MOKI PRO 9328854012293 TWS Street Party Wireless Speakers User Guide

MOKI PRO 9328854012293 TWS Street Party Wireless Speakers

CONTROL PANEL

LED INDICATOR

BACK OF SPEAKER OVERVIEW

CHARGING

• Use the included MicroUSB to the USB charging cable and plug the MicroUSB end into the DC 5V port located on the back of the unit.
• The battery is fully charged in 6.5 hours. Charge time will be longer if the speaker is being used during charging.
• The red LED light indicates that the unit is charging.
• The red LED will turn off when the battery is fully charged. The charge cable can then be disconnected.

PLAY MODE

Auxillary Play Mode

1. Hold the Power button to turn on the speaker.
2. Connect one end of the audio cable (not supplied) to the 3.5mm audio port at the back of the speaker (see Back of Speaker Overview)
3. Connect the other end of the audio cable to the audio source.
4. Speaker will go to auxiliary mode automatically (LED will glow solid white)

Bluetooth Play Mode

1. When using a Bluetooth-enabled audio device, make sure the distance to the speaker is within 10m. Certain environments may affect the working distance.
2. Hold the power ON/OFF button to turn on the speaker. The unit will give a beeping sound to indicate it is in Bluetooth mode. The LED will rapidly flash white.
3. Enable Bluetooth on your audio device. Search for the new device “Moki Block Party”.
4. No password will be required. If your device requires a password, use “0000”.
5. Adjust the volume on your audio device to the desired level.

Note:
The speaker will automatically power off after 30 mins if not in use or music is not being played.

USB Play Mode

1. Hold the power ON/OFF button to turn on the speaker.
2. Plug your USB/flash drive into the USB-A port on the speaker.
3. The unit will enter USB play mode automatically.

LED MODE SELECTION OVERVIEW

• Press LED Mode button to cycle through different LED modes.
• Hold LED Mode button to turn off the top and bottom lights.
• Hold LED Mode button to turn off the center light.
• Double press LED Mode button to turn on/off side flashing lights.

TWS CONNECTION

Two speakers can be synced and connected via TWS (True Wireless Stereo) Technology.

1. Hold the power ON/OFF button on each speaker to turn both speakers on.
2. Press and hold the TWS pair ON/OFF button on both speakers to enter TWS mode.
3. You will hear a beep when the two speakers are paired (10 sec)
4. The LED on the master speaker will be solid white, while the LED on the second speaker will flash white.
5. On your audio device, turn Bluetooth on and follow normal Bluetooth pairing instructions.

Note:
Once speakers have been paired via TWS, they will pair again each time they are turned on. If you want to unpair them, press the TWS pair ON/OFF button to disconnect.
The speaker will beep and both LEDs will flash indicating the speakers are no longer paired.

TROUBLESHOOTING

BATTERY HEALTH

To prevent the possibility of the battery from leaking, heating or catching fire, please follow these precautions:

Warnings

• Please use supplied USB charging cable to charge the speaker.
• Please disconnect the charging cable after speaker is fully charged.
• Do not continue to charge the speaker after it is fully charged.
• Do not use or leave the speaker near a heat source such as a fire or a heater.
• Do not place the speaker in any liquid, fire, or heater.
• Do not hit or throw the speaker.

Cautions

• Do not use or leave the speaker in very high temperatures (ie. in direct sunlight or in a vehicle in extremely hot conditions)
• Do not use a speaker where there is a lot of static electricity, otherwise, the safety devices within the speaker can be damaged.
• The speaker should be stored at room temperature.
• The speaker battery should be charged and discharged every so often in order to activate and restore the battery’s energy.
• Please follow battery waste recycling guidelines when disposing of the speaker.

E-WASTE

This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled according to the European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities. Should you need to dispose of this product, please note that electrical products should not be disposed of with household waste. Please dispose of the speaker thoughtfully.

References

• Buy Moki Headphones & Kids Headphones | MOKI

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>