PAC-audio LPA-E4 Active Line Output Converter Installation Guide
- June 5, 2024
- Pac-Audio
Table of Contents
PAC-audio LPA-E4 Active Line Output Converter
Wiring Connection Chart (All Models)
MODELS:
- LPA-E4
- LPA2.4 / LPA2.2
- LPA1.4 / LPA1.2
important
- Important Note: This harness is provided with a inline fuse installed. Please remove prior to install and reinsert once finished.
- If your vehicle does not provide ACC source your harness will not have a “RED” wire to connect.
- It will use DC Offset to turn on as well as trigger the “REM OUT” on the LPA. On LPA-E4 there will be a jumper that you can move based on your application.
- This harness is designed to work on OEM NON-AMPLIFIED systems.
- Connect the RED BUTT Connector to the aftermarket system turn on for your amplifiers.
LPH Harness Instruction Guide
Example Installation – 4-Channel Amplifier – (HARNESS CUT REQUIRED)
- Cut the harness close as possible to the “CUT HERE AND INSULATE” label. You must insulate wires to prevent damage to OEM radio.
- The cut speaker wires will need to be connected to your aftermarket amplifier.(REFER TO LABEL ON HARNESS)
- Please refer to the chart on the first page for wiring your loose wires to your LPA.
- This harness is designed to work on OEMNON-AMPLIFIED systems.
Example Installation – Mono Amplifier – (HARNESS CUT NOT REQUIRED)
- If using a 2-Channel input LPA use the front speaker wires and insulate the remaining rear speaker wires.
- DO NOT CUT the speaker wires inbetween the “CUT HERE” Lables in order to keep the factory speakers functional.
- This harness is designed to work on OEM NON-AMPLIFIED systems.
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>