PDi 1400 Series ARMS Cover Installation Guide

June 4, 2024
PDi

MODEL NUMBER:
1400 SERIES ARMS
ARM COVER INSTALLATION

Safety steps:

  1. Always wear safety glasses/goggles to prevent injury from debris.
  2. Follow the installation/removal instructions for your existing products.

TOOL LIST:

  1. P1 or P2, Phillips screwdriver
  2. Safety glasses/goggles

NOTE:

  1. Attach the arm to the wall bracket and mount TV to the arm before beginning cover installation.
  2. The arm Safety Brake Pin must be removed from the arm nose to install the new Nose Arm Cover.
  3. DO NOT DISCARD THE SAFETY BRAKE PIN. Keep the safety pin for future service of the arm and/or TV. Locate the plastic Retainer Clip attached to the Arm’s safety brake pin. Attach the safety brake pin/clip to the coax cable inside the nose as shown.

PDi 1400 Series ARMS Cover - AFETY BRAKE PIN

PARTS LIST for KIT:

  1. (1) PD216-102L Base Cover
  2. (1) PD216-102R Base Cover
  3. (2) PD216-103 Elbow Covers
  4. (1) PD216-057L Left Nose Cover
  5. (1) PD216-057R Right Nose Cover
  6. (8) PD209-004 Painted Cover Screw

WALL MOUNTED ARM ­ PDI-AA14XX

STEP 1. Attach the left and right Base Covers using (4) PD209-004 screws.
STEP 2. Starting at the top of the elbow cover, hook the cover over the elbow plate on each side. Ensure the tabs on each half align with each other. Snap the lower hooks on the bottom of the elbow cover.
STEP 3. Attach the left and right Nose covers to the nose, using (4) PD209-004 screws.
STEP 4. Rotate the TV and move the arm through its range of travel to check for any interference issues.
NOTE: When the covers are properly installed there should only be a thin seam visible where the halves meet.

PDi 1400 Series ARMS Cover - WALL MOUNTED ARM

CEILING MOUNTED ARM – PDI-AC14XX & PDI-AD14XX 

STEP 1. Starting at the top of the elbow cover, hook the cover over the elbow plate on each side. Ensure the tabs on each half align with each other. Snap the lower hooks on the bottom of the elbow cover.
STEP 2. Attach the left and right Nose covers to the nose, using (4) PD209-004 screws.
STEP 3. Rotate the TV and move the arm through its range of travel to check for any interference issues.
NOTES:

  1. When the covers are properly installed there should only be a thin seam visible where the halves meet.
  2. The Base Covers and 4 Screws are not used on the ceiling-mounted arm. These parts can be kept or discarded.

PDi 1400 Series ARMS Cover - CEILING MOUNTED ARM

Document Number: PD196-379R3
PDi Communication Systems, Inc.

40 Greenwood Lane Springboro, Ohio 45066 USA
PH 1-800-628-9870 FX 937-743-5664 ****

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals