PNI International B5500 PRO Audio Baby Monitor User Manual
- June 3, 2024
- PNI International
Table of Contents
PNI International B5500 PRO Audio Baby Monitor
Safety warnings
PNI B5500 PRO is a safe to use product that meets the relevant standards related to electromagnetic fields.
- Before using this product, read the instruction manual carefully.
- The product should only be assembled by adults.
- Do not allow children access to the power cords.
- This product is not a toy. Do not allow children to play with it.
- This product does not replace the responsible supervision of an adult.
- Position the product at least 1 meter away from the child.
- Do not keep the product close to heat or water.
- Observe the supply voltage recommended by the manufacturer.
Baby unit
- A – LED indicator
- B – On /off button (long press the button to turn the unit on /off)
- C – Night light
- D – Microphone
Power supply
Insert one end of the included power cord into the Micro-USB port on the back
of the unit and the other end into a 230V USB adapter (not included).
Optionally, the unit can also be powered by batteries. Insert 3 AAA batteries
into the battery compartment (not included).
Parent unit
- E – LED indicator
- F – PTT button (press and hold to talk to the child remotely)
- G – Turn the night light on /off on the child unit
- H – Volume control
- I – On /off button (long press the button to turn the unit on /off)
- J – Microphone
Power supply
Insert one end of the included power cord into the Micro-USB port on the back
of the unit and the other end into a 230V USB adapter (not included).
Optionally, the unit can also be powered by batteries. Insert 3 AAA batteries
into the battery compartment (not included).
Pairing the two units
Note: the two units are paired from the factory.
If a problem occurs and the two units no longer communicate even though they
are within the reccomended range, follow the procedure below to pair them
again:
Press and hold the on /off button on both units simultaneously for about 5
seconds.
Functions
Out of range
When the two units are too far from each other, an alarm is triggered: the
parent unit will emit a continuous beep, and the LED on both units will flash
red /green.
Discharged battery
When the batteries installed in any of the units are discharged, the unit will
beep every 30 seconds and the LED will flash red.
Pager (unit location)
Briefly press the on /off button on the child unit to send a signal to the
parent unit to locate it. The parent unit will output a Di .., Di .., Di ..
sound until you briefly press the on /off button.
Night light
You can turn the night light on or off by 3 methods:
- 1. Briefly press the power button on the parent unit once.
- Briefly press the side button (C-night light) on the parent unit.
- Briefly press the on /off button on the child unit 3 times.
Vox
As long as there are noises in the child’s room, the child unit will emit
continuously. Approximately 30 seconds after the interruption of any noise,
the unit will enter standby mode (no longer emits). When the unit detects
noise again, it starts emitting. The time when it starts emitting depends on
the set sensitivity.
Microphone sensitivity control
K – Microphone sensitivity adjustment (Hi/Lo)
- Move the knob to the right to activate the low sensitivity of the microphone, a setting suitable for noisy environments or when the child unit is close to the child. The child unit starts emitting when the sound reaches 60dB.
- Move the knob to the left to activate the high sensitivity of the microphone, setting suitable for quiet environments or when the child unit is further away from the child. The child unit starts emitting when the sound reaches 50dB.
Note: Position the child unit 1 – 3 meters away from the child.
Technical specifications
Power supply| 5V (via Micro-USB port)
4.5V (3 x AAA batteries, not included)
---|---
Communication frequency| 2.4GHz
Emission power| 0.1W
Communication distance| Up to 100 meters (in open field)
Two-way audio| Yes
Microphone| Built-in
Speaker| Built-in
Dimensions| 70 x 40 x 100mm
Working temperature| 0°C ~ +50°C
Simplified EU declaration of conformity
SC ONLINESHOP SRL declares that Audio Baby Monitor PNI B5500 PRO is in
accordance with the EMC Directive 2014/30/EU and the RED Directive 2014/53
/EU. The full text of the EU Declaration of Conformity is available at the
following website:
https://www.mypni.eu/products/8335/download/certifications
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>