WMF 0415120011 Lono Crepe Maker User Manual
- June 3, 2024
- WMF
Table of Contents
WMF 0415120011 Lono Crepe Maker
Appliance assembly
- Crepe plate
- Temperature controller
- Crepe spatula
- Batter spreader
- Basic device
Important safety information
- The appliance can be used by children older than 8 years of age as well as by people with limited physical, sensory or mental capabili-ties and persons lacking experience and/or lacking knowledge, if they are supervised or have received instructions on how to use the appliance safely and have understood the resulting risks.
- Children must not play with the appliance.
- Children must not clean or maintain the appliance unless they are older than 8 years of age and are supervised.
- Keep the appliance and its connection cable out of reach of chil-dren under 8 years of age.
- If the appliance’s connection cable is damaged, it must be replaced by the manufacturer’s central customer service department or by a similarly qualified person. Improper repairs may put users at serious risk.
- The appliance must not be operated via an external timer or remote control.
- Clean all parts immediately after use and remove any food residue straight away.
- Follow the instructions in the “Cleaning and care” section.
- The appliance is designed for indoor household use only.
- This appliance is designed for use in households and similar envi-ronments, such as:
- Staff kitchen areas in shops, offices and other commercial environments
- Farmhouses
- By guests at hotels, motels and other residential facilities
- At bed-and-breakfast establishments.
The appliance is not intended for purely commercial use.
Before use
Read the instruction manual carefully. It contains important information about the use, safety and maintenance of the appliance. It should be kept in a safe place and passed on to any subsequent users. The appliance may be used only for the intended purpose in accordance with these instructions for use. The safety precautions must be observed during use.
Technical data
- Mains voltage : 220–240 V~, 50–60 Hz
- Power consumption : 1,370–1,630 watts
- Protection class : I
Additional safety information
- The appliance should be connected only to earthed wall sockets that have been installed in accord-ance with the regulations. The power cable and plug must be dry.
- The connection cable must not come into contact with hot appliance parts.
- Only use an extension cable if it is in perfect condition. Make sure you use enough cable and that it is safely routed.
- To operate the appliance, it must be positioned unobstructed on a table and not up against a wall or in a corner.
- Place the appliance on a flat, solid surface.
- Do not place the appliance on delicate surfaces (glass table, tablecloth, varnished furniture, etc.) or soft surfaces.
- Stop using the appliance and/or pull the mains plug out of the socket immediately if:
- The appliance or the mains cable is damaged
- You suspect that the appliance may be defective following a fall or similar incident. In such cases, arrange for the appliance to be repaired.
- Caution! The appliance gets hot! Risk of burns! Do not transport the appliance when it is hot.
- Warning : When the appliance is switched on, its touchable surfaces can get very hot and they also remain hot even after the appliance has been switched off!
- Always switch the appliance off after use, pull the mains plug out of the socket and allow the appliance to cool down completely before removing and cleaning the crepe plate (1).
- Never operate the appliance without the crepe plate, otherwise the glowing heating element is exposed.
- Do not place kitchen utensils on the cooking surface of the appliance.
- Do not leave the appliance unattended.
- Pull out the mains plug:
- If the appliance malfunctions during use
- Before cleaning and care
- After use
- Do not immerse the appliance in water to clean it.
- We accept no liability for any damage caused as a result of misuse, incorrect operation or improper repairs. Warranty claims are likewise excluded in such cases.
- The appliance is not intended for commercial use.
Use
The WMF Lono crepe maker allows you to prepare sweet or savoury crepes to your own individual taste.
Setting up and connecting
- Remove all packaging from the appliance.
- Clean the appliance (see chapter „Cleaning and care“).
- Set up the appliance on a stable and level surface near to a plug socket.
Initial operation
Before using the appliance for the first time, clean the crepe plate (1), crepe spatula (3) and dough spreader (4) in hot water using washing-up liquid and dry carefully. Then add a few drops of oil to some kitchen towel and rub onto the plate. Position the crepe plate (1) correctly on the basic device (5). Insert the mains plug into the socket, the LED ring on the temperature dial (2) is lit up white. To pre-heat the crepe plate (1), set the temperature controller (2) at the highest setting for around 10 minutes. During the heating-up phase, the LED ring lights up red. As soon as the heating-up phase is complete, the LED ring is lit up white. During preparation, use the temperature controller (2) to reduce the temperature if necessary.
Note: Only add the batter to the crepe plate (1) once it has heated up.
Note : When the crepe plate (1) is heating up, the LED ring is lit up red. As soon as the required tem-perature is reached, the LED ring is lit up white.
Non-stick coating
Always use the crepe spatula (3) and batter spreader (4) provided. Never touch
the scratch-sensitive coating with sharp or pointed objects. When using your
new appliance for the first time there may be a little smoke or odour. This is
for technical reasons and is perfectly normal.
Warning : You cannot switch the appliance off using the temperature controller (2)! Therefore pull out the mains plug after use.
Preparing crepes
Place the crepe plate (1) on the basic device (5). Heat the appliance up. Use a ladle to pour a little bat-ter onto the crepe plate (1) and use the batter spreader (4) to spread the batter, making even, circular movements. The overflow rim on the crepe plate (1) prevents the batter from flowing off the plate. Please note that batter can flow over the rim if you use too much. Turn the crepes using the crepe spatula (3). After preparing your crepe, transfer it to a plate and add your chosen toppings.
Basic recipe
Ingredients (approx. 10 servings) 250 g flour, 3 eggs, 500 ml milk, 1 pinch salt Mix all the ingredients in a bowl to make the batter. Allow the batter to rest for around 1 hour.
Note : The runnier the batter, the thinner the crepes will be.
Cleaning and care
- Pull out the mains plug and allow the appliance to cool down.
- Once the crepe plate (1) is warm to the touch, use a piece of kitchen towel to remove as much fat and other residue from it as possible.
- Clean the crepe plate (1) in lukewarm water using washing-up liquid and a washing-up brush. Note: Do not use abrasives, metal scourers or oven cleaner.
- The crepe spatula (3) and batter spreader (4) can be cleaned in the dishwasher.
- Never immerse the basic device (5) in water or use water to clean it. Simply put a little washing-up liquid on a damp cloth, wipe the appliance and then dry it.
For UK use only
This product is supplied with a 13 A plug conforming to BS 1363 fitted to the mains lead. If the plug is unsuitable for your socket outlets or needs to be replaced, please note the following. If the plug is a non-rewireable one, cut it from the mains lead and immediately dispose of it. Never insert it into a socket outlet as there is a very great risk of an electric shock. The replacement of the plug at the mains lead has to be done according to the following instruc-tions:
Warning – This appliance must be earthed
Important : The wires in this mains lead are coloured in accordance with the following code:
- green/yellow Earth
- blue Neutral
- brown Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
- the wire which is coloured green and yellow must be connected to the terminal which is marked with the letter E or by the earth symbol , or coloured green or green and yellow,
- the wire which is coloured blue must be connected to the terminal which is marked the letter N or coloured black,
- the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red
- If a 13 A (BS 1363) plug is used it must be fitted with a 13 A fuse conforming to BS 1362 and be ASTA approved. If any other type of plug is used, the appliance must be protected by a 10 A fuse either in the plug or adapter or at the distribution board. If in doubt – consult a qualified electrician.
- Never use the plug without closing the fuse cover.
The appliance complies with European directives 2014/35/EU, 2014/30/EU and 2009/125/EU. At the end of its life, this product may not be disposed of in normal household waste, but must instead be taken to a collection point for recycling electrical and electronic appliances. The materials are recyclable in accordance with their labelling. Reuse, recycling and other ways of reutilising old appliances make an important contribution to protecting our environment. Please ask your local authorities for information about the appropriate disposal point. End users are personally responsible for deleting any personal data that may be stored on appliances they are disposing of. Subject to change.
Consumer Service:
Tel.: +49 (0)7331 256 256
E-Mail : [email protected]
Hersteller : WMF GmbH WMF Platz 1 73312 Geislingen/ Steige Germany wmf.com