Delta Electronics Inc NWA1100 300Mbps Wireless Access Point Owner’s Manual
- September 6, 2024
- Delta Electronics Inc
Table of Contents
NWA1100 300Mbps Wireless Access Point
“`html
Product Specifications
-
Product Dimensions: 270mm x 270mm x 60.2mm (exclude universal
mounting kit) -
Product Weight: 1.75kg
-
Radio Frequency:
- 2.4GHz
- 5GHz
- 6GHz
- Bluetooth Low Energy (V4.1) – 2402 ~ 2480MHz
-
Networking Interface: One Wi-Fi 2.4GHz, One Wi-Fi 5GHz, One
Wi-Fi 6GHz, One Wi-Fi 2.4/5/6GHz (scanning), One Bluetooth
2.4GHz -
Antenna Peak Gain:
- Dual Band Wi-Fi(2.4GHz): 7.7dBi
- Dual Band Wi-Fi(5GHz): 7.6dBi
- Wi-Fi 6GHz Band: 7.5dBi
- BLE: 5.9dBi
-
Max Power Consumption: Please refer to manual for detailed
information -
Max Tx Power: Please refer to manual for detailed
information -
MTBF: Please refer to manual for detailed information
-
Power Source: Please refer to manual for detailed
information -
Mounting Mode: Please refer to manual for detailed
information -
Operation Temperature: Please refer to manual for detailed
information -
Operation Humidity: Please refer to manual for detailed
information -
Altitude: Please refer to manual for detailed information
Product Usage Instructions
Installation Guide
-
Installation of ceiling plate + AP on T-bar (9/16 & 15/16):
Please update accordingly as per the manual. -
Uninstallation of ceiling plate + AP from T-bar (9/16 &
15/16): Please update accordingly as per the manual. -
Installation of RJ45 cable on ceiling plate.
-
Installation of ceiling plate + AP on wall mount.
Regulatory Compliance Information:
Safety Notice:
-
Please use CSA/UL Certification Approval & LPS’s External
Power Adaptor. -
Please connect with CSA/UL Certification Approval & LPS’s
DC Source. -
NWA1100 is indoor use Wireless AP.
-
There is a risk of fire if the battery is replaced with an
incorrect type.
FCC Requirement for Operation in the United States of
America:
This device complies with Part 15 of the FCC Rules. Operation is
subject to specific conditions as mentioned in the manual.
Guideline for Human Exposure:
For mobile device usage (>20cm/low power), follow the
radiation exposure statement provided in the manual.
FCC Regulations:
-
The operation of this device is restricted to indoor use only
as per FCC regulations. -
The operation on oil platforms, cars, trains, boats, and
aircraft is prohibited except under specific conditions mentioned
in the manual.
FOR COUNTRY CODE SELECTION USAGE:
Note: The country code selection is for non-US model only and is
not available to all US models. Per FCC regulation, all WiFi
products marketed in the US must be fixed to US operation channels
only.
Frequently Asked Questions (FAQ)
Q: Can the NWA1100 be used outdoors?
A: No, the NWA1100 is designed for indoor use only as specified
in the regulatory compliance information.
Q: What is the maximum power consumption of the NWA1100?
A: Refer to the product manual for detailed information on the
maximum power consumption of the NWA1100.
Q: Is the NWA1100 compatible with all types of mounting
modes?
A: The NWA1100 can be mounted using specific installation
methods outlined in the manual. Please follow the installation
guide for proper mounting.
“`
Indoor Wireless AP
NWA1100
Product Specification Product dimensions
Product weights Radio frequency
Operation frequency 2.4GHz 5GHz 6G Bluetooth low energy(V4.1) Networking
interface Antenna peak Gain
Max power consumption Max Tx Power
MTBF Power source Mounting mode Operation temperature Operation humidity
Altitude
270mm x 270mm x 60.2mm (exclude universal mounting kit) 1.75kg One Wi-Fi
2.4GHz One Wi-Fi 5GHz One Wi-Fi 6GHz One Wi-Fi 2.4/5/6GHz(scanning) One
Bluetooth 2.4GHz
2412 ~ 2462MHz 5180 ~ 5850MHz 5925 ~ 7125MHz 2402 ~ 2480MHz 1x5G mGig Ethernet
port Wi-Fi 6GHz band: 7.5 dBi Dual band Wi-Fi(2.4GHz): 7.7dBi Dual band Wi-
Fi(5GHz): 7.6dBi BLE: 5.9dBi
45watts Wi-Fi 2.4GHz band: 21dBm(per chain) Wi-Fi 5GHz band: 19dBm(per chain)
Wi-Fi 6GHz band: 8dBm(per chain) BLE: 5dBm 356,126 hours Power over
Ethernet(PoE): 802.3bt Wall / Ceiling 0~+45C 5 90% Noncondensing 10,000ft
(3,048m)
Installation Guide Installation of ceiling plate + AP on T-bar (9/16″ & 15/16″) Please update accordingly
Uninstallation of ceiling plate + AP from T-bar (9/16″ & 15/16″) please update accordingly
Installation of RJ45 cable on ceiling plate
Installation of ceiling plate + AP on wall mount
Regulatory Compliance Information:
Safety Notice
. Please use CSA/UL Certification Approval & LPS’s External Power Adaptor. .
Please connect with CSA/UL Certification Approval & LPS’s DC Source. . NWA1100
is indoor use Wireless AP. . There is a risk of fire if the battery is
replaced with an incorrect type.
FCC Requirement for Operation in the United States of
America:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any
interference received, including interference that may cause undesired
operation.
Guideline for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body. This device complies
with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures: Reorient or relocate the
receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help. FCC Caution Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate this equipment. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter. For
operation within 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range, it is
restricted to indoor environment.
This device complies with ISED’s licence-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Le présent appareil
est conforme aux CNR d’ ISED applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le
dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce
dispositif doit accepter tout brouillage reçu, y compris un brouillage
susceptible de provoquer un fonctionnement indésirable. Caution : (i) the
device for operation in the band 5150-5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems; Avertissement: Le guide d’utilisation des dispositifs pour réseaux
locaux doit inclure des instructions précises sur les restrictions
susmentionnées, notamment : (i) les dispositifs fonctionnant dans la bande
5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin
de réduire les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux;
FOR MOBILE DEVICE USAGE (>20cm/low power) Radiation Exposure Statement: This
equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
greater than 20cm between the radiator & your body.
Déclaration d’exposition aux radiations: Cet équipement est conforme aux
limites d’exposition aux rayonnements ISED établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé à plus de 20 cm entre
le radiateur et votre corps.
FCC regulations restrict the operation of this device to indoor use only. a.
The operation of this device is prohibited on oil platforms, cars, trains,
boats, and aircraft, except that operation of this device is permitted in
large aircraft while flying above 10,000 feet in the 5.925-6.425 GHz band. b.
Operation of transmitters in the 5.925-7.125 GHz band is prohibited for
control of or communications with unmanned aircraft systems.
FOR COUNTRY CODE SELECTION USAGE Note: The country code selection is for non-
US model only and is not available to all US model. Per FCC regulation, all
WiFi product marketed in US must fixed to US operation channels only.
IC Devices shall not be used for control of or communications with unmanned
aircraft
systems. Operation shall be limited to indoor use only. Operation on oil
platforms, automobiles, trains, maritime vessels and aircraft shall be
prohibited except for on large aircraft flying above 3,048 m (10,000 ft).
Les dispositifs ne doivent pas être utilisés pour commander des systèmes
d’aéronef sans pilote ni pour communiquer avec de tels systèmes.
leur utilisation doit être limitée à l’intérieur seulement leur utilisation à
bord de plateformes de forage pétrolier, d’automobiles, de trains, de
navires maritimes et d’aéronefs doit être interdite, sauf à bord d’un gros
aéronef volant à plus de 3 048 m (10 000 pi) d’altitude.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>