.0 V – 2.0 A, 9.0 V – 2.0 A
- USB-C Connector: 5.0 V – 3.0 A, 9.0 V – 2.0 A
Output
- USB-C Connector: 5.0 V – 3.0 A, 9.0 V – 2.22 A, 12.0 V – 1.5 A
Instructions
How to Charge Smartphone & Other Devices
When the USB-C plug (C) is connected to a device that supports 5 V charging,
the Power Stand will enter the ordinary 5 V charging mode and the LED
indicator light (B) will turn white. When using the USB-C plug for charging,
the first LED indicator light (B) will turn blue to represent the fast
charging mode. During this time, the output voltage will reach between 5.6 V
−and 12V to charge your device. When you unplug the device or interrupt the
charging, the LED indicator light (B) will remain on for 35 seconds, then it
will turn off the Power Stand output to enter the standby mode.
When the load current is less than 60mA, the Power Stand output will turn off and enter standby mode. Long press the power button (A) for 2 seconds to enter the small current mode, in which 4 LED indicator lights (B) will flash every 5 seconds. Double-click the power button (A) or long-press the power button (A) for 2 seconds to exit the small current mode.
Power Stand
AIRLINE EDITION: Pre-charged up to 30% – ready to fly
LED INDICATOR
The USB-C plug (C) output also supports the PD2.0/3.0 protocol, QC2.0/3.0, Huawei’s FCP, MTC’s PE1.1/2.0, and Samsung’s AFC cell phone fast charging protocol.
How to Recharge
Recharge by connecting a USB-C charging cable (F) to the USB-C input port (D)
on the side of the Power Stand and connect the other end of the cable to a
wall charger. You may also recharge the Power Stand by directly plugging the
built-in USB-C plug (C) into a wall charger.
Safety Precautions
- Keep the device out of the reach of children.
- The device is only intended for short-term use and should be disconnected from the mains after use.
- Never use the device if the casing is damaged.
- Never expose the device to liquids or moisture.
- Improper use of the device will invalidate the manufacturer’s warranty.
- No liability is accepted for damages.
- Keep these instructions.
Warranty & limitation of liability
This product has been developed in line with international safety standards.
The user must exercise due care and attention when using the product. The
warranty expires 24 months after the date of purchase and is limited
exclusively to the replacement of a defective product. Aside from its
commitment to replace a defective product within the warranty period,
WorldConnect AG accepts no liability, under any circumstances, for direct,
indirect, or consequential damages resulting from (i) a defective product;
(ii) force majeure events; (iii) any improper use of the product that deviates
from its intended use (iv) any use of the product that contravenes the
instructions contained in the manual. Liability is also excluded for any lost
profits, operational downtimes, data loss, or any other losses and/or damages
incurred during the proper or improper use of the product.
Subject to change.
©2023 WorldConnect AG. All rights reserved.
WorldConnect AG, Viscosestrasse 46,
9443 Widnau, Switzerland
WorldConnect AG c/o DACHSER SE,
Pinkertweg 40, 22113 Hamburg, Germany
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>