BODEGA CF8 12V Car Refrigerator User Manual

: June 5, 2024
: BODEGA

Table of Contents

BODEGA CF8 12V Car Refrigerator
SAFETY INSTRUCTIONS
Product Features
Product Structure
installation
Function and Operation
Cleaning and Storage
Smart Control- Fridge APP Instructions
Troubleshooting
Warranty and Maintenance
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BODEGA CF8 12V Car Refrigerator

SAFETY INSTRUCTIONS

WARNING!

Do not operate the appliance if it is visibly damaged.
Do not block the gaps of the fridge with things like pin, wire, etc.
Do not expose the appliance to rain or soak it in water.
Do not place the appliance near naked flames or other heat sources (heaters, direct sunlight, gas ovens etc.)
Do not store any explosive substances like spray cans with a flammable propellant.
Ensure the supply cord is dry and not trapped or damaged. Do not locate multiple portable socket outlets or portable power supplies at the rear of the appliance.
Check the voltage specification on the type plate corresponds to that of the energy supply. The appliance is only to be used with the power supply unit provided with the appliance.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
Once unpacked and before turning on, the appliance must be placed on a level surface for more than 6 hours.
Make sure that the appliance stays horizontally when it is running. The tilt angle must be less than 5° for long time running and be less than 45° for short time running.
Keep the ventilation openings in the unit casing or in the built-in structure free of obstacles.
Keep the appliance stable on the ground or in the car; Do not drain upside down.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
CAUTION!
Repairs may only be carried out by qualified personnel. Incorrect repair may cause danger. The lamp and supply cord must be replaced by the manufacturer or qualified persons.
The installation of DC power in the boat must be handled by qualified electricians.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
The appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they’ve been given supervision or instruction concerning use of the device in a safe way and understand the hazards.
NOTICE!
Disconnect the power supply before each cleaning and maintenance and after every use.
Do not use sharp tools to defrost; Do not damage the refrigerant circuit.
Risk of child entrapment. Before you throw away your old refrigerator or freezer: take off the doors: leave the shelves in place so that children may not easily climb inside.
Check if the cooling capacity of the appliance is suitable for storing food or medicine. Food may only be stored in its original packaging or in suitable containers.
If the appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould from developing within the appliance.
The appliance is intended to be used in household and similar applications such as:
Staff kitchen areas in shops, offices and other working environments;
- Camping, Farm houses and by clients in hotels, motels and other residential environments;
- Bed and breakfast type environments;
- Catering and similar non-retail applications.
  Please according to local regulations regarding disposal of the appliance for its flammable

Product Features

High-efficiency DC compressor and conversion module.
CFC-free and great heat insulation.
DC12/24V or AC 100~240V (using the adapter) power supply.
Fast cooling to -15°C/S°F(based on 25°C/77°F room temperature).
Intelligent battery protection system.
Digital display control panel for temperature setting.
Wireless charging, USB charging port.

Product Structure

installation

Remove the original car console.
install the included fridge base and tighten the screws.
install the console fridge on the car cigar lighter.
Connect the include
| ****

CUT OUT

| DC 12V| ****

CUTIN

| ****

CUT OUT

| DC 24V| ****

CUTIN

---|---|---|---|---|---|---
L| 8.SV| | 10.9V| 21.3V| | 22.7V
M| 10.lV| | 11.4V| 22.3V| | 23.7V
H| 11.lV| | 12.4V| 24.3V| | 25.7V

DC power cable with the car cigar lighter.

Function and Operation

Power Supply: connect to DC 12V/24V or AC 100~240V (using the adapter the adapter should be purchased separately) power supply.
Display Screen Initialization: the screen will be on for 2 seconds after connecting to the power supply.
Power On/Off: press to switch ON/OFF.
Temperature Setting: press+ or – for temperature setting, the setting will be saved automatically after stopping operating for 4 seconds(Note: the temperature displayed is the current temperature of the compartment, it’ II takes a while to reach the set temperature.) Temperature setting range: -20~ 20°c (-4~68°F)
Cooling Mode: under the running state, press to switch MAX(fast cooling) and ECO (Energy saving Mode).(*Factory setting is MAX.)
Temperature Unit Setting: switch off the fridge, long press for three seconds until El displays, keep pressing until ES displays. then press+ or- to select Celsius or Fahrenheit.(*Factory setting is °C.)
Battery Protection Mode: under the running state, long press for three seconds until the screen flashes, then press again to select protection mode H(High), M(Middle) and L(Low)(*Factory setting is H.)

Voltage Reference:

| ****

CUT OUT

| DC 12V| ****

CUTIN

| ****

CUT OUT

| DC 24V| ****

CUTIN

---|---|---|---|---|---|---
L| 8.SV| | 10.9V| 21.3V| | 22.7V
M| 10.lV| | 11.4V| 22.3V| | 23.7V
H| 11.lV| | 12.4V| 24.3V| | 25.7V

*the voltage is a theoretical value, there may be a deviation in different sceneries.
Due to the different output voltages between vehicles, H should be set when the product is connected to car power, and M or L should be set when it is connected to a portable battery or other back-up battery. The battery gear should be set from H to M or from M to L if there is a voltage protection code Fl shown on the panel. The battery gear should be set to H if the product keeps working after turning off the car engine, or the product may drain the battery.

Reset: switch off the fridge, long press O for three seconds until El displays, under El mode, long press +- at the same time until the screen displays “888”.
Wireless charging : put your mobile phone in the center of the wireless charge section and start charging.(Note:your mobile phone must have the function of wireless charging.)

The recommended temperature for common food:

Cleaning and Storage

Cleaning:
- Unplug the device first to avoid electric shock.
- Use wet cloth to clean the device and dry it.
- Do not soak the device in water and do not wash it directly.
- Do not use abrasive cleaning agents as these can damage the device.
Storage:
If the device will not be in use for a long time, please follow the steps:
- Turn off the power and remove the plug.
- Remove all the items stored in the device.
- Wipe off excess water from the fridge with a soft rag.
- Put the device in a cool and dry place.
- Leave the lid slightly open to prevent odors from forming.
Defrosting:
Humidity can form frost in the interior of the cooling device or on the evaporator. This reduces the cooling capacity. Defrost the device in good time to avoid this.
- Switch off the device.
- Take out the contents of the device.
- Keep the lid open.
- Wipe off the defrosted water.
  A Never use hard or sharp tools to remove ice or to loosen objects which have AA frozen in place.

Smart Control- Fridge APP Instructions

First Step: Turn on the Bluetooth on your smart device; start the APP and click “Search” to find nearby fridges.
Second Step: Click fridge icon for Bluetooth pairing (the APP will prompt you to pair the fridge by pressing the set button on the fridge’s control panel when connecting the fridge for the first time). After pairing, the APP will switch to the main interface allowing you to control the fridge.

MENU
Current temperature
Current-voltage
Target temperature
Switch Left/Right compartment
SET
(VON/OFF
Temperature control
Temperature control
ECO(Energy-saving) / MAX(Fast-cooling)
Lock / Unlock
Celsius / Fahrenheit
Unpairing the device and return to search
Battery protection mode: High/Medium/Low

Note :
*Click the lock icon on the APP to lock/unlock the control panel on the fridge, if locked, the fridge can only be controlled by the APP.
Downloading the “CAR FRIDGE FREEZER” Application

Scan the QR code on the left or search for the “CAR FRIDGE FREEZER” APP in the APP Store (for Apple devices) or Google Store (for Android devices).

Troubleshooting

Issues	Cause/Suggestions

Refrigerator does not work

| • Check if the switch is on.

• Check if the plug and socket are connected well.

• Check if the fuse has been burnt.

• Check if the power supply malfunctions.

• Switch on/off the fridge frequently may cause start delay of the compressor.

Refrigerator compartments are too warm| • The door is opened frequently.

• A large amount of warm or hot food was stored recently.

• The refrigerator has been disconnected for a long time.

Food is frozen| • The temperature was set too low.
There is “water flow”

noise from inside the refrigerator

|

• It’s a normal phenomenon, caused by the flow of refrigerant.

There are waterdrops around the refrigerator

casing or door gap

|

• It’s a normal phenomenon, the moisture will condense to water when it touches a cold surface of the refrigerator.

The compressor is slightly noisy when starting| • It’s a normal phenomenon, the noise will be reduced after the compressor works stably.

Code Fl displayed

| • Possible cause: low voltage to fridge.

Adjust the battery protection from High to Medium or from Medium to Low.

Code F2 displayed

| • Possible cause: condenser fan is overloaded. Disconnect power to fridge for 5 minutes & re-start.