CALIBER LT7XB Balanced Line Driver Instruction Manual
- June 5, 2024
- CALIBER
Table of Contents
CALIBER LT7XB Balanced Line Driver
Connection diagram
- RCA stereo signal cable (left and right channel) to the amplifier
- Audio input connection. Possible in 2 options;
- by RCA input (low input). Use a stereo audio signal cable between the LT 7XB and you head unit.
- by speaker input (high input). Use 2 speaker outputs (R-, R+, L-, L+) Of your head unit to connect to the LT TXB (connector included). Only use one of these two options to connect!
- The remote signal output of the head unit (not necessary when using high-level input)
- Loop through of the remote signal, to the amplifier
- To ground
- To +12V (note: adding a fuse is recommended)
- Gain control, output level control
- Balanced (8V output) and unbalanced (4V output) mode switch.
Note: Place the LT 7XB as close to the head unit as possible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>