VENTURE LIGHTING BF0011 LED Strip Fixture User Manual
- June 5, 2024
- VENTURE LIGHTING
Table of Contents
VENTURE LIGHTING BF0011 LED Strip Fixture User Manual
Before You Begin
Read These Instructions Completely and Carefully
Upgrade Instructions
STEP 1 : Disconnect power from the existing luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
STEP 2 : Remove the existing luminaire. Dispose of the lamp(s) and ballast(s) per local requirements.
STEP 3 : Remove lens and wire way cover. (A)
STEP 4 : Select installation point and locate studs. For rear access points, feed wires through hole. (B)
STEP 5 : Select wiring access point and remove appropriate knockout.
STEP 6 : Make the necessary wiring connections as shown in the wiring
diagram. (C)
WARNING
Risk of fire and electric shock
- Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
- Venture Lighting’s LED Strip Fixture installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- The product should be installed and operated by a qualified electrician or technician in accordance with relevant local codes.
- Check to make sure that all fixture connections have been properly made and the fixture is grounded to avoid potential electrical shocks.
- Suitable for use in damp and dry locations.
- The installer must determine that the supply voltage meets the fixture requirement.
- Minimum 90°C supply conductors
Customer Service
800-451-2606
7905 Cochran Rd., Suite 300
Glenwillow, OH 44139 USA
E-mail:
[email protected]
VentureLighting.com