MENSA HEATING Vireoo Outdoor Heater User Guide

MENSA HEATING Vireoo Outdoor Heater

Product specifications

Cafe table with infrared heat. (For outdoor use).

1. On/Off switch
2. Heat protective grid
3. Adjustable feet
4. Ventilation holes
5. Series connection circuits*
   

Heating mode

Vireoo is designed to heat two people sitting on each side of the table. It will take about 1 minute from the time you switch on the table until you feel the heat. In order to get the most out of your Vireoo table, you should place a leg on each side of the table leg. By placing your legs this way, you will get heat on the inside of both of your legs and your body can utilise the heat optimally. Press the On/Off switch (1) to turn off the product if you do not require further heat.

• Vireoo Professional is equipped with sensors which make the product turn off and on automatically (provided that the product is turned on). The sensors are timed to three minutes. This means that if no movement is sensed within three minutes, the table turns off automatically. Vireoo Professional is also equipped with series connection circuits making it possible to connect up to 5 tables to the same power outlet. The series connection circuits are located on the bottom of the table and can be attached and removed.

Power plugs and series connectors should be installed as shown.

Warning

– Do not cover the heater’s grid. (2)
– Do not place bags or other objects in such a way that they block the grid. (2)
– Do not insert foreign objects into the heat source behind the grid. (2),(4)
– Connect the product only to outlets with earth.
– This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacity – unless they are supervised and instructed by a person who is responsible for their safety.
– This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capa-
ble of leaving the room on their own, unless constant supervision is provided.
– Do not place the heater directly below a power outlet
– Do not place the heater near swimming pools, bath tubs or shower rooms
– If the supply cord is damaged, it must be replaced by the manufacture, its service agents or similarly qualified persons in order to avoid a hazard.
– *Never connect more than five tables in a series

Installation instructions

Remove the table leg from the box and place it as shown in the picture.
Remove the transport protection by loosening the two screws. Then remove the top brackets and install it with two screws and washers

Place the table leg standing on the top bracket, so that the top bracket is facing the ground/ floor. Remove the transport protection by loosening the the two screws. Route the cord through the leg and pull it up so that it fits the table leg. Make sure the cord is positioned correctly, so that it is located directly next to the hole in the foot. Fasten the foot with the two

• Attach also the 4 screws in the serial connectors
  

Install the tabletop with four screws. Turn then Vireoo-table correctly and reconnect power.
You are now ready to enjoy your new Mensa Heating product.

Maintenance and cleaning

Disconnect the plug from the socket before cleaning or when not in use for prolonged periods.

• When cleaning, do not spray cleaners or water directly into the table.
• Apply the cleaner on a rag and wipe the product.
• Regular maintenance of the product is recommended as this will prolong the table’s service life and appearance.
• Check that the cord is not damaged and that the plugs are clean.

Troubleshooting

Follow the troubleshooting steps listed below:

• Make sure the power cord is connected correctly.
• Check the cable for any ruptures.
• Make sure the On / Off switch has been pressed.
• Check whether the bulb is blown.

Please contact the place of purchase if this did not solve your problem .

Disposal

The product should not be disposed of along with household waste. Instead, the product must be disposed of along electronic waste by dropping it off at collection points for recycling of electronic waste. To learn more about where
you can drop off your electronic waste for recycling, contact your local authority or your local waste management authority.

Scan this QR code to download your digital manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>