Concept CP3000 Steam Cleaner User Manual

Steam Cleaner
User Manual

ACKNOWLEDGMENT
Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its service life.
Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe place for future reference. Make sure that any persons handling the vacuum cleaner are also familiar with this Operating Manual.

Technical parameters

Voltage| 220-240 V ~ 50/60 Hz
Input power| 1600 W
Noise level| <80 dB (A)

IMPORTANT SAFETY INSTRUCTIONS

Do not leave the appliance unattended when plugged into the mains. When using an electric appliance, the following precautions should always be followed:

• Do not leave the appliance unattended when plugged into the mains. Always disconnect the device from the mains before maintenance or if it is not in use.

• Do not use outdoors or on wet surfaces.

• Do not put the device in operation when in the upright or locked position.

• Do not let the device run while it is stationary. Keep the device moving when it is in use.

• Do not allow the device to be used as a toy. Close attention is necessary when the device is used near children.

• Use the device only as described in this manual. Always use only the manufacturer’s recommended attachments.

• Always unplug the device from the mains when filling with water, emptying it or if the appliance is not in use.

• Do not use the device if the cord or plug is damaged. If the device does not work as it should, it may have been dropped, damaged, left outdoors, or immersed in water, contact an authorized service center.

• Do not pull on the power cord, do not carry the device by holding the power cord, do not use the cable as a handle, do not close the cable in the door, or rotate it around sharp edges or corners.

• Keep the cord away from heat sources.

• Do not run the device over the cord.

• To unplug the appliance, grasp the power plug and pull it out. Do not pull the power cord.

• Do not touch the plug or the device with wet hands.

• Do not use the device without the water tank cap in place.

• Do not use the steam function with an empty water tank.

• Empty the water tank when the steam cleaner is not in use.

• Do not put any object into the device’s openings. Do not use the device with any opening blocked; keep it free of dust, lint, hair, and anything that may reduce performance.

• Contact the manufacturer/retailer (see warranty and service terms). Incorrect installation and repair can cause electrical shock to the user.

• Keep your hair, clothing, fingers, and all parts of the body away from openings and moving parts of the device.

• Do not ever aim the steam cleaner on yourself or another person. Steam is very hot and can cause burns.
  Do not use the appliance in the presence of explosive or flammable vapors.

• Turn off all controls before unplugging.

• Do not use the device to clean hot or smoking objects, such as cigarettes, matches, or hot ash.

• Use extra care when cleaning the stairs.

• Do not use the device to clean up flammable or combustible liquids, such as gasoline or lighter fluid. Do not use the device areas where such liquids may be present.

• Do not use to pick up flammable or combustible liquids, such as gasoline or lighter fluid, or use it in areas where they may be present.

• Do not use the device in an enclosed space where flammable, explosive or toxic vapors may be released from oil base paint, diluent, moth preparations, or in areas where flammable dust is present.

• Use of chemicals may damage the appliance and you will lose your warranty.

• Do not use the device to clean up toxic solutions such as chlorine bleach, drain cleaner, gasoline, etc.

• Never put additives (such as perfume, stain remover or products containing alcohol) in water as they may damage the steam cleaner or make it dangerous to you.

• Ensure that the water tank cap has been properly screwed down before use.

• Do not touch hot parts of the device. It is normal for the device to get hot during operation.

• Do not use the device to clean clothes while being worn.

• The impact of the steam may have an adverse effect on some materials. Always test the steamer on a small area to determine if the particular material is suitable for treatment with the steam cleaner.

• Never aim the device at people, animals or plants (risk of scalding!).

• Do not aim the appliance at electrical systems or wires.

• Do not repair the appliance yourself. Contact an authorized service center.

• This appliance may be used by children 8 years of age and older and by persons with physical or mental impairments or by inexperienced persons if they are properly supervised or have been informed about how to use the product in a safe manner and understand the potential dangers. Children must not play with the appliance. This appliance may be cleaned by children 8 years of age and older if they are properly supervised. Keep this appliance and the power cord out of reach of children younger than 8 years of age.

If you fail to follow the manufacturer’s instructions, repairs cannot be recognized as a warranty.

Household use only
The steam vacuum cleaner with a mop is designed for use on hard surfaces such as ceramic, glass, stone, marble, concrete, vinyl, linoleum, and sealed hardwoods and carpet. The appliance is not designed for use on fine silks, leather, velour, or other delicate steam-sensitive materials such as waxed polished furniture, very thin plastics, unsealed hardwoods, ceilings, drywall, and exterior paint of automobiles, electronics, or items using electricity.
NOTE:
The heat and steam may not be suitable for some steam or heat-sensitive floor types. If unsure, we recommend checking the use and care instructions from the floor manufacturer and testing on an inconspicuous area prior to use.

PRODUCT DESCRIPTION

1. Hook for attaching a power cord
2. Lever for releasing the water tank
3. Water tank
4. Replaceable hard water filter
5. Dirt tank
6. Steam trigger
7. Power On/Off button
8. Charging indicator
9. Vacuum feature On/Off button| 10. Vacuum feature indicator
11. Steam level button (Low/High level)
12. Steam-ready indicator
13. Mop pad holder
14. Microfiber mop pad
15. Power cord
16. Suction head
17. suction inlet
18. Carpet glider
---|---

OPERATING INSTRUCTIONS

Assembly

1. Align the connector tab at the bottom of the handle with the receiving port on top of the unit and push until it “snaps” together.

2. Lock – Place your foot on the head and gently lean the handle back to release it for use. Return the handle to the upright position to engage the lock.

3. Power Cord Release – To loosen the cable, rotate the hook by 45 ° and remove the cable.

4. Easy Power Cord Storage – Rotate the hook to the vertical position, and wrap the cable around the upper and the lower hook located under the handle.

5. Carrying Handle – The handle is located on the back of the appliance body for easy lifting, carrying, and use on stairs.

6. Microfibre Mop Pad Holder
   A. To attach the mop pad holder, place the head onto the microfiber steam mop pad holder.
   B. To remove the mop pad holder, place your foot on the release pedal and lift the appliance.
   Use NOTE: For vacuuming, do not use the steam mop pad.

7. Press the „VAC“ button to start vacuuming.

8. To empty the dirt tank, grasp the dirt tank handle, press the release button, and remove the tank.

9. Press the empty button on the front of the tank, open it and empty it.

10. Put the dirt tank back.
    NOTE: Do not use the device without the dirt tank.

Steam Mop Operation

|
---|---

1. Attach the mop pad to the holder.

2. To attach the mop pad holder: place the front of the steam cleaner on the holder, align the foot pedal to the center of the head and gently press the head to the holder until
   it “snaps” together.
   NOTE: Never use the steam mop without the microfiber steam mop pad in place.

3. For carpet cleaning only, proceed according to step and fit the carpet glider on the head. If the steam cleaner is used on hard floors, remove the carpet glider.

4. Grasp the water tank release lever and pull forward and upward to remove the water tank.

5. Remove the cap from the bottom of the water tank and fill it with water. Make sure the cap sealing is in its place.
   Screw the cap and put the water tank back.
   NOTE: Do not attempt to use a steam mop with an empty water tank!

6. Turn the power switch on, (the power indicator will be on).

7. Press the steam level button, to adjust the steam level.
   The default is maximum and can be adjusted to minimum.

8. When the MIN/MAX indicator stops flashing (when it lights steadily), press and hold the steam trigger (on the inner side of the handle) to start steam cleaning.

9. When the Steam Mop stops emitting steam turn the power OFF and refill the water tank.

10. Steam Settings:
    Tiles/Stone – Maximum
    Sealed wooden floor – Minimum
    NOTE:
    When the microfiber steam mop pad becomes too wet or dirty, replace it with a clean cloth.

USE & MAINTENANCE

Maintenance

1. When finished steam cleaning, ensure to turn off the appliance and unplug from the mains.
2. Empty the remaining water from the water tank.
3. Remove the mop pad. Microfibre pads can be washed in a washing machine, up to 100 °C. For heavily soiled pads, soak them in warm water with detergent or a mild stain remover beforehand. Allow the pods to dry completely before storing.
   NOTE: DO NOT USE FABRIC SOFTENER

Changing the Water Filter
The water filter will help filter minerals that reduce the effectiveness of the steam cleaner. Depending on water conditions and use frequency, the filter should be replaced every 80-100 hours.
The steam mop will work using ordinary tap water. However, if you live in an area with hard water, the minerals that form the hard water will reduce the life of the water filter installed in the steam mop. This will eventually allow deposits to build up on the heating element of the appliance, which will reduce its performance. To prolong the life of your filter and heater, we recommend using distilled or de-mineralized water.

WARNING: Unplug the cord from the mains before maintenance.

Outlet Filter Maintenance
Push the filter cover tab down and remove it from the appliance body. Remove the filter from the back of the cover and wash it until it is completely clean. Before returning the filter, allow it to dry thoroughly. Put the filter cover back into the appliance – align the bottom of the cover with the appliance body and rotate it to its place. It snaps when it is in the right place.

Dirt tanks
Remove the filter unit from the dirt tank. Turn the coarse outer filter counterclockwise and release it. Turn the main filter counterclockwise and release it. Remove the outer foam filter from the bottom of the main filter. Clean all the filters and let them dry properly before assembly. Place the foam filter on the bottom of the main filter. Put the main filter back into the case. Turn the main filter clockwise until it locks into place. Place the foam filter on the bottom of the main filter. Put the main filter back into the case. Turn the main filter clockwise until it locks into place. Place the coarse outer filter on the main filter and align the unlock symbol with the arrow symbol on the coarse filter. Turn the coarse outer filter clockwise until it snaps and locks into place. Return the filter unit back to the dirt tank. Place the dirt container back into the appliance body.

TROUBLESHOOTING

Function problems sometimes may seem serious, but they can often be easily solved. With a help of this table, you are able to solve some of the problems that may occur. Any further maintenance should be performed by an authorized service center.

switch the appliance on.
The electrical socket is faulty.| Check the socket by unplugging the steam cleaner and plugging it into a different electrical socket.
The vacuum feature does not function.| The dirt tank is full.| Empty the dirt tank.
Dirt has clogged the inlet.| Remove dirt from the inlet.
The filter needs cleaning.| See the “Filter Maintenance” section. Contact the Authorised Concept Service Centre.
Very low or no steam is emitted when the steam cleaner is on.| The water tank is empty.| Make sure that the water tank is filled.
The trigger has not been pressed properly.| Press the trigger and activate the pump.
The trigger has not been selected.| Make sure that the steam feature is selected.
The steam-ready indicator does not shine.| Wait for the indicator to light up. If it does not turn on after 1 minute. Contact Authorized Concept Service Centre.
Hard Water Filter needs changing.| See “Changing the Hard Water Filter”.
The steam cleaner still does not operate
properly.| Check all the above points.| Contact Authorized Concept Service Centre.

PURCHASABLE ACCESSORIES
All accessories and spare parts can be purchased separately.
When ordering, please provide the model number of your appliance, indicated on the nameplate at the bottom of the product.

SERVICE
Maintenance of a more extensive nature or repair, which requires interference with the internal parts of the product, must be performed by a professional service.

ENVIRONMENTAL PROTECTION

• Recycle packaging materials and old appliances rather than throwing them away.
• The appliance box may be disposed of at a sorted waste collection point.
• Deliver polyethylene (PE) plastic bags to a waste collection facility for recycling.

Recycling the product at the end of its service life
A symbol on the product or its packaging indicates that this product should not be disposed of as household waste. It must be taken to a collection point authorized for recycling electric and electronic equipment. By making sure this product is disposed of properly, you will help prevent negative effects on the environment and human health that would otherwise result from the inappropriate disposal of this product. You can learn more about recycling this product from your local authorities, a household waste disposal service, or in the store where you purchased this product.

This product meets all the basic EU regulation requirements that relate to it.
Changes to the text, design, and technical specifications may occur without prior notice and we reserve the right to make these changes.

Jindřich Valenta – Concept Czech Republic
Vysokomýtská 1800, 565 01 Choceň
Tel. +420 465 471 400, Fax: +420 465 473 304
www.my-concept.cz| ELKO Valenta – Slovakia, s.r.o.
Hurbanova 1563/23, 911 01 Trenčín
Tel.: +421 326 583 465, Fax: +421 326 583 466
www.my-concept.sk
---|---
Elko Valenta Polska Sp. Z. o. o.
Ostrowskiego 30, 53-238 Wroclaw
Tel.: +48 71 339 04 44, Fax: 71 339 04 14
www.my-concept.pl| Verners VT Ltd.
Piedrujas iela 5a, Riga, Latvia
Tel. + 371 67021021, fakss + 371 67021000
e-pasts: info@verners.lv, www.verners.lv

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>