BaByliss MEN T810E Men Beard Trimmer User Manual
- June 5, 2024
- BaByliss MEN
Table of Contents
BaByliss MEN T810E Men Beard Trimmer
T810E
Please carefully read the safety instructions before using the appliance.
TRIMMER FEATURES
-
35mm blades:
Moveable blade: CMS (Chrome-Molybdenum-Stainless Steel): Fixed Blade: stainless steel -
Hair collector
-
1 cutting guide for 39 lengths (from 1 mm to 20 mm, in 0.5 mm increments)
-
ON/OFF switch
-
Wheel to adjust the cutting length
-
Power indicator light
-
Trimmer charging plug
-
Cleaning brush
CHARGING THE TRIMMER
- Insert plug into the appliance and connect the adapter. Before using the trimmer for the first time, allow it to charge for 16 hours. Make sure the trimmer’s switch is in the OFF position.
- Check that the charging indicator light is on.
- A full charge provides a minimum of 60 minutes’ use of the trimmer.
- subsequent charges should be 8 hours.
IMPORTANT INFORMATION REGARDING THE NI-MH BATTERIES OF THIS UNIT
To obtain and maintain the longest battery life possible, allow it to charge
for 16 hours approximately every three months. Moreover, full battery life of
the unit will only be obtained after three complete recharge cycles (one cycle
of 16 hours followed by two cycles of 8 hours).
HANDLING THE COMB GUIDE
IMPORTANT: Always position the cutting guide BEFORE switching the
appliance on; always switch the appliance off before positioning the cutting
guide.
To remove or replace the cutting guide, first adjust the cutting length to a
minimum and then, with the motor off, pull the guide upwards to remove it
(Fig. 1), or press until it clicks into place (Fig. 2) to the position.
Use the adjustment wheel to select the desired cutting length.
TURNING IT ON AND USING IT
Turn the adjustment wheel to select a cutting length. Operate the ON/OFF
button.
You can change the cutting length at any time.
IMPORTANT! Make sure you keep the cutting guide flat against the skin. That is, the tips of the teeth and the little corners protruding from the comb should always be in contact with the skin. If not, the precision of the cut may change (Fig. 3-4).
MAINTENANCE
Regular maintenance of the blades and hair collector will keep the trimmer in optimal working condition.
Removable blades
To make cleaning easier, the BaByliss trimmer blades can be removed. Make sure
that the trimmer is off and remove the cutting guide. Hold the trimmer with
the blades pointing up and remove them by pressing their points.(Fig.5).
Carefully brush the blades using the cleaning brush to remove hair.
Rinse blades under water without immersing the appliance.
Self-lubricating blades
The blades of your trimmer have a reservoir pad for releasing the necessary
amount of oil for proper operation of your trimmer, time after time.
Nevertheless, it is recommended that it be refilled occasionally when you
notice performance is not as high.
Remove the blades as described above.
Squeeze a few drops of BaByliss oil onto the pad (Fig.6). Then replace the
blades on the trimmer.
The BaByliss oil is specially formulated for the trimmer, it does not
evaporate nor does it slow the blades.
It is possible to obtain replacement blades when they are worn out or damaged.
Hair collector
For best hygiene, we recommend regularly removing the hair collector for
cleaning:
Remove the collector by pulling the upper part (Fig. 7)
Empty the collector.
To replace the collector, place the lower part of the collector in the
appropriate slot and finalize by clipping the upper part into place (Fig. 8).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>