iHome B16 Series True Wireless Earbuds User Manual
- June 5, 2024
- iHome
Table of Contents
iHome B16 Series True Wireless Earbuds
CHARGING THE EARBUDS
USB
POWER ON/OFF
- Press and hold either Multi-Function Button (MFB) for 3 seconds to turn the earbuds ON.
- Press and hold either Multi-Function Button for 5 seconds to turn the earbuds OFF.
BLUETOOTH PAIRING
- When the earbuds are ON, they will automatically enter pairing mode.
- Select ‘ekids B16’ on your Bluetooth-enabled device to connect.
- A voice prompt will sound to indicate pairing is complete.
Earbuds will automatically connect to your Bluetooth device whenever it is in range. To manually pair, press the MFB on each earbud 2 times. To reset Bluetooth, press the MFB on both earbuds 3 times.
MULTI-FUNCTION BUTTON
Speakerphone
Answer Call| Double press MFB
Reject Call| Press MFB for 2 sec
End Call| Double press MFB
Voice Assistant
ON/OFF| Press MFB 3x
Bluetooth Audio
Play/Pause| Short press MFB
Volume Up| Press LEFT MFB for 2 sec
Volume Down| Press RIGHT MFB for 2 sec
Next Track| Quick double press LEFT MFB
Previous Track| Quick double press RIGHT MFB
LED INDICATORS
Earbud Charging
Charging| Flashing White LED
Fully charged| LED OFF
Case Charging
Charging| 1 LED= 25% / 2 LED= 50% / 3 LED= 75%
Fully charged| 4 Solid LED
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED statements
- This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
- This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF exposure
This device complies with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.