CUR AQUA 007130 Heated Towel Rail Instruction Manual

CUR AQUA 007130 Heated Towel Rail

SAFETY INSTRUCTIONS

• The product is not intended to be used by persons (children or adults) with any form of functional disorders, or by persons who do not have sufficient experience or knowl­edge on how to use it, unless they have received instructions concerning the use of the product from someone who is responsible for their safety. Keep children under supervi­sion to make sure they do not play with the product.

• The product is intended to be used in a bathroom or laundry room etc. Do not use the product outdoors.

• Do not place the product near a bathtub, shower, or sink, etc. that contains water or any other liquid.

• The product is intended to be used to dry wet textiles.

• Keep the product under careful supervision when it is used by, or near children.

• Pull out the plug when the product is not in use.

• Do not use the product if the power cord or plug is damaged, if it is not working properly after it has been
  d rapped, or if the product is damaged in any other way. Take the product to an au­thorised service center to be checked, repaired or adjusted.

• Do not route the power cord under carpets etc.

• Place the power cord so that there is no risk of treading on it, or tripping over it.

• Pull out the plug to cut off the power supply to the product.

• Never insert foreign objects into the ventilation or outlet open­ings – risk of electric shock, fire, and/or material damage.

• Do not use this product in explosive environments, e.g. near flammable liquids, gases or dust.

• The product must only be used for its intended purpose and in accordance with these instructions. Any other use could result in fire, electric shock or personal injury.

IMPORTANT:

• The product must only be used in an upright position.
• Service must only be carried out by an authorized service center.
• Do not place the product directly below a power outlet.

ELECTRICAL SAFETY

New installations and extensions to existing systems should always be carried out by an authorised electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords and light sockets. Incorrect installation can result in fatal injury and the risk of fire.

SYMBOLS

TECHNICAL DATA

INSTALLATION

WALL MOUNTING

1. Mark out the screw holes on the wall. Drill holes in the wall and insert plugs.
2. Fit the bracket with one screw in the nut on the towel rail.
3. Fit the wall bracket with the screws.
4. Fit the switch box with concealed cables and the switch.

FIG. 1 / FIG. 2

WARNING!
The towel rail must be installed so that the power switch or control cannot be reached by a person in a bathtub or shower.

SWITCH BOX

1. Fit the switch box on the towel rail.

2. Remove the side cover.
   FIG. 3

3. Pull the power cord through the bottom of the switch box, leaving a suitable length sticking out.
   FIG. 4

4. Screw the switch box firmly onto the vertical tube on the towel rail.
   FIG. 5

Terminals

1. Put the terminal block in the switch box and check the markings.
2. Connect the neutral, live and® wires on the power cord to the corresponding terminals.
3.  Replace the cover and screw tight.
4. Fit the cover plate on the back to conceal the power cord.

FIG. 6

WARNING!
The installation must be carried out by an electrician or other qualified personnel to ensure safe use.

HOW TO USE

Power switch

• Put the power switch in the on position (1) (the status light goes on). The product starts.
• Put the power switch in the off position (0) (the status light goes off). The product is switched off.

Note: Switch off the towel rail and pull out the plug when it is not in use.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>