TnB UMTYRE10 Pneu 10 Inch Escooter Tyre Instructions
- June 5, 2024
- TnB
Table of Contents
UMTYRE10 Pneu 10 Inch Escooter
Tyre Instructions
UMTYRE10 Pneu 10 Inch Escooter Tyre
PNEU 10″
POUR TROTTINETTE ~LECTRIQUE
10″ESCOOTER TYRE
Instructions
UMTYRE1O
22/06/2022 03:17
OUR THANKS
Congratulations on your purchase and thank you for your trust and confidence in Tine. Our products comply with the regulations and standards In force. Before using this device, we recommend that you read the instructions and safety guidelines carefully and keep this manual for future reference.
Material needed.
cutter, Phillips screwdriver, Allen key, lubricant or liquid soap, 3 tire
levers, 2 clamps
– Use the cutter to remove the red adhesive part. Use a Phillips screwdriver
to loosen the screws. Remove the plastic guard and unthread the central bolt
using an Allen key. Perform these operations on both sides of the wheel.
– Remove the wheel from its place. For the front wheel, pull the brake cable
and be careful not to damage it. For the rear wheel, unscrew the 5 screws with
a Phillips screwdriver and remove the disc.
– Unscrew the valve and push It lightly with a screwdriver.
– At this point, apply lubricant or liquid soap on the inner edges of the tire
for easy handling. If you are unable to do as above, the following steps are
still possible.
– Place 2 tire levers on either side of the valve. Leverage to remove the tire
from the rim, then repeat this operation around the wheel.
– Extract the tire and the inner tube from the rim, taking care to loosen the
valve.
– Extract the inner tube from the tire. Unscrew the valve from the new inner
tube and inflate it to 3/4.
– Insert the inner tube into the tire, taking care to keep the valve in its
location, in the rim.
– Insert the inner tube into the tire, taking care to keep the valve in its
location.
– Lubricate the inside of the tire to facilitate the following operations.
– Using a tire lever, position the tire on the first part of the rim.
– Use two clamps to clamp the tire on both sides of the valve.
– Place two tire levers opposite the clamps, then leverage with a third tire
lever between the two already installed.
– Remove the tire levers and the clamps.
– Use the valve to inflate the inner tube.
– For the rear wheel, tighten the 5 brake disc screws.
– Replace the wheel in its location and screw in the bolts on both sides.
For the front wheel, remember to reinsert the brake cable in its notch so that
it doesn’t protrude from the fork Screw the plastic guard in place and
reposition the red sticker.
NEED HELP?
Concerned about the satisfaction of our customers, you can contact us at
info@t-nb.com.
For maintenance, troubleshooting, and miscellaneous information about this
product, please visit our website: www.t-nb.com
t-nb.com
TnB SA France / Rue Nicolas Joseph Cu0t
PA de La Cu/13300 $alone Provence
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>