JENSEN JS69T Car audio speakers Owner’s Manual

: June 5, 2024
: Jensen

Table of Contents

Safety Guidelines
INSTALLATION
Mounting
OPERATION
SPECIFICATIONS & FEATURES
WARRANTY
Documents / Resources

TRIAXIAL SERIES

INSTALLATION/OWNER’S MANUAL Car Audio Speakers

PREPARATION

Safety Guidelines

Thank you for purchasing the Jensen JS Triaxial Series Car Speakers. Although Jensen has attempted to make sure all of the information contained within this manual is accurate. please be aware that any part of it is subject to change without notice.
CAUTION The following instructions should be used a general guideline only.
If you are unsure about performing any of the procedures listed below. please consult a professional car audio installation center.

Before installation, please follow these guidelines:

Be sure to carefully read and understand the instructions before attempting to install this product.
For safety. disconnect the negative terminal from the battery prior to beginning the installation.
To ensure an obstacle-free fit. check and double-check the mounting depth of the speakers against available depth. as well as the location of window mechanics. door handles. and window handles.
Use caution before you drill or cut! Be careful not to cut or drill into gas tanks. fuel lines. brake or hydraulic lines. vacuum lines or electrical wiring when working on any vehicle.
Never run speaker wires underneath your vehicle. Running speaker wires inside the vehicle provides the best protection from exhaust heat and environmental elements.
Avoid running wires over. near. or through sharp-edged surfaces. Use rubber grommets to protect any wires routed through metal.
When running the speaker cable from the amplifier. avoid running it near sources of high current (i.e. wiring harnesses. battery cables).
If using provided grilles. be sure the mounting location is a sufficient distance from the door and/or window handles.

INSTALLATION

Basic Installation Steps
Step 1: Remove existing speaker.
Step 2: Position new speaker and align with existing mounting holes.
Step 3: Attach the positive(+) and negative (-) speaker terminals
(see FIGURE 2). Be sure to observe proper polarity when connecting the wires (the striped wire is the negative lead) . JENSEN JS69T Car audio speakers -
speaker

Connect the speaker outputs from the head unit to the speakers.
In some vehicles. it may be possible to utilize the existing speaker wiring. When doing this. be cautious of the polarity(+/-) of the speaker wires. as these wire colors vary for each vehicle.
Tip: Using factory wiring harness adapters for the head unit and speakers can help eliminate wiring issues.
In some vehicles. it may be necessary to run new speaker wire throughout the vehicle. Observe caution when routing wires.
Always use quality connectors that fit tightly. or solder each connection. It may be necessary to waterproof connections made inside door panels.
Wiring speakers out-of-phase (the polarity of one speaker is wrong) will cause the speakers to sound poor. and have very little bass response.

Mounting

Determine where the speakers will be mounted. Make sure the area is large enough for the speaker to mount evenly. Also ensure the mounting location is deep enough for
the speaker to fit.
Refer to the specification chart to determine the proper diameter hole to cut for your speaker model.
If needed. use the grille as a template to mark the locations for the mounting screws. Drill the holes with a 3/32″ bit.
Fit the speaker to the hole cut-out. Mount the speaker using the supplied screws. If the speaker grille is to be used. insert 4 screws into the grille insert holes and then mount the speaker.

JENSEN JS69T Car audio speakers - speakers |
---|---

OPERATION

Specifications JENSEN JS69T Car audio speakers - fig
2

The above diagram is to be used with the specifications matrix guide below.
Design and specifications subject to change without notice.

Model| Size| Type| Power
(RMS/Peak)
Rating| Sensitivity| Frequency
Response| Cutout
Diameter| Top
Mounting
Depth| Bottom
Mounting
Depth| Mounting
Height| Tweeter
Height
---|---|---|---|---|---|---|---|---|---|---
JS65T| 6.5″| 3-Way| 50W/250W| 87dB| 70Hz-
20kHz| 5.59″| 2 28′| 2.44″| 0.67″| 0.51′
JS68T| 5″x 7″
6″x 8″| 3-Way| 50W/250W| 87dB| 70Hz-
20kHz| 4 95 x 7 11| 2.22″| 2.59″| 0.65″| 0.28″
JS69T| 6″x 9″| 3-Way| 75W/375W| 89dB| 50Hz-
20kHz| 5.95″ x 8.70*| 3.11″| 3.56″| 0.87″| 0.42

SPECIFICATIONS & FEATURES

| JS65T| JS68T| JS69T
---|---|---|---
Speaker Size| 6 1/2″| 5″ x7″ / 6″ x8″”| 6″ X 9″
RMS / Peak Power| SOW/ 25OW| SOW/ 25OW| 75W / 375W
Woofer Surround Type| Nitrile Butadiene Rubber| Nitrile Butadiene Rubber| Nitrile Butadiene Rubber
Woofer Material| IMPP| IMPP| IMPP
Midrange Size| 35mm| 35mm| 58mm
Midrange Material| Mylar dome| Mylar dome| Mylar dome
Tweeter(s) Size| 15mm| 15mm| 20mm
Tweeter(s) Type| Piezo| Piezo| Piezo
Voice Coil Type| TSV| TSV| TSV
Voice Coil Size| 25mm| 25mm| 35mm
Sensitivity| 87db| 87db| 89db
Frequency Response| 70-20khz| 70-20khz| 5O-2Okhz
Nominal Impedance| 4ohms| 4ohms| 4ohms
Grilles Included| Yes| No| Yes

JENSEN JS69T Car audio speakers - fig 3

WARRANTY

Limited One-Year Warranty
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
Namsung America Inc. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase.
Namsung America Inc. agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new, renewed or comparable product (whichever is deemed necessary) in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. Subsequent replacement products are warranted for the balance of the original warranty period.
Who is covered?
This warranty is extended to the original retail purchaser for products purchased from an authorized Jensen dealer and used in the U.S.A .
What is covered?
This warranty covers all defects in material and workmanship in this product. The following are not covered: software, installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product. Specific license conditions and copyright notices for the software can be found via
www.jensenmobile.com
What to do?

Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls may save you a service call.
If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center.
Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment.
For more information and for the location of the nearest authorized service center please contact us by one of the following methods:
• Call us toll-free at 1-888-921-408
• E-mail us at cs@jensenmobile.com

Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.
customer Support
:1-888-921-4088
[Monday-Friday, 9AM – 5~M EST)
https://www.jensenmob1le.com
Designed and Engineered in the USA
Namsung America Inc. ©2021 Namsung America Inc. All rights reserved.
All rights reserved. No part of this publication may be reproduced. distributed. or transmitted in any form or by any means. including photocopying. recording. or other electronic or mechanical methods. without the
prior written permission of SAMSUNG AMERICA INC
NSC0921-V01
Register your warranty

https://jensenmobile.com/register.html
Scan to register, or visit:
https://jensenmobile.com/register.html
Upon registration, you may also choose to be notified of product updates or special promotions.
Visitwww.jensenmobile.com for detailed owner’s manuals on most products.
If you need any assistance, please contact customer service atcs@iensenmobile.com or call 1-888-921-4088 M-F 9 am -5 pm ET Thank you for your purchase! www.JensenMobile.com
Follow us to keep up to date wit11 new
products and information
Facebook JensenAuclio Instagram Jense11Auclio Twitter @Jensen Auclio