BODEGA COOLER X30 Car Refrigerator User Manual

BODEGA COOLER X30 Car Refrigerator

SAFETY INSTRUCTIONS

ARNING!

• Do not operate the appliance if it is visibly damaged.
• Do not block the gaps of the fridge with things like pin, wire, etc.
• Do not expose the appliance to rain or soak it in water.
• Do not place the appliance near naked flames or other heat sources (heaters, direct sunlight, gas ovens etc.)
• Do not store any explosive substances like spray cans with a flammable propellant.
• Ensure the supply cord is dry and not trapped or damaged. Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
• Check the voltage specification on the type plate corresponds to that of the energy supply.
• The appliance is only to be used with the power supply unit provided with the appliance.
• Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
• Once unpacked and before turning on, the appliance must be placed on a level surface for more than 6 hours.
• Make sure that the appliance stays horizontal when it is running. The tilt angle must be less than 5° for long-time running and be less than 45° for short-time running.
• Keep the ventilation openings in the unit casing or in the built-in structure free of obstacles. (Around the compressor l00mm).
• Keep the appliance stable on the ground or in the car; Do not drain upside down.

CAUTION!

• Repairs may only be carried out by qualified personnel. Incorrect repair may cause danger.
• The lamp and supply cord must be replaced by the manufacturer or qualified persons.
• The installation of DC power in the boat must be handled by qualified electricians.
• Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• The appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they’ve been given supervision or instruction concerning use of the device in a safe way and understand the hazards.

NOTICE!

• Disconnect the power supply before each cleaning and maintenance and after every use.
• Do not use sharp tools to defrost; Do not damage the refrigerant circuit.
• Risk of child entrapment. Before you throw away your old refrigerator or freezer: take off the doors: leave the shelves in place so that children may not easily climb inside.
• Check if the cooling capacity of the appliance is suitable for storing the food or medicine.
• Food may only be stored in its original packaging or in suitable containers.
• If the appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance.
• The appliance is intended to be used in household and similar applications such as:
• Staff kitchen areas in shops, offices and other working environments;
• Camping, Farm houses and by clients in hotels, motels and other residential environments;
• Bed and breakfast type environments;
• Catering and similar non-retail applications. X Please according to local regulations regarding disposal of the appliance for its flammable refrigerant and blowing gas.

PRODUCT FEATURES

• High-efficiency DC compressor and conversion module.
• CFC free and great heat insulation.
• DC12/24V or AC 100~240V (using dedicated adapter) power supply.
• Fast cooling to -20°C/-4°F(based on 25°C/77°F room temperature).
• Intelligent battery protection system.
• LED display for temperature setting.
• Cup holder design and adjustable door opening direction.

PRODUCT STRUCTURE

REVERSE DOOR OPEN DIRECTION

• The door has two opening directions and can be taken off at an angle of 20°. When installing it back, align the door shaft with the compartment hole and then insert it.

APP Connection

WiFi MODEL

Scan the QR Code with your smartphone or search it in the APP Store or Google Play to download the “QZsmart” app.

PREPARATION BEFORE USE

1. Make sure your car fridge is on and ensure that your smartphone is connected to 2.4 GHz Wi-Fi network.
   NOTE: This device works only on 2.4 GHz Wi-Fi® network.

2. Ensure that the Bluetooth function of the mobile phone is enabled at the same time; otherwise, the device cannot be automatically searched.

3. Download the QZsmart app from the App Store or Google Play™.
   NOTE: Authorize the app to access network and location services.

4. If you are using the app for the first time, click the “Sign up” button and register. If you already have an account, click the “Log in” button.

5. For better WIFI connection, please reset the product WIFI before using it for the first time. You can disconnect the connection by turning off the switch of the refrigerator and simultaneously long pressing + and – on the control panel of the refrigerator for 3 seconds and hearing one beep.

Add Device

1. From the Home Page, press “Add Device” or press in the top right corner of the screen.
   (If you already have a device added to your account, the “Add Device” button will not appear).

2. Connecting

• Auto-connect: (Featured First)
• The app will automatically search when Wi-Fi and Bluetooth are switched on, so you can add the corresponding product directly from the automatic search.
• Step 1: Press “Add Device” or press “ “.
• Step 2: When the device is found, press Add. The Bluetooth function must be enabled during this process.
• Step 3: Select your Wi-Fi network. (Be sure to use a 2.4G network)
• Step 4: Enter your router password.
• Step 5: Wait for connection and click “NEXT”.
• Step 6: Once the device is added, you can use the menu to change the name and location of the device.
• Step 7: When you are finished, click “Done”.
• Manual connection: Select your model from the device menu.
• Step 1 : Press “Add Device” or press “ “.
• Step 2: Select the corresponding product type and click the product diagram of the corresponding model.
• Step 3: After the product is shut down, press ” Next “.
• Step 4: Long pressing ” + “and” – ” on the control panel of the refrigerator for 3 seconds and hearing one beep, Press “Next”.
• Step 5: Select your Wi-Fi network. (Be sure to use a 2.4G network)
• Step 6: Enter your router password.
• Step 7: Click “Confirm.” The next screen will say “Connect your mobile phone to the device’s hotspot.”
• Step 8: Click “Go to connect.” This will take you to your phone’s settings (or Wi-Fi list for Android).
• Step 9: Select “SmartLife-XXXX.”
• Step 10: Navigate back to the QZsmart App.
• Step 11: Click “Next.” Your smartphone will automatically connect.
• Step 12: Once the device is added, you can use the menu to change the name and location of the device.
• Step 13: When you are finished, click “Done.”
• Follow the APP interface, there are detailed operation reminders in the APP interface, you need to follow the steps one by one.
• NOTE: Connection may take up to 60 seconds.
• Once the device is added, you can use the menu of the app to change the name of the device.
• When you finished, press “Done”.
• NOTE: Your mobile device is connected to a 2.4GHz Wi-Fi network when pairing with the app.
• Please select the 2.4GHz network when selecting a Wi-Fi network on the app during setup.

BLUETOOTH MODE
Bluetooth function can be used in non-wifi environments.
PREPARATION BEFORE USE
Please be sure to connect to WIFI successfully for the first time. (Again, you must connect to WIFI first, otherwise, you will not be able to use Bluetooth in non-wifi environments.)
NOTE:
After the WiFi connection is disconnected, wait about 2-3 minutes before you can directly use the Bluetooth control.
Using the My App
The main interface can control the switch, set “temperature” and “lock”. Click on “more features” in the lower right corner to set the switch of temperature unit, cooling mode, battery protection mode.

How to unbind

A car refrigerator can only be connected to one mobile phone. First method: You can disconnect the connection by turning off the switch of the refrigerator and simultaneously long pressing + and – on the control panel of the refrigerator for 3 seconds and hearing one beep.
Second method: Removing connection with the app: Open the app and go to the device page. Click” ” in the upper right corner, and then click “Remove Device” at the bottom.

Cautions

• There will be a delay in operating the machine on the mobile phone, about 1-3 minutes, please be patient.
• The language of the APP automatically switches with the language of the mobile system.
• You can lock or unlock the control panel on the refrigerator by operating the APP lock icon.
• Please note that if you want to lock the refrigerator, please control it through the APP, the operation panel of the refrigerator does not have the function of locking and unlocking.

Function and Operation

• Power Supply: connect to DC 12V/24V or AC 100-240V power (using a dedicated adapter).
• Display Screen Initialization: connect to the power supply, the buzzer will make a long beep, and the display will be on for 2 seconds then enter the normal operating mode.
• Power On/Off: press to switch ON/OFF.
• Temperature Setting: press+ or – for temperature setting, the setting will be saved automatically after stopping operating for 3 seconds (Note: the temperature displayed is the current temperature of the compartment, it’ II take a while to reach the set temperature.) Temperature setting range: -20~20°C (-4~68°F)
• Cooling Mode: under the running state, press to switch MAX(fast cooling) and ECO (Energy saving Mode).(*Factory setting is MAX.)
• Battery Protection Mode: under the running state, long press for three seconds until screen flashes, then press again to select protection mode H(High), M(Medium) and L(Low) (*Factory setting is H).

Voltage Reference

• the voltage is a theoretical value, there may be a deviation in different sceneries.
• H should be set when the product is connected to car power, and M or L should be set when it is connected to a portable battery or other back-up battery.
• Temperature Unit Setting: switch off the fridge, long press for three seconds until El displays, then switch to ES by pressing again. Under ES mode, press+ or- to select Celsius or Fahrenheit.(*Factory setting is °C.)
• Reset: switch off the fridge, long press for three seconds until El displays, under El mode, long press at the same time for three seconds to reset it.

Recommended temperature for common food

CARE AND MAINTENANCE

Cleaning

• Switch off and unplug the device first to avoid electric shock.
• Use wet cloth to clean the device and dry it.
• Do not soak the fridge in water and do not wash it directly.
• Do not use abrasive cleaning agents during cleaning as these can damage the device.

Storage

• If the device will not be in use for a long time, please follow the instruction:
• Switch off and unplug the device.
• Take out all the items stored in the device.
• Wipe off excess water with a soft rag.
• Put the fridge in a cool and dry place.
• Leave the lid slightly open to prevent odors from forming.
• Recommended storage environment: ambient temperature: 25°C, ambient humidity: 75%.

Defrosting

• Humidity can form frost in the interior of the cooling device or on the evaporator.
• This reduces the cooling capacity. Defrost the device in good time to avoid this.
• Switch off and unplug the device first to avoid electric shock.
• Take out all the items stored in the device.
• Keep the lid open.
• Wipe off the defrosted water.
• Never use hard or pointed tools to remove ice or to loosen objects which have frozen in place.

TROUBLESHOOTING

TECHNICAL INFORMATION

*Due to product improvement, the technical information might be different from actual information, please refer to the rating label on the product. Manufacturer: Foshan Alpicool Electric Appliance Co., LTD. Address:13A Xinlong Road Shiongliyue Industrial Zone, Xintang Village, Lunjiao Town, Shunde District, Foshan City, Guangdong, China Contact: Mickey Tel: + 1(313) 913-7585 E-Mail: info@bodegacooler.com.

warranty

Thank you for purchasing the BODEGA COOLER product. We sincerely hope that you are satisfied with the product. We’d like to offer you a 12-month warranty for free. Once activated the warranty, you will be ensured that if anything goes wrong with your product. Replacement units/parts will be warranted during the warranty period.

What you need to do

• Any help or questions during use, please contact us via website
• www.bodegacooler.com, or send an email to info@bodegacooler.com,
• we will service you within 24 hours. When contacting us, we suggest sending Order ID, the problem and a photo or a video for helping us clearer about the problem and offer you the best solution.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>