XFANIC XF-A3001A 2.4G Wireless Lavalier Microphone User Manual

XFANIC XF-A3001A 2.4G Wireless Lavalier Microphone

Content of packaging

• Charge Case x1
• Microphone Transmitter x1
• Receiver x1
• Wind Muff x1
• User Manual x1

Product Parameters

Charging Case

• Input Voltage: DC4.8 5.4V
• Battery Capacity: 500mAh
• Charging Time: about 90min
• Changing Times: 5 time

Microphone

• Frequency:2.4GHz
• Latency:25ms
• Frequency Response range:20~20kHz
• Battery:.70mAh
• Working time:6.5H
• Charging time: about 80min

Receiver

• Frequency:2.4GHz
• Latency:25ms
• Frequency Response range:20-20kHz
• Connector: Lightning

Product Diagram

1. Charging box USB-C interface
2. Charging box indicator
3. Microphone clip
4. Microphone indicator
5. Lightning connector
6. Microphone reset button
7. Microphone charging contacts
8. Receiver indicator
9. Receiver reset key

How does it work

1. Open the charging box, then take out the device the microphone will be turned on automatically and the green light flashes slowly, the lightning receiver indicator light is off.
2. Plug the lightning receiver into the device, if both the green lights of the receiver and the microphone are steady on, which means the pairing of the device isM successful, and the recording tool can opened to start voice recording.

Note: Can only listen to video or recording effect after the receiver is pulled out of the device

Transmitter Function Description

Receiver Function Description

Charging Case Function Description

Warranty Information

Please fill in relevant information to ensure your legal rights

Our hardware product enjoys the corresponding warranty service from the date of purchase. The Warranty is limited to the product host and the accessories are not covered by the warranty.

FCC STATEMENT

Any changes or modifications not expressly approved by the party responsible for compliancecouldvoid the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:

1. this device may not cause harmful interference.
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.
• Consult the dealer or an experienced radio/TV technician for help

Information to user

The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. In cases where the manual is provided only in a form other than paper, such as on a computer disk or over the internet, the information required by this section may be included in the manual in that alternative form, provided the user can reasonably be expected to have the capability to access information in that form.

[54 FR 17714,Apr.25,1989,as amended at 68 FR 68545,Dec.9,2003]

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>