danfoss RAX-K Thermostatic sensor Instructions
- June 5, 2024
- Danfoss
Table of Contents
danfoss RAX-K Thermostatic sensor Instructions
Thermostatic sensor RAX-K
Sets for systems
Sets for systems with flow coming from the bottom, with an M30x1.5 built-in valve insert:
- thermostatic sensor RAX-K
- H-Piece, type RLV-KB
Danfoss Thermostatic Sensors RAX-K
- Remove the protective cap from the valve insert by turning it anticlockwise.
- Ensure that the setting mark on the sensor is positioned at the top before mounting the sensor.
- Mount the thermostatic sensor on the valve and tighten it with a 32 mm spanner (max torque 15 Nm).
H-piece valves, type RLV-KB
Two pipe system
Danfoss A/S
Climate Solutions
danfoss.com
+45 7488 2222
Any information, including, but not limited to information on selection of
product, its application or use, product design, weight, dimensions, capacity
or any other technical data in product manuals, catalogues descriptions,
advertisements, etc. and whether made available in writing, orally,
electronically, online or via download, shall be considered informative, and
is only binding if and to the extent, explicit reference is made in a
quotation or order confirmation. Danfoss cannot accept any responsibility for
possible errors in catalogues, brochures, videos and other material. Danfoss
reserves the right to alter its products without notice. This also applies to
products ordered but not delivered provided that such alterations can be made
without changes to form, fit or function of the product.
All trademarks in this material are property of Danfoss A/S or Danfoss group
companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All
rights reserved.
© Danfoss Climate Solutions I 03/2022 I AN408535149374en-000101
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>