FLAMA 2326FL Fan Heater Instruction Manual

FLAMA 2326FL Fan Heater

FAN HEATER

SECURITY INSTRUCTIONS

Read all instructions carefully before using the device for the first time and keep this manual. Any use that does not comply with the instructions releases FLAMA from all responsibilities. Before each use, make sure that the appliance, the socket and the cable are in good condition. The device must be used under the normal conditions of use defined in this manual.
CAUTION: To avoid the risk of overheating, NEVER COVER the device. Do not use this heater if it has been dropped; Do not use the heater if there are visible signs of damage; Use this heater on a horizontal, stable surface or hang it on the wall, as applicable. It is advisable to keep the device out of the reach of children under 3 years of age, unless they are accompanied by an adult. Do not place the device under a socket. Do not use this appliance near baths, showers, washbasins or swimming pools. WARNING: Do not use this heater in small rooms when they are occupied by persons unable to leave the room on their own initiative, except under constant supervision. WARNING: To reduce the risk of fire, keep textiles, curtains or other flammable materials at least 1 m away from the air outlet. Do not let water penetrate the device. Do not touch the device with wet hands. Do not insert any type of object inside the device (eg needles, etc.). If the power cord is damaged in any way, it must be replaced by the manufacturer, an authorized Technical Assistance Center or a qualified technician, in order to avoid any danger to the user. To learn more about maintenance and cleaning operations, see the user guide that comes with the appliance. Children between 3 and 8 years of age must only be able to switch the appliance on or off if it has been placed or installed in the normal operating position and if children are accompanied or have been instructed on how to use the appliance safely and understand all potential hazards. Children between 3 and 8 years of age must not install, adjust or clean the appliance, or carry out maintenance at the expense of the user. ATTENTION: Some components of the appliance can reach very high temperatures and cause burns. Particular attention should be paid to the presence of children and vulnerable people. This appliance can be used by children over 8 years of age and by persons with reduced physical, sensory or mental capabilities, or without experience or knowledge, if these persons are properly supervised or if they have received instructions regarding the safe use of the appliance and if the possible risks have been assimilated. Children must not use the appliance as a toy. Cleaning and user maintenance must not be carried out by children without supervision.
This product complies with the Electromagnetic Compatibility and Low Voltage Directives. This instruction manual is also available in PDF format at www. flama.pt.

RECOMMENDATIONS

The electrical installation of the part, the installation of the device and its use must comply with the regulations in force in your country.
Do not use the device near flammable objects and products, and, in general, respect the minimum distance of 50 cm between the device and other objects (walls, curtains, mists, etc.).
The appliance must be placed so that the electrical plug is accessible.
Do not pull on the power cord or the appliance, even when you want to disconnect the plug from the socket.
Never use the appliance leaning or lying on its side.
This product is intended for domestic use only. In the event of professional, inappropriate use or use that does not comply with the instructions, the manufacturer declines all responsibility and the guarantee will be void.
Fully unwind the cable before each use.
Do not use an extension cord not adapted to the power of the appliance.
Do not switch on the appliance in a dusty place or where there is a risk of fire.

USE IN BATHROOMS (protection against water falls)

The design of this «IPX1» appliance allows it to be used in any of the areas, including places that may present a risk of vertical water falls (kitchen, bathroom, etc.).
In France, the NFC15100 Standard governs the installation’s standard security rules. 4 volumes are defined for bathrooms.
In such a room, the appliance must only be installed in volume 3, so that the control buttons are not within reach of a person using the bath or shower.
The electrical installation in the area, the installation of the appliance and its use must comply with the regulations in force in your country.
Never use the appliance without the corresponding filter (if supplied).
Switch off and let the appliance cool down before putting it away or carrying out any maintenance operations.
In the event of any damage resulting from incorrect use, the warranty will be void.
If the appliance is used in a bathroom with a bath or shower, the “protection volume” illustrated in fig. 1.
In any case, it should always be installed away from taps, sinks, showers, etc.
The appliance must not be placed immediately under a fixed power socket.

DESCRIPTION

1. Indicator light
2. Power & Mode rotary knob
3. Thermostat adjustment knob

OPERATION

The fan heater can be operated using the manual controls located on the fan heater.
Carefully remove the fan heater from the box and bag.
Make sure the appliance is in the off position (o) before connecting the fan heater to the mains.
The fan heater must be placed on a solid, flat surface.
Plug the power plug into an electrical outlet. Make sure the plug is securely in the socket. If not properly seated, it can overheat and damage the outlet. The cord and plug assembly may become hot during normal use.
Turn the Power & Mode rotary knob to the desired programmed temperature. The low temperature (1000W) is represented by ( I ) and the high temperature (2000W) by ( II ).
For fan only operation without any heat production, turn the Power & Mode rotary knob to the fan setting ( ).
To adjust the temperature, adjust the thermostat adjustment knob, depending on the room temperature and the desired temperature. The appliance only starts up after turning the thermostat adjustment knob to a temperature higher than that measured by the appliance’s internal thermostat.
To turn off the fan heater, turn the Power & Mode rotary knob to the off position (o). Then remove the plug from the socket.
The indicator light remains on until the appliance is turned off.

THERMOSTAT INSTRUCTIONS

Before adjusting the thermostat, let the fan heater operate and heat the room. To do this, turn the thermostat adjustment knob to the maximum temperature.
When the desired temperature is reached, lower the thermostat setting until the fan heater switches off. You can do this by turning the thermostat adjustment knob counterclockwise.
The fan heater will automatically maintain the set temperature by cycling on and off. To prevent the fan heater from cycling on and off, set the thermostat adjustment knob to a higher temperature position.
NOTE: It is normal for the fan heater to turn on and off as it maintains a fixed temperature.

SAFETY FEATURES

Fall protection system:
The appliance has a safety device that switches it off automatically if the working position is not correct or if the appliance falls over.
The fan heater is equipped with thermal overload protection to prevent overheating.
The fan heater switches off automatically when it reaches an excessive temperature. It only works again if the user restarts the appliance. (See RESTART INSTRUCTIONS below)

RESTART INSTRUCTIONS

Turn off the fan heater and wait 15 minutes for the appliance to cool down.
After 15 minutes, turn the appliance back on and operate normally.

TROUBLESHOOTING TIPS

If your fan heater unexpectedly shuts down or stops working, this could be due to activating one of the aforementioned safety features to prevent overheating. Make sure the power plug is plugged into a working electrical outlet. Check thermostat settings. The fan heater may be off because it has reached the desired fixed temperature.
NOTE: In order to avoid overheating, do not cover the appliance.

CLEANING AND MAINTENANCE

WARNING: Always disconnect the plug before moving or repairing the appliance.

Cleaning:
IMPORTANT! DO NOT IMMERSE THE VENTILATOR IN WATER! Clean the fan heater grilles with your vacuum cleaner brush attachment. This will remove lint and dirt from the inside of the heater. DO NOT ATTEMPT TO DISASSEMBLE THE VENTILATOR. Clean the outside of the fan heater with a soft cloth. DANGER: Do not use gasoline, benzine, thinner, abrasive cleaning fluids, etc. as these will damage the fan heater. NEVER USE ALCOHOL OR SOLVENTS.

STORAGE
Store the fan heater together with these instructions in the original box in a cool, dry place.

ANOMALIES AND REPAIR
In case of malfunction, please take the appliance to an authorized Technical Assistance Service. Do not attempt to disassemble or repair the appliance, as this may be dangerous.

PROTECTING THE ENVIRONMENT
This symbol indicates the separate collection of electrical and electronic equipment.
The main objective of the separate collection of this waste is to reduce the quantity to be disposed of, promote reuse, recycling and other forms of recovery in order to reduce its negative effects on the environment.
When it is no longer in use, this appliance must not be disposed of together with other unsorted municipal waste.
The user is responsible for delivering it free of charge to the selective collection facilities available for that purpose.
Pieces of equipment that are no longer in use can also be taken back at points of sale, by purchasing new pieces of equipment that are equivalent and have the same functions.
For more detailed information on collection points, please contact your City Council or a point of sale for this equipment.

INFORMATION REQUIREMENTS

Model identifier(s) 2326FL

Element| Symbol| Value| Unit| Element| Unit
Heating output| Type of heating output, only for electric, accumulation ambient heaters (choose one option)
Nominal heating

output

| ****

Pnom

| 2,0| kW| Manual thermal load control, with integrated thermostat| No
Minimum heating output (indicative)| ****

Pmin

| 1,0| kW| Manual thermal output control, with interior and/or exterior temperature retroaction| No
Maximum continuous heating output| ****

Pmax, c

| ****

2,0

| ****

kW

| Electronic control of thermal load, with interior and/or exterior temperature retroaction| ****

No

Auxiliary electricity consumption| Heating potential with fan| No
At nominal heating

output

| ****

elmax

| 0,01| kW| Type of heating output/interior temperature control (select an option)
At minimum heating output| ****

elmin

| 0,01| kW| Heating potential in a single phase, without interior temperature control| No
In standby mode| ****

elSB

| N/A| kW| In two or more manual phases, without interior temperature control| No
| | | | With interior temperature control by mechanical thermostat| Yes
| | | | With electronic interior temperature control| No
| | | | With electronic interior temperature control and daily timer| No
| | | | With electronic interior temperature control and weekly timer| No
| | | | Other control options (multiple selections possible)
| | | | Interior temperature control, with presence detection| No
| | | | Interior temperature control, with open window detection| No
| | | | With remote control option| No
| | | | With adaptive startup control| No
| | | | With limited operation time| No
| | | | With black body sensor| No
|

Fábrica de Louças e Electrodomésticos, S.A. Zona Industrial | Apartado 2041 3701-906 Cesar Portugal
Tel: +351 256 850 170
Fax: +351 256 850 179
Website: www.flama.pt
Email: info@flama.pt

References

• Empresa Pequenos e Grandes Eletrodomésticos | Flama
• Empresa Pequenos e Grandes Eletrodomésticos | Flama

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>