HOUSEGARD WA201S Water Leak Alarm User Manual
- September 21, 2024
- HOUSEGARD
Table of Contents
HOUSEGARD WA201S Water Leak Alarm
MODEL : WA201S
Thanks for choosing a water leak alarm from Housegard. Our products are developed to be user friendly and durable. This pack contains: 1 water leak alarm, 1 pcs 9 Volt battery and 1 user manual.
GENERAL
Housegard water alarm is an automatic water leak detector for household appliances. WA201S consists of a sensor, signal processing identification circuit and alarm circuit. It uses water’s conductivity as its alarm signal source. If the humidity reaches a certain value, the detected signal will be transmitted to the internal circuit by the three probes and the alarm will go off. Place WA201S directly on the floor where water leakage may occur, for example in the kitchen, laundry room or near sinks. WA201S can only detect water leaks that come in physical contact with the detector.
TECHNICAL SPECIFICATION
- Model: WA201S
- Areas of use: Private homes and weekenders.
- Power source: 1pcst 9V battery 6LR61/6LF22
- Temperature span: +1C to +60 c
- Power consumption:
- Normal mode 25-10 uA,
- Alarm mode: 220 uA
- Response time: 7 seconds
- Alarm signal: 85 dB / 3 m
- Size: 83 x 30 mm
OPERATION
- A. Unscrew the upper cover, remove the battery’s protective cover and insert the battery.
- B. Test the detector by letting the three metal probes of the water alarm come into contact with water during 4-7 seconds until the alarm goes off. The alarm turns off when the sensors are separated from the water.
- C. Place the detector on the desired surface.
ATTENTION
- The battery is not pre-installed. Remember to insert the battery before the alarms is taken into use.
- Do not attempt to repair the devise.
- Change battery regularly. The alarm emits a short signal when the battery life time is ending.
- Test the alarm on a regular basis according to procedure described in text above.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>