GoGEN MAXIPREHRAVAC B USB/MP3/CD/RADIO PORTABLE PLAYER Instruction Manual

: June 5, 2024
: Gogen

GoGEN MAXIPREHRAVAC B USB/MP3/CD/RADIO PORTABLE PLAYER

Thank you for buying this product. Please read through these operating instructions, so you will know how to operate your equipment properly. After you finished reading the instructions manual, put it in a safe place for future reference.

CAUTION

Use of controls or adjustment or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Avoid installing the unit in locations described below:
1. Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, or other equipments that radiate too much heat.
2. Places subjected to constant vibration.
3. Unventilated or dusty places.
4. Humid or moist places.
Operate buttons and switches as instructed in the manual.
Before turning on the power for the first time, make sure that the power cord is properly installed and the voltage switch is correctly set.
Store your CD or other devices in a cool area to avoid damage from heat.

DANGER
Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

This Compact Disc player is classified as a Class 1 LASER PRODUCT. THE CLASS 1 LASER PRODUCT label is located on the rear exterior.

WARNING:

Remove batteries if exhausted or if they will not be used for a long period.
The incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore:
Do not mix battery types, e.g. alkaline with zinc carbonate.
When inserting new batteries, replace all batteries at the same time.
The apparatus is used in moderate climates.
The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
The main plug is used as the disconnect device, the disconnect device shall remain readily operable.

NAMES OF CONTROLS

HANDLE
USB PORT
TUNING CONTROL
DIAL SCALE
CD COMPARTMENT
FUNCTION SWITCH
VOLUME CONTROL
CD SKIP/SEARCH FORWARD BUTTON
CD SKIP/SEARCH BACKWARD BUTTON
FOLD.-/-10 BUTTON
CD PROG./P-MODE BUTTON
CD PLAY/PAUSE/STANDBY BUTTON
CD STOP/USB BUTTON
FOLD.+/+10 BUTTON
SPEAKERS
POWER INDICATOR
LCD DISPLAY
FM STEREO INDICATOR
FM TELESCOPIC ANTENNA
BATTERY COMPARTMENT
AC SOCKET
MIC JACK
AUX IN JACK

LOCATION OF CONTROLS

GoGEN-MAXIPREHRAVAC-B-USB-MP3-CD-RADIO-PORTABLE-PLAYER-
fig1

POWER SOURCE

This unit is designed to be operated on AC/DC.

AC OPERATION
Plug the tail of AC power cord into AC socket on unit and the plug into household AC outlet. The batteries will be automatically disconnected.

DC OPERATION
Open the BATTERY COMPARTMENT DOOR. Install 6 pcs UM-2/C size batteries (not included) into compartment. Please follow correct polarities as indicated.

CAUTION
Remove batteries if they are flat or not being used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.

BASIC FUNCTION

SWITCHING ON THE UNIT
Set the FUNCTION switch to CD/MP3/USB/AUX or RADIO.
NOTE: In CD/MP3/USB/AUX mode, when the unit is not providing the main function for
15 minutes, the unit will automatically switch into standby mode.
ESD hints – The product maybe reset or not reset to operation of control due to electrostatic discharge, just switch off and reconnect again.

ADJUSTING VOLUME
Rotate the VOLUME CONTROL clockwise or counterclockwise to increase or decrease volume.

RADIO OPERATION

Slide the FUNCTION switch to RADIO position, the POWER indicator will illuminate.
Tune to required station by rotating the TUNING KNOB.
Rotate the VOLUME CONTROL to comfortable volume level.
Extend the TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting. Note: The FM STEREO indicator will be on if you are receiving FM stereo program.
Turn off the radio by switching the FUNCTION switch to „OFF“ position

CD/MP3 OPERATION

Discs for playback
This system can playback all digital audio CD/MP3/WMA discs, finalized digital audio CD-Recordable (CD-R) discs and finalized digital audio CD-Rewritable (CD-RW) discs.

LOADING A DISC

Set the FUNCTION switch to CD/MP3/USB position.
Open the CD door. “OP” will be shown on the display.
Place an audio CD into the tray with the label side facing up.
Close the CD door, the total number of tracks will appear in the display.
To remove the CD, open the CD compartment lid, grasp the CD by its edges, and carefully take it out.

Note:

To ensure good system performance; wait until the disc tray completely reads the disc before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will show

PLAYING A DISC

Press the PLAY/PAUSE/STANDBY button on unit or on remote control to start playback. The playback starts from track 1, “►” will appear on the display.
To interrupt playback, press the PLAY/PAUSE/STANDBY button, “►” and the track number will flash on the display.
To resume playback, press the PLAY/PAUSE/STANDBY button again.
To stop playback, press the STOP/USB button, the total number of tracks would appear in the display.

SELECTING A DESIRED TRACK/PASSAGE

To select a desired track

Press the CD SKIP/SEARCH NEXT/BACK button repeatedly in stop mode or during play until the desired track appears on the display.
Press the PLAY/PAUSE/STANDBY button to start play.

To search for a particular passage during playback (track scanning at high speed)
Press and hold the CD SKIP/SEARCH NEXT/BACK button to scan the current playing track at high speed until desired point passage, and then release the button.
Playback will start again from this point.

To select a song which track number exceeds 10 (for MP3 disc only)
To select a song/track which number exceeds 10, Press the FOLD.+/+10 button each time to skip forward/backward 10 tracks, then press the CD SKIP SEARCH NEXT/BACK button to select desired track. For example: to select the 17th track, press FOLD.+/+10 button, and then the CD SKIP SEARCH NEXT button six times immediately.

To Select A Desired Folder (for MP3 disc only)
(if the MP3 disc contains more than one folder)
To skip to the desired folder during playback, press and hold the FOLD.+/+10 or FOLD.-/-10 button for about 2 seconds to skip to next/previous folder.

PROGRAM TRACKS

Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3 99 tracks can be stored in the memory in any order.

In stop mode, press the PROG./P-MODE button, the PROG will flash and the P01 indicator will be on.
Press the CD SKIP/SEARCH NEXT/BACK button to select the first desired track to be programmed.
Press the PROG./P-MODE button to enter. The display changes to show P02.
Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
Press the PLAY/PAUSE/STANDBY button to start playback from the first programmed track.
Press the STOP/USB button to stop program playback.

To Erase the Memory (Program)
To clear the program, you have two options:

Press the STOP/USB button when the disc is stopped, or
Open the CD compartment lid, program will be erased.

REPEAT

You can play one track or all tracks on the disc repeatedly.

To Repeat a Single Track

Press PROG./P-MODE button once in play mode, “ ” will flash on the display. The current track will be played over and over again till you press the STOP/USB button.
To cancel repeat play, press PROG./P-MODE button control until “ ” disappears from the display.

To repeat all the Tracks

Press PROG./P-MODE button until the “ ” shows steady on the display, all tracks on the disc will be played over and over again till you press the STOP/USB button.
To cancel repeat play, press the PROG./P-MODE button control until “ ” disappears from the display.

To repeat the folder (only for MP3 disc which contains more than one folder)

Press the PROG./P-MODE button until “ FOLDER” show steady on the display, the current folder will be repeated over and over again till you press the STOP/USB button.
Press the PROG./P-MODE button once to cancel.

RANDOM PLAY

Press the PROG./P-MODE button in play mode till the “RDM” shows steady on the display, the random play will start from next track automatically(or press CD skip forward button), until all tracks are played over and then stop. Press the PROG./P-MODE button once to cancel.

INTROSCAN PLAY (FOR CD DISC ONLY)

Press the PROG./P-MODE button in play mode till the “INTRO” shows steady on the display, the unit will start to play the first 10 seconds of music of each track, until all tracks are played over and then stop. Press the PROG./P-MODE button once to cancel.

USB OPERATION

Set the FUNCTION button to “CD/MP3/USB” position, press and hold the STOP/USB button for about 2 seconds to enter the USB mode.
Connect the USB to the USB INPUT. The LCD will show the total number of tracks stored in the USB. The unit will start playback from track 1 after reading finished.
Press PLAY/PAUSE/STANDBY button to pause and resume playback.
Press the STOP/USB button to stop playing. The display will show total number of USB and STOP.
Proceed repeat play (repeat 1- repeat folder – repeat all)/program play/skip next and back operation as described in above “CD/MP3 OPERATION”.

CAUTION:
Do not use any USB extension cable for connecting the USB device to avoid any conflict.

AUX-IN OPERATION

This unit has provided special AUX-IN jack, through this jack other audio sources can be connected to this unit and be amplified.

Set the FUNCTION switch to CD/MP3/USB/AUX IN position.
Connect the audio cable into the AUX-IN jack and the other end connect to the AUDIO OUT jack of the external audio source. The unit will change to AUX mode automatically.
Adjust the volume of the main unit to your desired level.
Press PLAY of the external audio source (eg.MP3 player) to start playback.

MICROPHONE OPERATION – KARAOKE

This unit provides one 3,5 mm Mic Jack for Karaoke function. Connect 3,5mm microphone to the mic jack, then turn on the microphone. The microphone is available in all modes.

COMPACT DISC MAINTENANCE

1. Always use a compact disc bearing the mark as shown.
2. Notes on handling discs
• Removing the disc from its storage case and loading it.
• Do not touch the reflective recorded surface.
• Do not stick paper or write anything on the surface.
• Do not bend the disc.
3. Storage
• Store the disc in its case.
• DO not expose discs to direct sunlight or high temperatures, high humidity or dusty places.
4. Cleaning a disc
• Should the disc become soiled, wipe off dust, dirt and fingerprints with a soft cloth.
• The disc should be cleaned from the center to the edge.
• Never use benzene, thinners, record cleaner fluid or anti-static spray.
• Be sure to close the CD door, so the lens is not contaminated by dust.
• Do not touch the lens.

SPECIFICATIONS

GENERAL

Power Source AC 230V~ 50 Hz
DC 9 V 1,5 V UM-2/C x 6 pcs
Power consumption 14 Watts
Standby Power Consumption < 0,5 Watts
Weight Approx. 1,2 kg
Dimensions Approx.214 mm (L) x 204 mm (W) x 110 mm (H)
Operation temperature + 5 °C to + 35 °C

RECEIVER SECTION

Receiving Bands FM ST.
Tuning Range FM: 88 – 108 MHz

COMPACT DISC SECTION

Optical Pickup 3-Beam Laser
Frequency Response 100 Hz – 16 KHz

AUDIO SECTION

Power output 0,8 Watts x 2 (RMS)
AUX Jack 3,5 mm
MIC Jack 3,5 mm

ACCESSORIES

Instruction Booklet , AC Cord

SPECIFICATIONS ARE SUBJECT TO CHANGE FOR CONTINUOUS IMPROVEMENT, WE RESERVE THE RIGHTS TO MODIFICATION WITHOUT PRIOR NOTICE.

WARNING: DO NOT USE THIS PRODUCT NEAR WATER, IN WET AREAS TO AVOID FIRE OR INJURY OF ELECTRIC CURRENT. ALWAYS TURN OFF THE PRODUCT WHEN YOU DON’T USE IT OR BEFORE A REVISION. THERE AREN’T ANY PARTS IN THIS APPLIANCE WHICH ARE REPARABLE BY CONSUMER. ALWAYS APPEAL TO A QUALIFIED AUTHORIZED SERVICE. THE PRODUCT IS UNDER A DANGEROUS TENTION.

TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.

Disposal of old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems).

This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product.