concept VT 7020 Hot Air Fan Instruction Manual

: June 5, 2024
: concept

Table of Contents

Introduction
IMPORTANT SAFETY INSTRUCTIONS
PRODUCT DESCRIPTION
OPERATING INSTRUCTIONS
MAINTENANCE AND CLEANING
TROUBLESHOOTING
- SERVICING
ENVIRONMENTAL PROTECTION
WARRANTY TERMS
Manufacturer
- Product data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**concept VT 7020 Hot Air Fan Instruction Manual

**

Introduction

Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its service life.

Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe place for future reference. Make sure other people using the product are familiar with these instructions.

Technical parameters

Voltage| 220 – 240 V ~ 50/60 Hz
Input| 850 – 1500 W
Noise level| 65 dB(A)

IMPORTANT SAFETY INSTRUCTIONS

Use the unit only as described in this operating manual.
Remove all the covering and marketing materials from the unit before the first use.
Make sure the mains voltage corresponds to the values stated on the product’s rating plate. Do not connect the unit to adapter plugs or extension cables.
Do not use this unit with any programmable device, timer, or any other product turning the unit on automatically; if the unit is covered or installed improperly, a fire may occur.
Make sure to place the unit on a stable heat-resistant surface, out of the reach of other heat sources.
Close supervision is necessary when the unit is on or plugged into the socket.
Before unplugging the unit from the wall outlet, move the mode selector to the “O” position and then remove the plug from the wall outlet.
Never pull the cord to disconnect the plug from the socket; hold the plug instead.
Do not install the unit directly under the wall outlet.
Keep the minimum safe distance of at least 100 cm between the unit and any flammable materials, such as furniture, curtains, lace, blankets, paper, clothing, and so on.
Keep the air inlet grille and air outlet grille unobstructed (at least 100 cm in front of and 50 cm behind the unit).
Warning! The outlet grille achieves an operational temperature of more than 80°C. Do not touch it; there is a danger of being burned!
Do not allow children or unskilled people to handle the unit. Use the unit out of the reach of these individuals.
Persons with limited movement capacity, reduced sensory perception, insufficient mental capacity or those who are unaware of the proper handling should use the product only under the supervision of a responsible person who is aware of these instructions.
Pay the utmost attention when using the unit near children.
Do not cover the unit. There is a risk of overheating. Do not use the unit for drying cloth.
Do not hang anything above or in front of the unit.
Use the unit only as described in this operating manual.
The unit shall be installed in such a way that the plug remains accessible at all times.
The unit may be operated in the upright position only.
Do not use the unit near a shower, bathtub, sink, or swimming pool.
Do not use the unit in an environment with explosive gases or flammable substances (solvents, varnishes, adhesives, etc.).
Turn the unit off, disconnect the power cord from the wall outlet, and allow the unit to cool before cleaning.
Keep the unit clean; prevent foreign bodies from entering the grille openings. This could cause a short circuit, damage to the unit, or fire.
Do not use abrasive or chemically aggressive substances to clean the unit.
Never use the appliance if the supply cord or plug is damaged. Immediately refer to an authorised service centre for repair.
Do not use the unit if it does not operate properly, if it has been dropped, damaged or exposed to any liquids.
Take the unit to an authorized service centre for testing and repair.
The unit is not designed for outdoor use.
The appliance is intended for domestic use only, not for commercial use.
Never operate the appliance with wet hands.
Do not immerse the power cord, plug, or appliance in water or any other liquid.
The unit is designed as an auxiliary heater, not for the purpose of overall heating of an interior.
The unit shall not be mounted on the wall.
The unit shall not be used in any means of transport.
Do not repair the appliance yourself. Refer to an authorized service centre instead

Failure to follow the manufacturer‘s instructions may lead to refusal of warranty repair.

PRODUCT DESCRIPTION

Air inlet grille
Air outlet grille
Mode selector
Thermostat regulator
Safety switch against overturning the device

Caution
When turning the unit on for the first time or after a prolonged downtime the unit may emit a slight odor. This odour will vanish after a short time.

Note: Do not use the unit in rooms smaller than 4 m2

OPERATING INSTRUCTIONS

Place the unit on a stable surface or floor to prevent it from tipping over. Remove the entire feed cord from the storage space and uncoil it.
Connect the power cord plug to the wall outlet
Select the required function using the mode selector:
0 = Off
= Cool air
1 = heating capacity (850 W )
2 = Full heating capacity (approximately 1500 W ).
You may set the required temperature in the room using the thermostat regulator. When heating function (1) or (2) is selected, the unit will alternately switch on and off, thus keeping the required temperature.
Note: A more accurate temperature can be set as follows:
Set the thermostat to the maximum, and switch the heating to (1) or (2) . When the required temperature has been reached in the room, turn the thermostat slowly to a lower temperature, until the unit switches off.
If you use the fan in the cool air mode , set the thermostat regulator to the maximum.
After use, move the mode selector to the (0) position and unplug the unit from the mains.

Safety switch against overturning the device:
safety switch against overturning stops operation, when the device is overturned or is placed inappropriate manner that undermines security.

MAINTENANCE AND CLEANING

Warning!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!

The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may damage the unit’s surface!
The air inlet and outlet grilles should be cleaned frequently to ensure proper operation of the unit and to avoid overheating.
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!

TROUBLESHOOTING

The unit is equipped with a safety fuse that cuts off the power supply to the heater, and restores it after it cools down. If this happens in the course of ordinary operation, check the cleanliness of the inlet and outlet grilles, or change location of the unit to improve the air circulation in and around the unit.

SERVICING

Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an expert service centre.

ENVIRONMENTAL PROTECTION

Packaging materials and obsolete appliances should be recycled.
The transport box may be disposed of as sorted waste.
Polyethylene bags shall be handed over for recycling.

Appliance recycling at the end of its service life:

A symbol on the product or its packaging indicates that this product should not go into household waste. It must be taken to the collection point of an electric and electronic equipment recycling facility. By making sure this product is disposed of properly, you will help prevent the negative effects on the environment and human health that would otherwise result from inappropriate disposal of this product. You can learn more about recycling this product from your local authorities, a household waste disposal service or in the shop where you bought this product.

WARRANTY TERMS

Warranty

The manufacturer (or importer) is responsible for ensuring the product complies with the requirements of applicable legal regulations as well as those of the relevant technical standards. Moreover, they are responsible for ensuring the product has the properties the manufacturer described in documents related to the goods or those reasonably expected by the customer
with regard to the nature of the goods or based on advertising produced by the manufacturer, and further they are responsible for ensuring the product is fi t for the purpose proposed by the manufacturer or that a product of the same type is normally used for.

The quality warranty term is 24 months from product takeover by the customer.
The warranty does not apply to wear and tear caused by regular use. The customer shall not be entitled to any warranty claims if, prior to taking the product over, they knew the product contained a defect or if the defect is attributable to the customer.

The warranty specifically does not apply:

if the product installation, operation and service conditions stipulated in the product operating manual have not been adhered to,
to malfunctions caused due to mechanical, heat or chemical damage, short circuit, over voltage or incorrect installation,
to malfunctions caused by an inexpert third-party intervention,
to malfunctions caused by natural disaster,
to malfunctions caused by insufficient or inappropriate maintenance in violation of the operating manual, including malfunctions caused by water and other sediments,
to changes in colour of the heating surface or to scratching of the surface caused as a result of using the products in an unusual manner,
to appearance and functional changes caused by exposure to sunlight, thermal radiation of water and other sediments,
if the service life of certain product parts expires, e.g. for accumulators, bulbs, etc.

The warranty does not apply to any products and services provided along with the product (gifts, promotional articles, etc.).

Filing a complaint

A complaint against a product defect must be filed as soon as identified, yet no later than before the end of the warranty term.

The customer must fi le a product complaint with the dealer from which they have purchased the product, or with any authorised service centre, a list of which is included in the product package, or available at www.my- concept.com.

While fi ling a product complaint, the product must be duly cleaned and securely packed so as to prevent any damage during its transport to an authorised service centre, where relevant, unless the product is delivered in person.

The customer must submit proof of having concluded a purchase contract for the product by producing the receipt.

While fi ling their complaint, the customer must indicate the noted defect and identify the preferred complaint application method.

Complaints processing

As long as the noted defect may be removed, the user has the right to have the defect duly removed free of charge on a timely basis.

Where such a procedure is not reasonable with regard to the nature of the defect, the user may require to be supplied a new defect-free product (replacement), or, where the defect applies to a part of the product only, replacement of the part concerned. However, if replacement of the product or any part thereof is not proportionate with regard to the nature of the defect, especially if the defect can be removed without undue delay, the customer has the right to have the defect removed free of charge.

If the noted defect is not removable, or if the customer becomes entitled to replacement of the product or a part thereof, yet the replacement is not possible, for example due to the product having been sold out, the customer has the right to return the product (withdrawal from the contract).

The customer shall have the right to a new product (replacement) or to replacement of a part of the product even if the defect can be removed, provided they cannot properly use the product due to repeated occurrence of the defect or due to a high number of such defects. In such a case, the customer also has the right to return the product (by withdrawing from the contract).

If the product is not returned (the customer does not withdraw from the contract), or if the customer does not apply the right to a new defect-free product (replacement), to replacement of a part thereof or to repair of the product, they may request a reasonable discount. The customer also has a right to a reasonable discount if a new defect-free product cannot be supplied to them, or if a product part cannot be replaced or the product repaired unless the situation is remedied within a reasonable time limit, or if remedying the situation would create major discomfort on the part of the customer.

The seller, authorised service centre or a staff member authorised by them must decide about each complaint immediately or within three business days in complicated cases. This term does not include a reasonable period of time, depending on the type of product concerned, required for the defect to be assessed by an expert. A complaint, including defect removal, must be dealt with without any undue delay, yet no later than within 30 calendar days of the complaint fi ling date, unless the seller and the customer agree on a later deadline.

On returning the product (withdrawing from the contract) the customer must return any accessories and documents supplied along with the product.

The customer does not have the right to keep the defective parts and components of the product replaced as part of a repair of the product.

This shall be without prejudice to any other rights the customer may have in relation to the purchase of the product.

Remark: Complaints against products damaged in transport are governed by the carrier’s complaints procedure.

Manufacturer

Czech Republic
tel.: +420 465 471 433
fax +420 465 473 304
Company ID No. 13216660
email: servis@my-concept.cz
www: www.my-concept.com