concept RO 3107 Oil Filled Radiator Heaters Instruction Manual

June 5, 2024
concept

concept RO 3107 Oil Filled Radiator Heaters Instruction Manual
concept RO 3107 Oil Filled Radiator Heaters

ACKNOWLEDGEMENT

Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its service life.

Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe place for future reference. Make sure other people using the product are familiar with these instructions.

Technical parameters

 | RO 3107| RO 3109| RO 3111
Voltage| 230 V ~ 50 Hz| 230 V ~ 50 Hz| 230 V ~ 50 Hz
Power input| 1500 W| 2000 W| 2300 W
Number of sections| 7| 9| 11

IMPORTANT SAFETY PRECAUTIONS:

  • Make sure the mains voltage corresponds to the values stated on the product’s rating plate. Do not connect the unit to adapter plugs or extension cables.
  • Do not use this unit with any programmable device, timer, or any other product turning the unit on automatically; if the unit is covered or installed improperly, a fire may occur.
  • Place the unit only on a stable and heat-resistant surface, out of the reach of other heat sources.
  • Do not leave the unit unattended while it is turned on or even only plugged into the wall outlet.
  • When plugging the unit into the wall outlet and disconnecting it from power network the mode selector has to be switched to 0 (off).
  • When disconnecting the unit from the wall outlet, never pull the power cord. Grasp the plug and disconnect it by pulling.
  • Do not install the unit just under the wall outlet.
  • The unit shall be installed in such a way that the plug remains accessible at all times.
  • Keep the minimum safe distance of at least 100 cm between the unit and flammable materials, such as furniture, curtains, lace, blankets, paper, clothing, and so on.
  • Keep a safe distance of the unit from other objects, 50 cm at minimum.
  • WARNING! The temperature on the unit‘s surface can reach more than 80°C during operation. Do not touch the hot parts.
  • Do not allow children or unskilled people to handle the unit. Use the unit out of the reach of these individuals.
  • Person with limited movement capacities, reduced sensory perception, insufficient mental capacity or those who are unaware of the proper handling shall use the product only under the supervision of a responsible, aware person.
  • Take extra care when using the unit near children.
  • Don’t let anyone use the unit as a toy.
  • Do not cover the unit. There is a risk of overheating. Do not use the unit for drying cloth.
  • Do not hang anything above or in front of the unit.
  • Use the unit only as described in this operating manual.
  • The unit may be operated in the upright position only.
  • Do not use the unit near a shower, bathtub, washbowl, or swimming pool.
  • Do not use the unit in an environment with explosive gases or flammable substances (solvents, vanishes, adhesives, etc.).
  • Turn the unit off, unplug the power cord from the wall outlet, and let the unit cool before cleaning and after use.
  • Keep the unit clean. Do not let any objects enter the unit through the grille. This could cause a short circuit, damage to the unit, or fire.
  • Do not use abrasive or chemically aggressive substances for cleaning the unit.
  • Never use an appliance with a damaged power cord or plug. Contact an authorized service center immediately to have defective components repaired or replaced.
  • Do not use the unit if it does not operate properly, if it has been dropped, damaged or exposed to any liquids. Take the unit to an authorized service center for testing and repair.
  • The unit is not designed for outdoor use.
  • The unit is suitable for domestic use only. It is not designed for commercial operation.
  • Do not touch the unit with wet or damp hands.
  • Do not immerse the power cord, plug, or appliance into water or any other liquid.
  • The unit shall not be mounted on the wall.
  • The unit shall not be used in any means of transport.
  • Do not repair the appliance yourself. Contact an authorized service center.

Failure to follow the manufacturer‘s instructions may cause refusal of warranty repair.

  1. This appliance is not intended for use by persons (including children)  with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
  2. Children should be supervised to ensure that they do not play with the appliance.

PRODUCT DESCRIPTION

PRODUCT DESCRIPTION

  1. Radiator sections
  2. Carrying handle
  3. Thermostat regulator
  4. Mode selector
  5. Supply cable holder
  6. Wheels

ASSEMBLY

It is necessary to fix the wheels on the bottom side prior to the first use.
The unit shall not be used without properly installed wheels.

  1. Place the unit on a stable surface (desk or floor).
    Check to make sure that the unit is undamaged, e.g. by fall or transport.
    Do not use a damaged unit.

  2. Screw the wheels in the bottom strips, and lace the curved end of the yoke in the opening in each strip (Fig. 1).

  3. Mount the set onto the bottom part of the unit (Figs. 2, 3).ASSEMBLY

  4. Fasten the yoke using a winged nut (Fig. 4) in order to stabilize the unit and prevent it from turning over.
    ASSEMBLY

NOTE
When turning the unit on for the first time or after prolonged downtime, the unit may release a slight smell. This smell will vanish after a short time.

OPERATING INSTRUCTIONS

  1. Place the unit on a stable surface or floor to avoid tipping over.
  2. Uncoil the supply cable.
  3. Connect the power cord plug to the wall outlet.
  4. Select the required function using the mode selector (Fig. 5)
3 Mode selector RO 3107 RO 3109 RO 3111
0 – Off. 0 W 0 W 0 W
1 = low heat 600 W 800 W 1000 W
2 = medium heat 900 W 1200 W 1300 W
3 = full heating capacity 1500 W 2000 W 2300 W
  1. You may set the required temperature in the room using the thermostat regulator. When heating function 1, 2, or 3 is selected, the unit will alternately switch on and off, thus keeping the required temperature.
    Note: More accurate temperature can be set as follows:
    Set the thermostat to maximum, and switch the heating to 1, 2, or 3. When the required temperature is reached in the room, turn the thermostat slowly to a lower temperature, until the unit switches off.

  2. After use, move the mode selector to the 0 position and unplug the unit from the mains.

CLEANING AND MAINTENANCE

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may damage the unit’s surface!
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!

REPAIRS & MAINTENANCE

Any extensive maintenance or repair requiring access to the internal parts of the product shall be performed by an authorized service center.

ENVIRONMENTAL PROTECTION

  • Packaging materials and obsolete appliances should be recycled.
  • The transport box may be disposed of as sorted waste.
  • Polyethylene (PE) bags shall be handed over for recycling.

Recycling at the end of the service life:
A symbol on the product or its packaging indicates that this product should not be disposed of as household waste. It must be taken to the collection point authorized for recycling electric and electronic equipment. By making sure this product is disposed of properly, you will help prevent negative effects on the environment and human health that would otherwise result from inappropriate disposal of this product. You can learn more about recycling this product from your local authorities, a household waste disposal service, or in the shop where you purchased this product.

Jindřich Valenta – ELKO Valenta Czech Republic, Vysokomýtská 1800,
565 01 Choceň, Tel. +420 465 471 400, Fax: 465 473 304, www.elkovalenta.cz

Elko Valenta Slovakia s. r. o., Kasárenská 396/14, 911 05 Trenčín
Tel.: +421 326 583 465, Fax: +421 326 583 466, www.elkovalenta.sk

Elko Valenta Polska Sp. Z. o. o., Ostrowskiego 30, 53-238 Wroclaw
Tel.: +48 71 339 04 44, Fax: 71 339 04 14, www.elkovalenta.pl

SC MEGAVISION SRL, P-TA UNIRII 1 SECT. 3, Bucuresti, Romania
Tel.: 30.30.173, Fax: 30.30.118

Logo

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals