hama 00200012 Universal USB-C Power Pack Instruction Manual

: June 5, 2024
: Hama

Table of Contents

hama 00200012 Universal USB-C Power Pack
Operating instruction
Explanation of Warning Symbols and Notes
Package Contents
Safety Notes
Operation
Care and Maintenance
Warranty Disclaimer
Technical Data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hama 00200012 Universal USB-C Power Pack

hama-00200012-Universal-USB-C-Power-Pack-PRODUCT

Operating instruction

Controls and Displays

On/Off button
USB port
USB port
USB-C port IN/OUT (Power Delivery)
LED capacity indicator
USB-C cable

Thank you for choosing a Hama product. Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of Warning Symbols and Notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.

Package Contents

Power Pack 26800 mAh*, with Power Delivery
USB-C to USB-C charging cable
These operating instructions

Safety Notes

Use the product only for the intended purpose.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
Ensure there is sufficient scope for heat dissipation and ventilation.
Only use the article under moderate climatic conditions.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not short-circuit the battery of the opened terminal device. There is a risk of explosion.
Protect the product from dirt, moisture and overheating and use it in dry environments only.
Do not drop the product and do not expose it to any major shocks.
Do not operate the product outside the power limits specified in the technical data.
Always pull directly on the plug when disconnecting the cable, never on the cable itself.
Make sure that cables do not pose a tripping hazard or block emergency exits.
Do not bend or crush the cable.
As with all electrical products, this device should be kept out of the reach of children.
Do not modify the device in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Do not open the device or continue to operate it if it becomes damaged.
Do not throw the battery or the product into fire.
Do not tamper with or damage/heat/disassemble the batteries/rechargeable batteries.

Operation

Charging the Power Pack

Begin charging the power pack by connecting the included USB-C charging cable to the power pack’sUSB-C input (IN 5V/3A; 9V/3A; 12V/2.5A; 15V/2A; 20V/1.5A) and to a suitable PD charger. Alternatively, you can charge the power pack using a USB-A to USB-C charging cable and a suitable USB charger. Please refer to the operating instructions for the USB charger used.
Charging begins and ends automatically.
Charge the Power Pack fully before using it for the first time.
Since the battery is integrated and cannot be removed, you will need to dispose of the product as a whole. Do this in compliance with the legal requirements.

Note – Capacity

The capacity is always shown when the Power Pack is charging.
Each status LED corresponds to 25% of the capacity. When an LED is permanently illuminated, this indicates that this capacity level has already been reached. The Power Pack is charged to at least 75% if three LEDs are illuminated, and the fourth is flashing.
If all four status LEDs light up, the full capacity is available.
Press the button of the Power Pack to switch it on and to check its current capacity.
The power pack switches off automatically after about 10 seconds.

Warning – Battery

Only use suitable charging devices or USB connections for charging.
As a rule, do not charge devices or USB connections that are defective and do not try to repair them yourself.
Do not overcharge the product or allow the battery to completely discharge.
Avoid storing, charging or using the device in extreme temperatures and extremely low atmospheric pressure (for example, at high altitudes).
When stored over a long period of time, batteries should be charged regularly (at least every three months).

Charging terminal devices

Connect the included USB-C charging cable to the power pack’s USB-C connection (see 8. Technical Data) and to the USB-C connection of your terminal device (smartphone, tablet, notebook, etc.) to charge your terminal device with Power Delivery. Alternatively, connect a suitable charging cable for your terminal device to one of the two USB outputs to charge your terminal device.
Charging begins automatically. The status LEDs show the remaining capacity when the Power Pack is charging.
The current battery status of your terminal device will appear on this device.
Charging ends automatically. Then disconnect the power pack from your terminal device.
The Power Pack will automatically switch off if it is not connected to a terminal device.

Warning – Connecting terminal devices

Before connecting a terminal device, check whether the power output of the charger can supply sufficient power for the device.
Ensure that the total power consumption of the connected terminal device does not exceed the limit value (see point 8 Technical Data).
Please refer to the instructions in the operating manual of your terminal device.
It is essential that you observe these specifications and the safety instructions regarding the power supply of your devices.
The power pack must not be charged and discharged at the same time!

Note – Optimised charging

Optimized charging means that the Power Pack recognises the connected terminal device and supplies it with the optimal current to minimise charging time.

Warning

Never connect the charging cable of the Power Pack to both the input and the output of the Power Pack at the same time. This could damage the battery.
Do not connect any terminal devices while the Power Pack is charging. This could damage the Power Pack and the connected device.

Care and Maintenance

Note
Disconnect the product from the mains before cleaning.

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
Ensure that no water is able to enter the product.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.