CRUX CS-GM11B Wiring Interface Owner’s Manual

CRUX CS-GM11B Wiring Interface

PRODUCT FEATURES

• Retains factory features in select GM LAN 11 Bit vehicles while functioning with an aftermarket radio.
• Pre-programmed to retain factory Steering Wheel Controls.
• Supports Bose, non-Bose and Y-91 audio systems.
• Retains chime functions.
• Retains front and rear parking sensors.
• EIA color coded wiring for easy installation.

NOTE:
Does NOT retain OnStar.

PARTS INCLUDED

INSTALLATION DIAGRAM

DIP SWITCH SETTINGS

AFTERMARKET RADIO DIP SWITCH SETTINGS:

NOTE : For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most off-brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.

4-PIN SWC CABLE
Use the proper 3.5MM to 4-Pin SWC cable for the aftermarket radio you are using.

OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached) OPTION B is used for ATOTO, BLAUPUNKT, BOSS, DUAL, FARENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY, SOUNDSTREAM and Most Off-Brand Radios.

NOTE : Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.

For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable and connect the SWC wires as follows:

Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.

SELECTING THE AUDIO SYSTEM

If the vehicle is equipped with an amplified audio system, the SWRGM-51 has a built-in audio level adaptor that outputs the proper audio level from the aftermarket radio to the factory amplifier. To use this feature, plug in the male 8-pin connector on the SWRGM-51 harness to the GRAY female 8-pin connector on the SWRGM-51 module. The module is also labeled “Bose” and “Non Bose” to avoid confusion. (see picture below) If the vehicle is NOT equipped with a factory amplified system, plug in the male 8-pin connector to the BLACK female 8-pin on the SWRGM-51 module.

CHIME VOLUME ADJUSTMENT

The SWRGM-51 has a potentiometer to adjust the chime volume. It is set at half way by default. To adjust the volume, simply use a suitable screw driver and turn the potentiometer clockwise to increase the volume and counter-clockwise to decrease the volume.

VEHICLE APPLICATIONS

16 and 14 PIN CONNECTORS

• 2007-2010 Cobalt
• 2006-2011 HHR
• 2008-2012  Malibu

PONTIAC

• 2007-2010 G5
• 2006-2010 Solstice

SATURN

• 2007-2010 Aura
• 2007 Ion
• 2007-Sky

CHEVROLET

• 2005-2006 Cobalt
• 2004-2007 Malibu

References

• Telepathy - Powering Successful Brands

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>