EliteControl Infinity Motion IP54 Wireless Outdoor Dual Tech Optex Motion Sensor Instruction Manual

EliteControl Infinity Motion IP54 Wireless Outdoor Dual Tech Optex Motion

Sensor

Specifications

Detection Method: Passive Infrared & Microwave
Coverage: 12m x 12m @ 12 0°
Wireless Range: Up to 50 0m Line of Sight
Wireless Frequency: 915MHz
Microwave Frequency: 10.525GHz
Mounting Height: 2.2 to 2.7m (Multi-Level) OR 0.8 to 1.2m (Pet Alley)
Detection Zones: 18 Zones or 40 Zones
Sensitivity: 2.0° c @ 0.6m I sec
Detectable Speed: 0.3m – 2.0m I sec
LED Indicator: Warm-up, Alarm, Wall< Test
Tamper Switch: Wall & Front Cover
Battery Type: 1 x CR123A Lithium
Battery Life: Up to 3 Years
Operating Temperature: – 4o0 c to 45°c
Environment Humidity: 95% max
Pet Alley (optional): Removes lower area detection to avoid small animals.

Overview

Dipswitch Settings

Detection Area

Pet Alley Configuration

1. Loosen Axing screw
2. Slide the main unit down
3. Rise mirror up to the Axing position
4. Re-tighten Axing screw

Masking

Masking can be achieved using the adhesive strips provided as detailed below:

Installation Areas to Avoid

The nix sign indicates prohibition

Dimensions

Learning Procedure (make sure you are in installer programming before proceeding. Default POOOOOOE)

Enable Wireless Input (P122E)

Press PROG 122 ENTER then the input number you wish to maRe wireless, followed by entering. Next, maRe sure options 1 & 5 are on. This ma Res the input active & wireless, then press ENTER to save
Example:

Learn Device into an Input (P164E) (ensure battery is correctly installed in the device before proceeding)

• Press PROG 164 ENTER then the input number you wish to enroll the device into, followed by entering
• Press ENTER again to start the learn beeps, indicating that the system is waiting to learn a device
• Activate the device tamper switch to complete the learning process and the Reypad should stop beeping The Reypad will now display the input number you learned the device into. Repeat the steps above using another spare input to learn another device or exit programming to test.

Note: Dipswitch 5 should be ON for testing purposes. This means the sensor will only sleep for 5 seconds after sensing any movement & then can be triggered again. After testing, it is recommended to turn dipswitch 5 OFF to extend the life of the battery.

Battery Status Indication

With the battery inserted, press the gold button on the ‘black inAnity module’ for less than 1 second & the LED will indicate battery status.

• Green = Battery OK
• Red = Battery Low & replacement is advised
• Battery low will be indicated at 2.3V & under

Default Programming

If the ‘inAnity motion IP54’ has previously been learned into a system it may require defaulting. To do so, press and hold the gold button on the ‘black inAnity module’ while inserting the battery & continue to hold. The indicator LED will display solid red and turn green when the default is successful.
Note: If system defaults have changed you may need to reference the control panel manual for more information

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>