Crux SWRHN-62L Radio Replacement Accessories Instruction Manual
- June 5, 2024
- CRUX
Table of Contents
Crux SWRHN-62L Radio Replacement Accessories
PRODUCT FEATURES
- Retains factory features in select Honda vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- Retains Factory Auxiliary Input.
- EIA color coded wiring for easy installation.
NOTES:
- Does not support amplified systems.
- Does not retain Rear Seat Entertainment system (RSE).
- Does not retain factory navigation system.
PARTS INCLUDED
- SWRHN-62L MODULE
- SWRHN-62L HARNESS
- ANTENNA ADAPTER
- SWC CABLE
INSTALLATION DIAGRAM
DIP SWITCH SETTINGS
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP:
Atoto, Dual, Farenheit, Jensen, Pioneer
| 1
OFF
| 2
OFF
| 3
ON
| 4
ON
---|---|---|---|---
Power Acoustik, Soundstream| OFF| OFF| ON| ON
Blaupunkt, Most off-brand Radios| OFF| OFF| ON| ON
Alpine| OFF| OFF| OFF| OFF
Clarion| OFF| ON| ON| OFF
Kenwood| OFF| ON| ON| ON
JVC| OFF| ON| OFF| ON
Boss, Old Sony| OFF| ON| OFF| OFF
New Sony| OFF| OFF| ON| OFF
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most off-brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
HONDA STEERING WHEEL CONTROL DIP SWITCH SETTING:
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable and set the DIP switches to the aftermarket radio you are using.
NOTE: Insulate the Blue/Yellow wire or 3.5mm plug if not being used.
For aftermarket radios that have wires for SWC connections, cut off the 3.5mm
plug on the Crux SWC Cable and connect the SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this
case “shield” does not need to be connected.
VEHICLE APPLICATIONS
Honda
- 2008 – 2012 Accord DX/EX/LX*
- 2011 – 2013 CRZ
- 2009 – 2013 Fit
- 2008 – 2011 Odyssey
- 2009 – 2013 Pilot*
- 2009 – 2013 Ridgeline
*Does NOT retain factory radio display.
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311 phone: 818-609-9299 • fax: 818-996-8188 • www.cruxinterfacing.com