DJI-MINI3P Mini 3 Pro Drone User Guide

DJI-MINI3P Mini 3 Pro Drone

Safety at a Glance

By using this product, you signify that you have read, understand, and accept the terms and conditions here. EXCEPT AS EXPRESSLY PROVIDED IN AFTER-SALES SERVICE POLICIES AVAILABLE AT http://www.dji.com/service). THE product AND ALL MATERIALS AND CONTENT AVAILABLE THROUGH THE PRODUCTS ARE PROVIDED “AS IS” AND ON AN “AS AVAILABLE BASIS” WITHOUT WARRANTY OR CONDITION OF ANY KIND. This product is not intended for children.

Flight Environment

AWARNING

• DO NOT use the aircraft in severe weather conditions including heavy wind exceeding9 10.5 m/s, snow, rain, or fog. hail, or lightning
• Fly the aircraft below 4,.000 m (13,123 t) above sea level.
• DO NOT ty the aircraft in environments where the temperature is beiow -10″ C (14″ F) or above 40* C (104 F
• DO NOT take from moving objects such as cars, ships, and airplanes.
• DO NOT fy close to reflective surfaces such as water or snow. Otherwise, the vision system may be limited.
• When the GNSS signal is weak, fly the aircraft in environments with good lighting and visibility. Love ambient light may cause the vision system to work abnormally.
• DO NOT try the aircraft near areas with magnetic or radio interference, including Wi-FI hotspots, routers, Bluetooth devices, high-voltage lines, large scale power transmission stations, radar stations, mobile base stations, and broadcasting towers.

NOTICE

• Be careful when taking off in the desert or from a beach to avoid sand entering the aircraft
• Fly the aircraft in open areas. Buildings, mountains, and trees may block the GNSS signal and affect the onboard compass.

Flight Operation

WARNING

• Stay away from rotating propellers and motors
• Make sure the aircraft batteries, remote controller, and mobile device are fully charged.
• Be familiar with the selected fight mode and understand all safety functions and warnings

NOTICE

• Make sure DU Fy and aircraft firmware have been updated to the latest version.
• Land the aircraft in state action when there is a low battery or high wind warming.
• Use the remote controller to control the speed and altitude of the aircraft to avoid oolisions during Return-to-Heme.

Battery Safety Notice

WARNING

• DO NOT allow liquid to come into contact with the batteries. DO NOT leave batteries covered in moisture or out in the rain. Do NOT drop the batteries into the water. Otherwise, an explosion or fire may occur
• DO NOT use non-Dul batteries. It is recommended to use DJ chargers.
• DO NOT use swollen, leaking. or damaged batteries, In such situations, contact DJ or a DUI autnorizod dealer The batteries should be used at a temperature between -10″ to 40 C (14 to 104 F High temperatures can cause an explosion or fire. Low temperatures will reduce the performance of a battery.
• DO NOT disassemble or pierce the battery in any way
• The electrolytes in the battery are highly corrosive. If any electrolytes come into contact with your skin or eyes, immediately wash the affected area with water and seek medical support.
• Keep the batteries out of the roach children and animals.
• DO NOT use a battery if it s involved in a crash r heavy impact
• Extinguish a battery fire using water, sand, or a dry powder fire extinguisher
• DO NOT charge the battery immediately after the fight. The battery temperature may be too high and may cause serious damage to the battery. Allow the battery to cool down to close to room temperature before charging Charge the battery at a temperature range of 5 to 40′ C(41to 104″ F). The ideal charging temperature range is 22″ to 28 C (72″ to 82″ F Charging of the ideal temperature range can prolong battery life.
• DO NOT leave the batteries near heat sources such as a furnace or heater or inside a vehicle on a hot day
• DO NOT store the battery for an extended period after fully discharging Otherwise, the battery may over-discharge and cause irreparable damage to the battery cell
• If a battery with a low power level has been stored for an extended period, the battery wl enter deep hibernation mode. Recharge the battery to bring it out of hibernation.

Specifications

Compliance Information

FCC Compiance Notice

• Supplier’s Declaration of Conformity
• Product name: D ii 3 Pro
• Model Number: MT3M3D
• Responsible Party: DUI Technioiog, In
• Responsible Party Address: 201 S. Victory Blvd, Burbank, CA 9150e
• Website: www.di.com.

We, DUI Tochnology, Inc., being the responsible party, declare that the above- mentioned mode was tested to demonstrate complying with all applicable FOC rides and regulations, This device complies with Part 15 of the FOC Rules. Operation is subject to the following two conditions: (1| Tris device may not cause interference, and 12) This device must acceçt an interference received, acquiring interference That may cause undesired operation Ary changes or modifications not expressly approved by the party for compliance could sold the user’s authority to operate the airport.

This emergence has been tested and found to with the iris for a Cuss B digital deice Pursuant to part 15 of the FCC Rules. These are designed to provide reasonable protection against hamate interference in a residential installation. This equipment generates, uses, and can racket radio frequency energy and not installed and used n accordance with the instructions, may cause harmful interference to radio communicators However, there is no guarantee that interference will not occur in a particular installation. f this equipment does cause habit interference to racko cr television receptor, which can be determined by turning the equipment on and on, the user b encouraged to try to correct te by one or more of the following measures:

• Reoriert or rekcate the rooving arterra.
• Inonease the separation between the equipment and receiver,
• Correct the equipment into at out on a direct different rain that to which the receivers conecte.
• Cornsuit the dealer or an experienced radio tv technician for help.

RF Exposure Information

The aircraft companies vuln FCC radiation exposure limits set forth for an uncontrolled environment In order to avoid the possibility of exceeding the FOC radio frequency exposure limits, human progmity to the antenna shal not be less than 20om durng national operation. This transmitter must not be co- located or operating in conjunction with any other antenna or transmitter This remote controller complies with FOC addition exposure Imte set fort tor an uncortroled environment. End user must 1cliow the specific operating instructions for satisfying RF expoure compiance. This transmitter must rat be co-located or operating in conjunction with the antenna or transmitter.

The portable device is designed to meet the requirements for exposure to waves established by the Federal Communications Commission USA. These requirements s8t an 8AR Imil of 16 W kg averaged over one gram of tissue. The highest SAR value reported under this standard dung product ceriñication for ie when the property is worn on the body.

Datweein the radator andd your body. Ths trenamitter must not be co-ocated or operatng in comjunctian with any cther antenna ar transmittar. Cst écuipemant est conforme aux limiles dexpostion aux radations CNR-102 latlies pour un arvironnenant ron contrče, Cal équioemant dl åve instale el uliiae avec une dstancs minnde ce 20 nerkre le redaleur et votre corpa.

This equipment complies with ISED radiation exposure limits set forth for uncontrolled recurrent. Ext must flaw the specific operating instructions for dating RF eposure complianca Ths transmitter must not be co-located or operating in conjunction with any oter anlenina or Tre portable device is designed to meet the requirements for exposure to aco was established by The SED.

These requirements see a SAR  of 1.6 Wkg averaged one ane gram of tissue, The highest SAR value ground under this standard during product certification when property wrom the body
Cas epances in SAR Imite da 1,5 Wlg en moyenne pour un gmme de tissu La vakeur SAR Ia pis lavde agnslee en vertu de cette nome lbrs de la certilicatkon de proaut å stkser koracu’l ast cormectement porté sur le corp.

Compliance Statement

SZ DUI TECHNOLOGY CO. LTD. hereby declares that this device IDUI Mni 3 Pro) is in compliance with the essential and otter relevant provisions of Raxko Equprment Pegularions 2017 A copy of the G8 Declaration cr Contomty is available online at www.j.oom/euro-compliance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>