GOGEN CDM 388 USB MP3 CD Radio Portable Player Instruction Manual
- June 5, 2024
- Gogen
Table of Contents
MAXIRADIOP
USB/MP3/CD/RADIO PORTABLE PLAYER
USB/MP3
INSTRUCTION MANUAL WARNING
TO PREVENT FIRE OR SHOCK HAZARDS DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
LIGHTNING FLASH WITH ARROWHEAD
SYMBOL – within an equilateral triangle, is intended to alert the user to
the presence of uninsulated dangerous voltage within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of electric shock to
persons.
EXCLAMATION POINT – within an equilateral triangle, is used to indicate
that a specific component shall be replaced only by the component specified in
that documentation for safety reasons.
The following label has been affixed to the unit, listing the proper procedure
for working with the laser beam:
| CLASS 1 LASER PRODUCT LABEL This label is attached to the place as
illustrated to inform that the apparatus contains a laser component.
---|---
| WARNING LABEL INFORMING OF RADIATION This label is placed inside the unit.
As shown in the illustration. To warn against further measures on the unit.
The equipment contains a laser radiating laser rays according to the limit of
laser product of class 1.
SAFETY INSTRUCTIONS
-
READ INSTRUCTIONS – All the safety and operating instructions should be read before the appliance is operated.
-
RETAIN INSTRUCTIONS – The safety and operating instruction should be retained for future reference.
-
HEED WARNINGS – All warnings on the appliance and in the operating instructions should be adhered to.
-
FOLLOW INSTRUCTIONS – All operating instructions should be followed.
-
WATER AND MOISTURE – The appliance should not be used near water, for example, near a bathtub, washbowl, kitchen sink, laundrytub, swimming pool or in a wet basement.
-
VENTILATION – The appliance should be situated so that its location or position does not interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface that may block the ventilation openings, in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.
-
HEAT – The appliance should be situated away from heat sources such as radiators, stoves, or other appliances (including amplifiers) that produce heat.
-
POWER SOURCE – The appliance should be connected to power supply only of the type described in the operating instructions or as marked on the appliance.
-
POWER CORD PROTECTION – Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them.
-
POWER LINES – An outdoor antenna should be located away from power lines.
-
OBJECT and LIQUID ENTRY – Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.
-
ESD WARNING – The display does not function properly or no reaction to operation of any the control may due to the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds.
-
DAMAGE REQUIRING SERVICE – The appliance should be serviced by qualified service personnel when:
A. The power-supply cord or plug has been damaged.
B. Objects have fallen into, or liquid has been spilled into the appliance enclosure.
C. The appliance has been exposed to rain.
D. The appliance has been dropped, or the enclosure damaged.
E. The appliance does not appear to operate normally. -
SERVICING – The user should not attempt to service the appliance beyond that described in the user operating instructions. All other servicing should be referred to qualified service personnel.
Notes:
A. Dirty or scratched CD may cause a skipping problem. Clean or replace the CD.
B. If an error display or malfunction occurs, disconnect the AC cord and remove all the batteries. Then turn the power back on.
BEFORE OPERATION
Notes: CONCERNING COMPACT DISCS.
Since dirty, damaged or warped discs may damage the appliance, care should be
taken of the followings items:
A. Usable compact discs. Use only compact disc with the mark shown below.
B. CD compact disc only with digital audio signals.
POWER SOURCES
AC power
You can power your portable system by plugging the detachable AC power cord
into the AC inlet at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
Make sure that the AC power cord is fully inserted into the appliance.
Battery power
Insert 6 x “C” size batteries into the battery compartment. Be sure that the
batteries are inserted correctly to avoid damage to the appliance. Always
remove the batteries when appliance will not be used for a long period of
time, as this will cause leakage to the batteries and subsequently damage to
your set.
Notes:
– Use batteries of the same type. Never use different types of batteries
together.
– To use the appliance with batteries, disconnect the AC power cord from it.
LOCATION OF CONTROL
RADIO OPERATION
General operation
- Set the “FUNCTION” selector to “RADIO” mode.
- Select desired band by using the “BAND” selector.
- Adjust radio frequency to your desired station by using the “TUNING” control.
- Adjust the “VOLUME” control to the desired level.
Fm / fm-stereo reception
– Set the “BAND” selector to FM mode for MONO reception.
– Set the “BAND” selector to FM ST. mode for FM STEREO reception. The Stereo
indicator light up to show FM ST. mode.
For better reception
– Reorient the antenna for better reception.
– Reorient the appliance to get better AM reception.
CD / MP3 OPERATION
General operation
PLAY/PAUSE / USB| Press to start playing CD / MP3 disc.
Press again to stop playing CD / MP3 operation temporarily.
Press again to resume playback.
---|---
SKIP+ &| SKIP + & Press to go to the next track or back to the previous track.
SKIP- | SKIP – Press and hold while playing until you find the point of the
sound.
STOP| STOP Press to stop all CD / MP3 operation.
Playback
-
Set the “FUNCTION” selector to “CD / MP3” mode.
-
Open the CD door and place a CD / MP3 disc with the label up in the CD compartment.
-
Close the CD door.
-
Focus search is performed if disc is inside.
For CD disc – Total number of tracks is read and appears on the display.
For MP3 disc – “MP3” appears on the display. -
Press the “PLAY / PAUSE / USB” button to start playing CD / MP3 disc.
-
Adjust the “VOLUME” control to the desired level.
-
Press the “PLAY / PAUSE / USB” button again when you want to stop playback temporarily.
-
Press the “STOP” button when finished.
CD / MP3 OPERATION
Program
Up to 20 tracks can be programmed for disc play in any order.
Be sure to press the “STOP” button before use.
- Press the “PROGRAM” button, the display will show “P01” and flash.
- Select desired track by using the “SKIP +” or “SKIP -” button. (You may select a desired album by pressing the “ALBUM” button).
- Press the “PROGRAM” button again to confirm desired track into the program memory.
- Repeat step 2 and 3 to enter additional tracks into the program memory.
- When all the desired tracks have been programmed, press the “PLAY / PAUSE” button to play the disc in the order you have programmed.
- Press the “STOP” button twice to terminate programmed playback.
Mode
Press the “MODE” button before or during playing CD / MP3 disc, each press
switches the mode function as follows:
- REPEAT 1
- REPEAT ALBUM ( *MP3 ONLY )
- REPEAT ALL
- RANDOM
- NORMAL PLAYBACK
USB OPERATION
General operation
PLAY/PAUSE / USB| Press to start playing tracks from the USB .
Press again to stop playing USB operation temporarily.
Press again to resume playback.
---|---
SKIP+ &| SKIP + & Press to go to the next track or back to the previous track.
SKIP- | SKIP – Press and hold while playing until you find the point of the
sound.
STOP| STOP Press to stop all USB operations.
Playback
- Plug or slot in USB device to the port. (Make sure no disc on disc tray)
- Set the “FUNCTION” selector to “CD / MP3 / USB” mode.
- Press and hold the “PLAY / PAUSE / USB” button for a few seconds to entry USB mode.
- Playback will start automatically from the first track.
- Press the “STOP” button when finished.
- Press the “PLAY / PAUSE / USB” button again, playback will start from the first track.
Program, mode
The operation of PROGRAM, MODE are as the same as that of CD / MP3. Please
refer to CD / MP3 OPERATION.
AUTOMATIC STANDBY SWITCHING
To comply with the “ERP2 (Energy Related Products)” Ecodesign Directive (2009/125/EG), its ultimate aim is to reduce the energy consumption of energy- using products; the device automatically switches to standby after approx. 10 minutes without a signal. In order to use the device again, switch the device off and then on again.
SPECIFICATIONS
| Power requirement: | 230 V/50 Hz |
|---|---|
| Output power: | 2 × 1 W |
| Dimensions: | 235 × 232 × 124 mm |
| Weight (NET): | 1350g |
WE RESERVE THE RIGHT TO CHANGE TECHNICAL SPECIFICATIONS.
WARNING: Do not use this product near water, in wet areas to avoid fire
or injury of electric current. Always turn off the product when you don’t use
it or before a revision. There aren’t any parts in this appliance that are
reparable by consumers. Always appeal to a qualified authorized service. The
product is under a dangerous tension.
Old electrical appliances, used batteries and accumulators disposal
This symbol appears on the product, on the product accessories or on the
product packing means that the product must not be disposed of as household
waste. When the product/ battery durability is over, please, deliver the
product or battery (if it is enclosed) to the respective collection point,
where the electrical appliances or batteries will be recycled. The places,
where the used electrical appliances are collected, exist in the European
Union and in other European countries as well. By proper disposal of the
product, you can prevent possible negative impacts on the environment and
human health, which might otherwise occur as a consequence of improper
manipulation with the product or battery/ accumulator. Recycling of materials
contributes to the protection of natural resources. Therefore, please, do not
throw the old electrical appliances and batteries/ accumulators in the
household waste. Information, about where it is possible to leave the old
electrical appliances for free, is provided at your local authority, at the
store where you have bought the product. Information, where you can leave the
batteries and accumulators for free, is provided to you at the store, at your
local authority.
Notes
Documents / Resources
|
GOGEN CDM 388 USB MP3 CD Radio Portable
Player
[pdf] Instruction Manual
CDM 388, USB MP3 CD Radio Portable Player, CDM 388 USB MP3 CD Radio Portable
Player, MP3 CD Radio Portable Player, CD Radio Portable Player, Portable
Player, Player
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>