hama 00223304 Mini Mechanical Timer for Outdoors Instruction Manual
- June 5, 2024
- Hama
Table of Contents
hama 00223304 Mini Mechanical Timer for Outdoors
Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely.
Please keep these instructions in a safe place for future reference. If you
sell the device, please pass these operating instructions on to the new owner.
Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from touching uninsulated
product parts that may carry hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your
attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
Package contents
- “Mini” mechanical daytime timer for outdoors
- These operating instructions
Safety instructions
- The timer complies with the IP 44 regulation, which means that the timer is splash-proof and therefore suitable for outdoor use. No direct jet water (e.g. from a garden hose or other irrigation systems) may be directed at the product! Operate the product either indoors or in a protected outdoor area, e.g. under eaves or in a garage. Never expose the product to precipitation! Otherwise there is a danger of a life-threatening electric shock!
- Never connect the timer to an extension cable or adapter. Instead only connect it directly to the power socket since otherwise overheating can occur.
- Use the timer only in permanently installed wall sockets.
- Immediately disconnect the defective unit from the mains and do not operate it any more.
- Repairs may only be carried out by authorised specialists.
- As with all electrical products, this device should be kept out of the reach of children.
- The product must only be operated on a supply network as described on the type plate.
- The product is intended for private, non-commercial use only.
- Use the product only for the intended purpose.
- Do not operate the product outside the power limits given in the specifications.
- The maximum connected load is 1800 Watt (resistive load). In the event of an overload, there is a risk of destroying the timer.
- Do not drop the product and do not expose it to any major shocks.
- As with all electrical products, this device should be kept out of the reach of children.
- Dispose of packaging material in accordance with the locally applicable regulations.
- Do not modify the product in any way. Doing so voids the warranty.
- Never connect multiple units of this product in series.
- Do not use any heat-generating devices (such as electric blankets, coffee machines, etc.) with this product. There is a risk of fire and injury.
- Do not use this product with any devices that are motorised or any devices that have a rotating component or tool. There is a risk of injury.
- Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
- Only use the article under moderate climatic conditions.
- Do not use the product in areas in which electronic products are not permitted.
Risk of electric shock
- Do not open the device or continue to operate it if it becomes damaged.
- Do not use the product if the AC adapter, the adapter cable or the mains cable are damaged.
- Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Getting started
Warning
- Only operate the product from an approved socket that is connected to the public power supply. The socket must be installed close to the product and must be easily accessible.
- Disconnect the product from the power supply using the On/Off switch – if this is not available, unplug the power cord from the socket.
- If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the socket strip’s maximum throughput rating.
- If you will not be using the product for a prolonged period, disconnect it from mains power.
Programming on/off times
To program the switch-on times, the black tab is pushed downwards according to
the desired time.
1 tab equals 30 minutes. If a longer time span is required, more tabs
(30-minute intervals) must be pushed downwards.
Switch-off times: Tab position > top
Setting the current time
The time selector dial is turned clockwise until the arrow on the inner ring
of the selector dial shows the current time.
Connecting the timer to the mains, connecting electrical appliances to the
timer
Insert the plug of the timer into a 230 V earthed socket, then insert the
mains plug (IP44) of the electrical appliance to be switched into the earthed
socket of the timer. The product may only be used indoors or in protected
outdoor areas (e.g. under eaves, in a garage or similar).
The timer may only be operated in the position de-scribed below. The socket
must be at the top, the rotary wheel for setting the time at the bottom.
Care and maintenance
Note : Disconnect the device from the mains before cleaning and during
prolonged periods of non-use.
Only clean this product using a lint-free, slightly damp cloth and do not use
any harsh cleaners.
Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.
Technical data
Timer switch | |
---|---|
Mains connection | 230 V ~ / 16 (2) A |
Connected load | 1800 W |
Protection class | 1 |
Protection | IP44 |
Switching intervals | 30-minute cycle |
Hama GmbH & Co KG
86652 Monheim /Germany
Service &Support
www.hama.com
49 9091 502-0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>