FSP MPF0000500GP Environmental Monitoring Device User Guide
- June 5, 2024
- FSP
Table of Contents
FSP MPF0000500GP Environmental Monitoring Device
Environmental Monitoring Device Quick Guide
Product Outlook
- Communication port
- input dry contact terminal
- Device status indicator
- DC input connector
Product Introduction
This environmental monitoring device (EMD) is a connectivity device to remote monitor temperature and humidity via SNMP manager. It also provides two dry contacts to receive signals from up to 2 compatible devices such as security system and alarm system.
- Plug & use for simple installation with SNMP manager
- Monitor temperature and humidity to protect your precious equipment
- Allow two contact closure signals for user-defined usage
- Management software to remote monitor temperature and humidity status via web browser
- Measure temperatures between Oto lOO’C with an accuracy of ±!SC
- Measure relative humidity between 10 to 90% RH with an accuracy of ±3%
Function Diagram
Installation Inspection
Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. You will find the following items inside of package
-
Pre-installation
Before making a connection to the environmental monitor device, make sure the UPS is already installed with the SNMP manager. Please check the SNMP manager for SNMP card installation. -
Wall-mounting
There is a mounting hole on the back of the unit. Simply mount the unit by positioning the key-hole slot over the mounting screw. (See chart 1) -
Connect to power
Please follow Chart 2 to connect an external 12VDC power source. If connecting to the SNMP card, there is power from SiMP L&d. 1L·s no need to wear an external power source. -
NOTE : To guarantee safe operation, please use the appropriate DC wire with UL2468 #24AWG spec.
-
SNMP Connection
Connect the supplied cable from the communication port of the environmental monitor device to the RS-232 port of the SNMP manager. Use another network cable to connect from RJ45 port of SNMP manager to LAN (Refer to chart 3) -
NOTE: If the supplied cable is not long enough for your application, you may substitute another longer cable (not exceed 15m)
-
Operation
After making the connection, the status LED will light up and the unit starts to operate.
Monitoring Software Operation
Software Installation
After unit is connected well, please follow below steps to install monitoring
software from the internet.
- Go to the website http://www.power-software-download.com
- Click ViewPower Pro software icon and then choose your required OS to download the software.
- Follow the on-screen instructions to install the software.
- When your computer restarts, the monitoring software will appear as an orange plug icon located in the system tray, near the clock.
Operation
- Step: Double click the “ViewPower Pro” icon to Step 2: SNMP manager will be automatically launch the software.
- Step Select “SNMP manager” by clickina rights Hutton of the mause
- Step: Enter the specific IP address to search all SNMP devices In LAN. The SNMP manager will automatically collect the IP address from sever by default via a DHCP server.
- Step: After SNMP manager is successfully detected by SNMP manager, select •open Monitor• by clicking right button of the mouse.
- Step: When launching VlewPower Pro software, dick the “Environmental information” icon to view the status.
TroubleShooting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>