HIKVISION DS-PDSMK-E-WB Wireless Smoke Detector User Manual
- June 5, 2024
- Hikvision
Table of Contents
HIKVISION DS-PDSMK-E-WB Wireless Smoke Detector User Manual
APPEARANCE
- Test/Silence Button
- Alarm/Test/Signal Indicator
- Tamper Switch
- Battery Holder
ENROLLMENT
INSTALLATION
- Check signal strength
- Install the detector.
TEST
User Manual
Scan the QR code for more information and operation help.
Specification
| Detection Method | Chamber with photoelectric sensor |
|---|---|
| Operation Mode | Independent & wireless reporting |
| Siren Volume | 85 dB @ 3 m |
| LED indicator | Blue (alarm) |
| Operating temperature | -10 °C to 55 °C (14 °F to 131°F) |
| Storage temperature | -20 °C to 60 °C (-4 °F to 140 °F) |
| Operating humidity | 10% to 90% |
| Dimension (D x D) | 11)102 x 48.4mm |
| Transmission frequency | 433 MHz |
| RF range | 800 m (free space) |
| Battery | Non Replaceable CR17450 x 1 for Main Sensor CR123A x 1 RF Module, 3V, |
10 Years Life Span
FCC Statements
Warning
This is a class A product. In a domestic environment this product may cause
radio inter-ference in which case the user may be required to take adequate
measures. FCC Information Please take attention that changes or modification
not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC compliance:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.
FCC Conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>