Flipo TOYS 804634T27M Remote Control for Dasher Twister Stunt Car Instruction Manual

Flipo TOYS 804634T27M Remote Control for Dasher Twister Stunt Car

Please read this instruction manual carefully before using.

•  For Ages 3+
•  Adult guidance is strongly recommended.

BATTERY INSTALLATION REMOTE CONTROL

1.  Loosen and remove the lock screw located on the rear of your remote control and remove the battery compartment lid.
2.  Insert 2 AA batteries according to the polarity information located in the compartment; make sure the (+) and (-) poles of each battery are positioned correctly.
3.  Replace the battery compartment door and screw; tighten screw completely to lock in place.

CAR

1.  Loosen and take out the lock screw located on the rear of your Dasher and remove the battery compartment lid.
2.  Insert 3 AA batteries according to the polarity information located in the compartment; make sure the (+) and (-) poles of each battery are positioned correctly.
3.  Replace the battery compartment door and screw; tighten screw completely to lock in place.

OPERATION

1.  The Dasher is activated by moving the red toggle switch located on the bottom of the vehicle to the ON position. To deactivate, move the switch to the OFF position
2.  Your vehicle is paired to a remote control of matching frequency. Your remote control will be labeled with the corresponding frequency.
3.  Drive the car by operating the white buttons on your remote control (Figure A).

SPINNING STUNT MOVES
Your Dasher is capable of any number of spins, turns, wheelies and other stunts. To do so, simply move your Dasher backward or forwards while also pushing one of the buttons on the right side of the remote that make the front axle twist. Different combinations of pushing these buttons will create different tricks! (Figure B)

IMPORTANT
Dasher’s are available in two colors, red & green. To allow for simultaneous play, each vehicle is paired to a remote control of matching frequency. The red Dasher is 27Mhz and the green car is 49Mhz – your remote controls will be labeled with the corresponding frequencies.

WARNINGS:

•  Not suitable for children under 3 years of age.
•  Installation of batteries should ALWAYS be done by an adult.
• Don’t pick up the vehicle while in motion.
•  Don’t place your vehicle or remote control near any source of heat.
•  Don’t operate your vehicle in dangerous places.
•  Avoid operating on sand, gravel or other loose surfaces.
•  Don’t let the vehicle get wet. Don’t run through water or operate in the rain.
•  Do not disassemble the vehicle or remote control.
•  If the vehicle is damaged and any broken parts are exposed, the vehicle should not be used.
• Watch for and avoid obstacles.

BATTERY CARE:

•  Failure to insert batteries in the correct polarity may shorten the life of the batteries or cause batteries to leak.
•  Do not mix old and new batteries.
•  For best results, use alkaline batteries.
•  Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.

FCC INFORMATION

This device complies with part 15 of the FCC Rule. Operation is subject to the following two conditions:  This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. 30 DAYS LIMITED WARRANTY: FLIPO GROUP warrants to the original purchaser, when used in North America only, that this product shall be free of defects in material and workmanship. This warranty applies within 30 days of the original purchase with normal home use. This warranty does not apply for commercial use of this product. Use outside of North America is not covered by this warranty. During the warranty period, we will at our option, repair or replace this product without charge, which shall be the consumer’s sole remedy. ALL RETURNS must be accompanied by a Return Authorization Number, which is issued by the Customer Service Department of Flipo Group. Please contact Customer Service BEFORE returning any item. Once you have obtained a Return Authorization Number, the product must be returned with a clear copy of the proof of purchase, showing place and date of purchase, postage and insurance prepaid .

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.

To assure continued compliance, any changes or modifications not expressly approved by the party.Responsible for compliance could void the user’s authority to operate this equipment. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.  This device may not cause harmful interference, and
2.  This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement. The device can ben used inthe portable exposure condition with restiction

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>