PDi PD168-079 100mm x 200mm Wall Mount Bracket Instruction Manual

June 5, 2024
PDi

PDi PD168-079 100mm x 200mm Wall Mount Bracket

Scope:
To install the PD168-079 wall mount kit to a PDi television. Note: The maximum capacity for this mount is 50 pounds.

Tool List:

  1. Safety glasses/goggles
  2. P1 or P2 Phillips screwdriver
  3. Level

Safety Steps

  1. Always wear safety glasses/goggles to prevent injury from debris.
  2. Follow the installation/removal instructions for existing products.

Mounting Distances
9” Minimum from clevis to ceiling for a PDi PDI-A32A

PDI-A32A MOUNTING DISTANCE

Bill of Material

Item Part Number Description Qty
1 PD181-900 100mm X 200mm Mounting Bracket to LCD 1
2 PD181-674 Vertical Wall Mount Bracket 1
3 PDIPPHMS103238 10-32 X .375 Phillips Pan Head Machine Screw 2
4 PDIITLW10 Washer, Internal Tooth Lock, #10 2
5 PDIFW25 1/4” Flat Washer 2
6 PDISLW25 1/4” Lock Washer 1
7 PDIPPHMSM6X110 M6 x 1 x 10mm Long Phillips Head Screw 4

Installation Procedure:

  • Step 1:
    Secure the PD181-900 Mounting Bracket (#1) to the TV using four (4) PDIPPHMSM6X110 screw (#7).

  • Step 2:
    Attach PD181-674 (#2) to the wall using customer-supplied 1/4” fasteners following the mounting distance diagram dimensions. Place one (1) PDIFW25 flat washer (#5) and one (1) PDISLW25 lock washer (#6) on the top fastener and through the top slot in the bracket. Place the remaining PDIFW25 flat washer (#5) on the bottom mounting fastener. Level the bracket using the top leveling slot and finish tightening fasteners.
    Note: If not installing into a solid wood stud, PDi recommends using Snap Toggle Wall Anchors as outlined in Tech Bulletin PDTCH-109.

  • Step 3:
    Carefully lift the set up and position the PD181-900 Mounting Bracket (#1) inside the sides of PD181-674 Wall Mount Clevis (#2) allowing the two side support pins of the PD181-900 Mounting Bracket (#1) to rest in the two notches at the front of PD181-674 Wall Mount Clevis (#2). Install two (2) PDIPPHMS103238 screws (#3), and two (2) PDIITLW10 washers (#4) and finger tighten. Position the tilt of the TV as desired and tighten the PDIPPHMS103238 screws (#3) until the TV holds in the desired position. PDi-
PD168-079-100mm-x-200mm-Wall-Mount-Bracket-fig-4

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals