ECOR PRO DH1100 Dehumidifier Instruction Manual

June 5, 2024
ECOR PRO

ECOR PRO DH1100 Dehumidifier Instruction Manual

THANK YOU

Thank you for choosing this innovative Ecor-Pro dehumidifier.

This instruction manual describes the many benefits and advanced features that this unique product has to offer.

The Ecor-Pro dehumidifier is a large capacity unit designed to run highly efficiently in places such as: restaurants, bars, printing presses, indoor swimming pools, jacuzzis, garages, animal enclosures, cellars, stores, boat sheds, weekend cottages, archives, etc.

Ecor-Pro specialises in complete indoor humidity control.
Our world class products incorporate the latest technological developments and are designed to create a quality environment.

It is important that you read these instructions carefully before installing and using your new dehumidifier.
Please keep them in a safe place for future reference.
Before using your dehumidifier for the first time, please ensure that it has been standing for 2 hours in it’s upright position before it is switched on.

SAFETY

For safety reasons, read this information carefully before operating. Persons who are not familiar with this type of product must not use it.

This appliance must be earthed and should only be connected to an  earthed 220 – 240 V / 50 Hz mains supply. The installation must be in accordance with the regulations of the country where the unit is used.

The unit is designated for indoor operation.

  • The dehumidifier is safe, however, as with other electrical appliance, use it with care.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.
  • Do not clean the dehumidifier by spraying it or immersing it in water.
  • Do not insert any object into the opening of the dehumidifier.
  • Disconnect from the mains before cleaning the unit or any of its components.
  • Never connect to an electrical outlet using an extension cord. If an outlet is not available, one should be installed by a licensed electrician.
  • Any service other than regular cleaning or filter replacement should be performed by an authorized service representative. Failure to do so could result in a loss of warranty. Your Ecor-Pro dehumidifier is supplied with an electrical cable and an earthed plug. Should it be necessary to replace this plug at any time, you must use an earthed electrical plug.

Warning! Never operate this appliance if it has a damaged cord or plug. If the supply cord is damaged, it must be replaced by an approved service representative or a similar qualified person in order to avoid any hazards.

There should be direct access to the electrical plug after connecting the power!

Do not use your dehumidifier under the following conditions:

  • If the power cable wires are frayed or cut.

  • When small children may be left unattended.

  • Where the power cable may be damaged.

  • If there is a risk of liquid falling on the unit

  • If an extension cord is needed to reach an outlet

  • Where it may be damaged by chemicals

  • Close to a heat source

  • Where there is a risk of interference by foreign objects

  • This product is not made for DIy repair

HOW IT WORKS

Your Ecor-Pro dehumidifier controls the Relative Humidity by passing the air through the unit forcing the excess moisture to condensate over a cooled heat exchanger. This condensate water then flows safely into a fixed drain. The dried air then passes through a final heat exchanger where it is warmed before it re-enters the room area at a slightly elevated temperature. The level of dehumidifying is set with the digital humidistat control.

POSITIONING

There must be free space of at least 30 cm between any other object and the front and the top of the unit.
Your Ecor-Pro dehumidifier can be installed in any area with a too high relative humidity, such as cellar, playing area, shed, archive or swimming pool.
The dehumidifier will begin to protect from the harmful effects of excess moisture as soon as it is plugged in and switched on.
When positioning your Ecor-Pro dehumidifier, ensure that it is placed on a level surface.
Best results are obtained when windows and doors are closed, thus preventing the possible influx of more humid, air.
When the unit is placed in a (swimming) pool area, connect to the mains via a transformer or a breaking switch, conform the local regulations regarding electrical installations.
When the dehumidifier is in operation, open outside doors and windows only when necessary.

WALL MOUNTING

The unit can stand on the floor or hang on a wall.
Wall-mounting brackets are provided with your Ecor-Pro dehumidifier.

Fix the support brackets with at least 6 screws to the wall, use the appropriate fixings for the weight of the unit and the type of wall, ensure the screw heads protrude by no more than 3.5mm as this will interfere with the back of the unit – counter-sunk type screws may be preferrable.
NOTE: the unit is heavy approximately 50kg.
Wall fixing dimensions are shown in the diagram below.
NOTE: H = Hight from floor level to base of unit.

When the support brackets are firmly fixed to the wall, remove the  lower unit fixing screws (B) and partially unscrew the upper fixing screws (A). Place the unit onto the support brackets as shown in the diagram below making sure the upper unit fixings (A) fit into the upper support bracket slots. Re-insert the lower fixings (B) through the lower support bracket holes. Secure all 4 fixings.

CLEANING

Disconnect from the mains before cleaning the unit or any of its components. Cleaning the air filter
Air circulation is impeded and the efficiency of the dehumidifying  and air purifying functions decreases when the filter is dirty. It is therefore good practice to clean the filter at regular intervals. The precise intervals depend on the room in which the appliance operates and on how frequently it is used.

  • Open the filter door ‘1’ pulling by it gently forward at the top edge
  • Remove the filters ‘2’ by sliding upwards.
  • Clean the filters or wash in tap water.
  • Dry the filters before inserting them back and closing the grille.

Housing
Wipe regularly clean with a moist cloth and mild household detergent.

Servicing
Have your dehumidifier once a year serviced by a qualified engineer.

Caution
This unit should not be operated without the air filter fitted. Operation without the air filter may damage the heat exchanger.

DRAINAGE

Connecting the permanent outlet
The condensate drain is by default positioned at the right hand side however, it can be repositioned to the left hand side if required. To do this, the back panel must be removed and the tube position re-routed (this must be done by qualified personell only)

  • Connect the pipe to an outlet tube with the correct diameter.
  • Push the other end of the tube into a drain, making sure that the tubing cannot be twisted or folded.
  • The entire length of the tube must have a steady fall.
  • Ensure that the outlet of the drainage pipe is not under the water level in the drain.

NOTE: In very cold weather conditions precautions should be taken to prevent the drainage pipe from freezing.

CONTROLS

Your Ecor-Pro dehumidifier features a microprocessor based digital control system for optimal performance control.
All functions are accessible via the membrane keypad shown below:

Functions:

ON/OFF
The unit is switched on and off by pressing the ‘ON/OFF’ button. When the unit is on, the fan runs in the set speed.
Humidity
Press the ‘HUMIDITY ADJUST’ button repeatedly to choose the desired level of relative humidity in the area. The corresponding control lights will indicate the selected percentage. The ‘Continuous Run’ control light indicates that the unit is running continuously, disregarding the relative humidity level in the area.
Fan speed
Press the ‘FAN SPEED SELECT’ button to select low or high speed. The corresponding control light will indicate this.
Humidity display
The digital display will normally show the measured relative humidity in the area.
Compressor Operating
The ‘Compressor Operating’ display illuminates when the compressor is running.

IMPORTANT:
This dehumidifier should not be used in temperatures below 7°C or above 35°C.
Defrost Control
The dehumidifier is equipped with an automatic deicing mode to defrost the refrigeration coil during low temperature operation. The compressor is switched off whilst the fan continues to run.

TROUBLE SHOOTING

If the dehumidifier does not operate:

  • Make sure the unit is plugged in.
  • Ensure the humidistate control is turned on.

If the unit is noisy:

  • Make sure the dehumidifier is standing solidly and level.

If the unit is leaking:

  • Check the drainage tube for correct fitting.
  • Check for twists and bends in the drainage tube.
  • Check the drainage tube for a suffcient and continuous downward slope.
  • Check and make sure that the outlet of the drainage pipe is not under the water level in the drain.

TECHNICAL DATA

Specifications DH 1100
Typical Extraction @ 32 °C 90%rh 81 I /day
Typical Extraction @ 30 °C 80%rh 76 I /day
Typical Extraction @ 30 °C 70%rh 61 I /day
Air Flow (High Speed) 850 m 3/hr
Voltage 230 V
Current @ 27 °C/60%rh 6.5 A
Frequency 50 Hz
Power @ 27 °C/60%rh 1.65kW
Phase 1ph
Dimensions (mm) 820 x 710 x 360
Weight (NET) 51kg
Weight (GROSS) 53kg
Operating Temperature 7°C / 35 °C
Refrigerant R410A Hermetically sealed 700g
  • (EC) No 842/2006: R410A is a preparation of fluoridated greenhouse gases covered by the Kyoto Protocol. Its global warming potential (GWP) is 1725.

Disposal

This marking indicates that this product should not be disposed with other house – hold wastes throughout the EU.To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Support

Get In Touch

Call: 0845 6880112
Email: info@adremit.co.uk

Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard,
Settle, North Yorkshire, BD24 9RH

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals